BONI MZ200 - Uncategorized Eldom - Free user manual and instructions

Product Type	Pet Grooming Set
Brand	Eldom
Model	BONI MZ200
Power	12 W
Power Supply	230 V ~ 50 Hz
Cutting Length Settings	3 mm, 6 mm, 10 mm, 13 mm comb attachments
Included Accessories	Hair clipper, comb, brush, fine brush, scissors, file, blade cover, oil, 4 comb attachments, suitcase
Operation	Corded (mains powered)
Intended Use	Trimming dry coat of pets only
Safety Features	Automatic shutdown not mentioned; caution against water use
Blade Type	Replaceable cutter (utility tool)
Noise Level	Not specified; adjustment possible with regulator (D)
Weight	Approx. 0.5 kg (estimated)
Dimensions (HxWxD)	Approx. 20 x 5 x 5 cm (estimated for clipper)
Cleaning	Wipe enclosure with damp cloth; wash attachments in warm water; do not immerse clipper
Maintenance	Oil blades regularly with supplied oil; replace cutter as needed
Warranty	Household use only; warranty void if misused or for professional use
Environmental	Do not dispose with household waste; recycle at appropriate facility

Frequently Asked Questions - BONI MZ200 Eldom

Can I use the BONI MZ200 on wet hair?

No, the clipper is designed for dry coat only. Using it on wet hair can damage the device and pose a safety risk.

How do I change the comb attachment?

Ensure the device is switched off and unplugged. Attach the desired comb (3, 6, 10, or 13 mm) until it locks into place. Never change combs while the appliance is running.

The clipper gets hot during use. Is this normal?

Yes, the cutting head may become warm. Periodically switch off the device and check the temperature. If too hot, allow it to cool down before continuing.

How do I clean the clipper?

After use, unplug the device and remove the comb attachment. Clean the head with the included brush. Wipe the housing with a damp cloth. Attachments can be washed in warm water with mild detergent. Do not immerse the clipper or cord in water.

How often should I oil the blades?

Regular maintenance is required. Apply 1-2 drops of the provided oil between the blades and run the device for a few seconds. Do not use hair oils or solvents.

Can I use this clipper on humans?

No, the BONI MZ200 is intended only for pet grooming. Using it on human hair can cause injury.

What should I do if the device is not cutting properly?

First, check if the blades are clean and oiled. If the problem persists, the cutter may need replacement. The cutter is a consumable part and not covered by warranty.

Is the clipper safe to use around water?

No, do not use the clipper near bathtubs, showers, swimming pools, or other water sources. Always disconnect after use in a bathroom.

What accessories are included in the set?

The set includes: clipper, cord, comb, cutter, fine brush, brush, oil, blade cover, 4 comb attachments (3, 6, 10, 13 mm), scissors, file, and a suitcase.

Can I wash the comb attachments?

Yes, the attachments can be washed in warm water with dishwashing liquid. Ensure they are fully dry before reattaching. The clipper itself must not be immersed.

USER MANUAL BONI MZ200 Eldom

The disposal of used electrical and electronic equipment (applies to European Union countries and other European countries with separate waste-collection systems).

This symbol on the product or its packaging indicates that it should not be classified as household waste. It should be handed over to an appropriate company dealing with the collection and recycling of electrical and electronic equipment. The correct disposal of the product will prevent potential negative consequences for the environment and human health resulting from hazardous substances present in the product. Electrical devices must be handed over to restrict their re-use and further treatment. If the device contains batteries, remove them, and hand them over to a storage point separately. DO NOT THROW EQUIPMENT INTO THE MUNICIPAL WASTE BIN. Material recycling helps to preserve natural resources. For detailed information on how to recycle this product, please contact your local authority, the recycling company, or the shop where you bought it.

/CZ/

Black plastic object with a handle and circular indentation, labeled '15' in the corner (no other text or symbols)

1. Read thoroughly this manual before the first use of the device.
2. The pet hair clipper is intended only for grooming pets. The set is intended only for grooming pets. The set must not be used to groom human hair due to injury risk.
3. Do not use the clipper while bathing your pet or for trimming wet hair (coat). The appliance is intended solely for trimming dry hair.
4. The appliance should be connected to the mains compatible with current parameters stated on the enclosure.
5. The cord may not be run through sharp edges and close to hot surfaces and objects, because the insulation may be damaged. Electrocution hazard.
6. Do not place any objects on the cord, furniture, etc. and make sure that the cord is not bent.
7. Always disconnect the appliance from the mains pulling the plug, and not the power supply cord.
8. This appliance may be used by children of at least 8 years old and by persons with reduced physical and mental capacity and persons with no experience and knowledge of the equipment if the supervision or instruction is provided for use of the equipment in a safe way, so that the related hazards are understandable. Children should not play with the appliance. Children without supervision should not clean and maintain the appliance. Children below 8 years of age should be kept away from the appliance.
9. Do not put the appliance close to sources of heat.
10. The hair clipper must not be immersed in water or sprinkled,

11. Do not ever use the hair clipper when wet, with wet hands or close to showers, water in the tub, washbasin or other containers. When the device is used in the bathroom, disconnect it after use, as closeness of water is hazardous even when the device is switched off,

12. The device is intended only for household use.

13. Do not use in open air.

14. Clean the device after each use.

15. Always disconnect the device from the mains before cleaning and maintenance, in case of abnormal operation and after its use.

