How to connect speakers to a NAD C320 integrated amplifier?

Question

Accepted Answer

To connect speakers to your NAD C320 integrated amplifier, follow these simple and safe steps:

Steps to connect your speakers:

Prepare the speaker cables: Use cables suitable for the power of your amplifier and in good condition. Each cable should have two distinct wires, usually identified by color (red for positive, black for negative).
Turn off the amplifier: Before any handling, ensure that the amplifier is turned off and unplugged to avoid any electrical risk.
Locate the speaker terminals: At the back of the NAD C320, you will find the terminals for speakers, often marked "Speaker A" and "Speaker B", with polarity indications (+ red and - black).
Connect the cables to the amplifier terminals:
- Insert the red wire (positive) into the red terminal (+).
- Insert the black wire (negative) into the black terminal (-).
Repeat this operation for each speaker.
Connect the other end of the cables to the speakers: Also respect the polarity on the speakers, connecting the red wire to the positive terminal and the black wire to the negative terminal.
Check the connections: Ensure that the wires are properly inserted and that the connections are secure without risk of short circuit.
Turn the amplifier back on: Once the speakers are correctly connected, turn on your NAD C320.
Test the audio output: Play an audio source to check that the sound is coming out correctly and without distortion.

Ensure that the impedance of the speakers is compatible with that recommended for the NAD C320 (generally 8 ohms, but check the specifications).
Avoid crossing the positive and negative wires to prevent damage to the amplifier or speakers.
If you are using the "Speaker A" and "Speaker B" outputs simultaneously, check that your amplifier supports this configuration.

By following these steps, you will be able to fully enjoy your audio system with a secure and effective connection.