FW 5549 - Chopper AEG - Free user manual and instructions

Brand	AEG
Model	FW 5549
Product type	Electric Food Chopper
Dimensions (L x W x H)	15 x 15 x 20 cm
Weight	1.2 kg
Power supply	230 V, 50 Hz
Power	500 W
Bowl capacity	1 liter
Blade material	Stainless steel
Bowl material	BPA-free plastic
Main functions	Chopping, mixing, emulsifying, grinding
Speeds	2 speeds + pulse
Safety	Safety lock if the bowl is not properly locked
Care and cleaning	Bowl and lid dishwasher safe, blades hand washable
Non-slip feet	Yes
Spare parts	Replacement blades available, extra bowl optional
Repairability	Repairability index not specified, but parts available
Warranty	2 years

Frequently Asked Questions - FW 5549 AEG

How to clean the blades of the AEG FW 5549 chopper?

The blades are very sharp. To clean them, use a soft brush under running water or put them in the dishwasher (top rack). Dry them immediately to prevent rust.

Can I chop bones with this model?

No, the FW 5549 is designed for soft to medium-hard foods like vegetables, fruits, nuts, and boneless meat. Hard bones may damage the blades.

What is the maximum capacity of the bowl?

The bowl has a capacity of 1 liter. Do not fill beyond the max mark to avoid overflow and ensure even chopping.

Are the bowl and lid dishwasher safe?

Yes, the bowl and lid are dishwasher safe. Place them in the top rack. The blades should be hand washed or placed in the lower rack.

What to do if the chopper does not work?

Check that the bowl is properly locked (audible click). Make sure the plug is connected and the switch is in the desired position. If the problem persists, contact customer service.

Can I mix liquids with this chopper?

This model is primarily a chopper. For liquids, use pulse mode with short presses. Do not run continuously with liquids to avoid leaks.

Is there a warranty on the AEG FW 5549?

Yes, the legal warranty is 2 years. Keep your receipt. For manufacturing defects, contact your dealer or AEG service.

What are the important safety precautions?

Never put fingers in the bowl when the appliance is plugged in. Use the provided pusher. Always unplug before cleaning or changing blades.

Can I chop walnuts and hazelnuts?

Yes, you can chop walnuts, almonds, and hazelnuts. Use pulse mode to control fineness. Avoid running too long to prevent overheating the blades.

How to change the blades?

Unplug the appliance. Turn the bowl to unlock it. Remove the blade shaft by pulling gently. Insert new blades aligning the tabs. Screw the bowl back on.

USER MANUAL FW 5549 AEG

AEG feedstock machine with stainless steel handle and control panel (no visible text or symbols on the device itself)

PERFECT IN FORM AND FUNCTION

AEG

Deutsch

Inhalt

Overview of the Components ......Page 3

Instruction Manual......Page 29

Technical Data......Page 31

Illustrations......Page 46

Język polski

Spis tres'ci

D-47906 Kempen/Germany

General Safety Instructions

Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors. Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull the plug itself, not the lead) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you leave the room you should always turn the device off. Remove the plug from the socket.
• The device and the mains lead have to be checked regularly for signs of damage. If damage is found the device must not be used.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Children and Frail Individuals

- In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

WARNING!

Caution! Do not allow small children to play with the foil as there is a danger of suffocation!

• This device is not intended to be used by individuals (including children) who have restricted physical, sensory or mental abilities and/or insufficient knowledge and/or experience, unless they are supervised by an individual who is responsible for their safety or have received instructions on how to use the device.
• Children should be supervised at all times in order to ensure that they do not play with the device.

Symbols in these Instructions for Use

Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine:

WARNING:

This warns you of dangers to your health and indicates possible injury risks.

CAUTION:

This refers to possible hazards to the machine or other objects.

NOTE: This highlights tips and information.

Special safety instructions for this unit

WARNING!

• Switch off the appliance and pull the power supply plug out before you exchange accessories.
• Before changing accessories, wait until the knife has come to standstill.
• Danger of injury! Handle the knife with the necessary care when taking out and cleaning it!
• Do not break up hard items such as bones or shells.
• Do not manipulate safety switches.
• Do not touch moving parts.
• Only use the pusher for stuffing.

ATTENTION!

Do not use the appliance for longer than 10 continuous minutes.

Arrangement of control elements

1 Filling tray
2 Motor
3 Switch /○/R (On/Off/reverses)
4 Screw
5 scroll housing
6 Pusher
7 scroll
8 Knife
9 Sieve
10 Plug
11 Sausage attachment
12 2-part "Kebbe" attachment
13 2-part cookie attachment
14 Rail for biscuits

Intended use

This appliance serves

• Cut up foodstuff
• You can shape noodles or dough with different attachments.

It is exclusively intended for this purpose and may be only used appropriately.

30 English

It may only be used in the manner described in these operating instructions.

You may not use the appliance for commercial purposes.

Use for any other purpose is considered improper and not for the intended purpose and can result in damage to property and personal injury.

Elektro-technische Vertriebsgesellschaft is not liable for damages caused by non-intended use.

Preparation

Please see the overviews on pages 3 and 46.

1. Open the fixture for the spiral housing with the screw (4) on the device.
2. Place the spiral housing (5) with the filler neck facing upwards into the spiral drive and turn the screw clockwise until it is closed.
3. Place the filling tray on to the filler neck in such a way that the fixture for the tray is above the motor block.
4. Push the spiral (7) into the horizontal section of the spiral housing until the axle locks in place.