16. Do not use with a broken or otherwise damaged comb, due to risk of injury.

17. Do not remove combs when the appliance is being operated. To replace the comb, switch off the device and disconnect the cord from the mains.

18. Do no use when unusual symptoms occur while operating the device: smoke, strange odour or unusual sounds. The device should be checked by a specialist.

19. Use the unit only with the original accessories that are provided with it.

20. Check regularly whether the power supply cord and the whole device are not damaged. The device must not be switched on if any damages are found. If the power cord is damaged, it must be replaced by the Service of the Manufacturer to prevent hazardous situations. The list of service facilities is enclosed and is published in www.eldom.eu

21. only authorised service centres may repair the device. Any modernisation of the appliance or using non-original spare parts or elements of the device is forbidden and threatens safety of its use.

22. Eldom Sp. z o.o. shall not be responsible for any damages resulting from improper use of the appliance.

CAUTION: Do not use the appliance near bathtubs, showers, swimming pools and similar water reservoirs.

EN

INSTRUCTION MANUAL

PET GROOMING SET MZ200

DESCRIPTION

1. Hair clipper
2. Cord
3. Comb
4. Cutter
5. Fine brush
6. Brush
7. Oil
8. Blade cover
9. Comb attachment 13 mm
10. Comb attachment 10 mm
11. Comb attachment 6 mm
12. Comb attachment 3 mm
13. Scissors
14. File
15. Suitcase

A. Cutting head
B. Adjustment of trimming length
C. Switch
D. Head adjustment

TECHNICAL DATA

Black plastic tray with a handle and label '15' (no other text or symbols)

• power: 12 W
• supply voltage: 230V \~ 50Hz

OPERATION

Trimming

• Before trimming, make sure that the coat is dry and clean, and then thoroughly comb out to have natural flow of hair.
• remove the cover (8) from the appliance (1). Make sure that the appliance (1) is clean and oiled (MAINTENANCE).
• Set the switch (C) in the "0" position,
• Attach the required comb (9, 10, 11, 12) and make sure that it is locked in position. Trimming is best started with the 13mm attachment (9), with other being used only if needed.
• Connect the cord (2) to the mains compliant with the information on the appliance.
  • To start the appliance, place the switch (C) in the "I" position.
  • The appliance must be running when it is put in contact with the coat.
• Trimming is best started from the neck, progressing towards the tail.

CAUTION

Be cautious when trimming hair in sensitive spots, such as face, stomach, etc.

- Trim small areas, slowly passing the appliance along the natural direction of the coat.

CAUTION

Do no use the hair clipper for wet hair.

The head (A) becomes hot when in operation, which is natural. Switch off the appliance (1) from time to time, using the switch (C), and check whether the head (A) is not too hot. If this is the case, stop trimming and wait for the head (A) to cool down.

• With loud operation of the appliance, adjust the head with the regulator (D).
• After the work, switch off the device with the button (C) pushed downwards and disconnect the power cord from the mains.

Comb

The comb (3) is intended for both preliminary combing out of the coat (with the wide-spaced teeth) and more precise styling (the other side).

Brush

The brush (6) is used to tidy the coat, remove dead hair and excess underfur. Regular brushing prevents felting. Tangled coat should be first combed out with the comb (3).

Scissors

Use the scissors (13) to trim coat, especially in the places that are hard to reach for the appliance.

Cutter

The cutter (4) is used to trim claws that cannot be word down naturally. Make sure not to trim the claws too short.

File

Use the file (14) to smoothen the claws after trimming, so that they are not prone to catching and chipping.

CLEANING

Cleaning the head (A) of the appliance and all accessories after each use is recommended.

• Do no immerse the appliance (1) or the cord in water or in other liquids.
• Before cleaning the appliance (1), set the switch (C) in the position "0" and disconnect from the mains, and then remove the attachment (9, 10, 11, 12)
  • Clean the head (A) with the brush (5).
• Do not use cleaning agents that are strong or destructive to the surface.
• Wipe the enclosure of the appliance (1) with a damp or dry cloth.
  • The attachments (9, 10, 11, 12) may be washed in warm water with washdish.

MAINTENANCE

Regular maintenance of cutting blades is necessary. Put one or two drops of oil (7) between the blades and run the device for several seconds.

CAUTION

Do not use hair oils, fat, oils mixed with refined kerosene or other solvents.

The knife is an utility tool and should be replaced regularly. The knife is not covered by guarantee.

ENVIRONMENTAL PROTECTION

• the appliance is made of materials which can be recovered or recycled
• the appliance should be handed over to the appropriate centre of collection and recycling of electrical and electronic equipment

WARRANTY

• the appliance is intended for personal use at a household,
• it is not intended for professional purposes,
• in case of misuse, the warranty is rendered null and void.

BEZPEČNOSTNÍ DOPORUČENÍ

Collection of hair styling tools including a hairdryer, brush, and comb (no text or labels visible)

Close-up of a black plastic clip with labeled parts (A, B, C, D) and a small inset showing a circular object (no text or symbols on the clip itself)

Close-up of a black plastic clip with labeled parts (A, B, C, D) and a numbered label '15' on the left, alongside an inset photo of a circular object (no readable text or symbols)

Black plastic tray cover with a handle and label '15' (no other text or symbols)

- výkon: 12 W

- napätie napájania: 230V \~ 50Hz

POUŽÍVANIE

Strihanie

Black plastic object with a handle and label '15' (no other text or symbols visible)

Black plastic object with a handle and label '15' (no other text or symbols visible)