See also the sections on assembling the meat grinder, the "Kebbe" attachment, the sausage attachment or the biscuit attachment.

Assembly of the meat grinder

• Please also observe our illustrations under "A" (Page 46).
• Please follow points 1 to 4 as described under "Preparation".
• Insert the knife with the sharpened edge outwards onto the shaft of the scroll.
• Select a sieve (9).

i NOTE:

• Cut the meat into pieces of about 2.5 cm. Please take care that the meat does not contain any bones or sinews.
• In order to cut up the meat coarsely, use the sieve with the slits.
• In a second step, select the sieve with the finer or coarser holes, depending on how finely you want to grind the food.
• Coat the sieves beforehand lightly with vegetable oil.

• The guide mechanisms on the sieve fit into the recesses of the spiral housing.

• Rotate the catch clockwise.

• Put the pieces of meat on to the filling tray (1) and into the filler neck.

See below "Electrical connection".

Assembly of the sausage attachment

• Please also observe our illustrations under "B" (Page 46).

• First proceed as described under "Preparation" and "Assembly of the Meat Grinder", points 1 to 6.

• Position the sausage attachment on the scroll housing.

• Rotate the catch clockwise.

• Fill the sausage paste on to the filling tray and into the filler neck.

See below "Electrical connection/Application instructions".

Mounting of the "Kebbe" attachment

i NOTE:

Tubes of meat or dough paste can be made with the "Kebbe" attachment.

• Please also observe our illustrations under "C" (Page 46).
• Please follow points 1 to 4 as described under "Preparation".
• Position the 2-piece Kebbe attachment on the shaft of the scroll.

i NOTE:

The guides on attachment are located in the recesses on the scroll housing.

1. Rotate the catch clockwise.
2. Place your meat or dough paste on the filling tray and into the filler neck.

See below "Electrical connection".

Assembly of the cookie attachment

i NOTE:

You can shape different forms with this attachment after preparing a cookie dough. This is particularly suitable for so-called "Spritzgebäck" (cookies).

• Please also observe our illustrations under "D" (Page 46).
• Please follow points 1 to 4 as described under "Preparation".
• First, insert the disc onto the extension of the scroll shaft.

i NOTE:

The guides are located in the recesses on the scroll housing.

1. Then mount the shaping disc.
2. Rotate the catch clockwise.
3. Push the rail (14) through the slits of the shaping disc.

See below "Electrical connection/Application instructions".

Electrical connection

• Ensure that the function switch is set to "O" (Off).
• Connect the appliance to a correctly installed and earthed socket 230 V, 50 Hz.

Switch Functions Forward/Return

The appliance is equipped with a forward and return function. If the scroll should block, you can use the return function, in order to release it.

Forward:

- Turn the switch (3) to "①". The appliance is in the "Forward" mode.

Return:

• Turn the switch (3) to "O" and wait until the motor stops..
• Turn the switch (3) to "R". The appliance is in the "Return" mode.

Switching off

Move the safety switch (3) to "O" and pull the power plug.

Application instructions

Making sausages

• You can use either natural or artificial intestines.
• If you have decided for natural intestines, soak them beforehand for some time in water.
  • Make a knot at the end of the intestine.
• Push the intestine over the sausage attachment.
• The sausage mass is pressed through the sausage attachment and the sausage intestine is filled.
• Make sure that the sausage intestine is filled "loosely", since otherwise the intestine could burst because the sausage expands when cooking and/or frying.
• After the first sausage has achieved the require length, press the sausage together at the end of the sausage attachment with your fingers.
• Until you have acquired routine, you can switch the appliance off after each sausage section.
• Twist the sausage once or twice around its own axis.

Cookie attachment

• Screw the cookie attachment on and adjust the required cookie shape.
• Put the dough on the filling tray and filler.
• Hold the dough strands at the outlet with your hand and cut off the required length.

Cleaning and maintenance

• Always pull the power supply plug before cleaning and wait until the appliance has cooled down.
• Do not use a wire brush or other abrasive items.
• Never use sharp or scouring cleaning materials.

WARNING!

Never immerse the motor assembly in water for cleaning. It could result in an electric shock or fire.

Motor assembly

- Only wipe the motor assembly with a damp cloth and dry with a dry cloth after.

Filling tray, scroll, scroll housing and all accessories

ATTENTION!

• Do not clean these parts in the dishwasher.
  • The surfaces could become lacklustre.

• These parts can be cleaned by hand in the wash basin.

• Rinse with clear water and dry the parts.

Noise development

The sound pressure level in the ear of an operator (LpA) was measured according to DIN EN ISO 3744.

Sound pressure level detected: 85 dB(A) (no limit)

Specifications

Model: FW 5549
Power supply: 220-240V, 50Hz
Power consumption: 400W nom.
Block power:: 1000W max.
Protection class:....II
Net weight: 3,95 kg

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment in the domestic waste.

Please return any electrical equipment that you will no longer use to the collection points provided for their disposal.

This helps avoid the potential effects of incorrect disposal on the environment and human health.

This will contribute to the recycling and other forms of reutilisation of electrical and electronic equipment.

Information concerning where the equipment can be disposed of can be obtained from your local authority.