01114 - Vacuum Cleaner Maxxmee - Free user manual and instructions

USER MANUAL 01114 Maxxmee

• Operating instructions 1 x Check the items supplied for completeness and the components for transport damage. If you find any damage, do not use the device but contact our customer service department. Remove any possible films, stickers or transport protection from the device. Never remove the rating plate and any possible warnings!

Possible dirt residues in the dust container can be attributed to quality checks and do not consti- tute a defect with the device.

SYMBOLS Danger symbols: These symbols indicate possible dangers. Read the associated safety notices care- fully and follow them. Supplementary information Read the operating instructions before use.

Warning: UV-C radiation

Protection class II SIGNAL WORDS Signal words indicate hazards if the asso- ciated notices are not followed. DANGER – high risk, results in serious injury or death WARNING – medium risk, may result in serious injury or death NOTICE – may result in risk of damage to material INTENDED USE ■ This device is intended to be used to kill off bacteria and remove dust, germs and domestic dust mites. It is suitable for use on mattresses, bed sheets, bed covers, upholstered furni- ture and similar items. On no account should the device be used to suck up the following: ○ liquids or wet substances (e.g. wet carpet shampoo) ○ glowing ash, cigarette ends, matches, etc. ○ inflammable or explosive substances ○ very fine dust (e.g. concrete dust), ash or toner ○ pointed, hard objects such as large pieces of broken glass ■ The device is for personal use only and is not intended for commercial applications. ■ The device should only be used as described in the operating instruc- tions. Any other use is deemed to be improper. ■ The warranty does not cover faults caused by incorrect handling, damage or attempted repairs. The same ap- plies to normal wear and tear. Dear Customer, We are delighted that you have chosen the MAXXMEE compact handheld dust mite vacuum cleaner. It not only removes dust and dirt from mattresses, pillows, covers and upholstered furniture, but at the same time also sterilises the surfaces with UV-C light. If you have any questions about the device and about spare parts/accessories, contact the customer service department via our website: www.ds-group.de/kundenservice We hope you have a lot of fun with your MAXXMEE compact handheld dust mite vacu- um cleaner. Information About the Operating Instructions Before using the device for the first time, please read through these operating in- structions carefully and keep them for future reference and other users. They form an integral part of the device. The manufacturer and importer do not accept any liability if the information in these operating instructions is not complied with. 01114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 1001114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 10 27.07.2023 14:34:2027.07.2023 14:34:20Compact Handheld Dust Mite Vacuum Cleaner

WARNING: Note all safety notices, instructions, illustra-

tions and technical data provided with this device. Failure to follow the safety notices and instructions may result in electric shock, fire and / or injuries. ■ This device must not be used by children. The device and the connecting cable must be kept away from children. ■ This device may be used by people with reduced physical, sensory or mental abilities or a lack of experience and/or knowledge if they are supervised or have received instruction on how to use the device safely and have understood the dan- gers resulting from failure to comply with the relevant safety precautions. Children must not play with the device. ■ The device must always be disconnected from the mains pow- er when it is left unattended and before it is assembled, disas- sembled or cleaned. ■ Never immerse the device and the connecting cable in water or other liquids and ensure that they cannot fall into water or become wet. ■ In the interest of your own safety, inspect the device for dam- age each time before you use it. Only use the device if it is not damaged! If the device or the connecting cable of the device are damaged, they must be replaced by the manufacturer, customer service department or a similarly qualified person (e.g. specialist workshop) in order to avoid any hazards. DANGER – Danger of Electric Shock ■ Use and store the device only in closed rooms. ■ Do not use or store the device in rooms with high humidity. ■ If the device falls into water while it is connected to the mains power, pull the plug out of the plug socket im- mediately! Only after this should you retrieve the device from the water. ■ Never touch the device and the con- necting cable with wet hands when the device is connected to the mains power. WARNING – Risk of damage to the eyes and skin! ■ Germicidal ultraviolet rays are harmful to the eyes and skin. Never expose yourself or other people and animals to direct or reflected rays! If you come into contact with the rays, consult a doctor immediately. 01114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 1101114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 11 27.07.2023 14:34:2027.07.2023 14:34:20EN

■ Make sure that the safety switches of the UV-C lamp are not blocked! WARNING – Danger of Injury ■ Keep children and animals away from plastic bags and films. There is a dan- ger of suffocation. ■ Make sure that the connecting cable is always kept out of the reach of small children and animals. There is a danger of strangulation. ■ Lay the connecting cable in such a way that it does not present a trip hazard. ■ Danger of becoming stuck! Keep animals, hair, jewellery, wide clothing, fingers and all other body parts away from the suction opening of the device. They could become caught. WARNING – Danger of Fire ■ Do not cover the device during operation in order to prevent it from catching fire. Do not insert anything into the openings of the device and make sure that they and the ventila- tion slots on the sides do not become clogged or covered. NOTICE – Risk of Damage to Material and Property ■ Only connect the device to a plug socket that is properly installed and matches the technical data of the device. The plug socket must also be readily accessible after connection so that the connection to the mains can quickly be isolated. ■ Only use suitable extension cables whose technical data is the same as that of the device. ■ Make sure that the connecting cable is not squashed, bent or laid over sharp edges and does not come into contact with hot surfaces. ■ The device must be switched off when inserting or removing the mains plug. ■ Pull the mains plug out of the plug socket if an error occurs during opera- tion or before a thunderstorm. ■ Always pull the mains plug and never the mains cable to disconnect the de- vice from the mains power. Never pull or carry the device by the mains cable. ■ Protect the device from heat, naked flames, sub-zero temperatures, per- sistent moisture, wet conditions and impacts. ■ Do not try to lubricate the castors with lubricant or oil. This would cause dust and dirt to increasingly adhere to the castors. ■ Use only original accessories from the manufacturer in order to guarantee that there is no interference that may prevent the device from working and to avoid possible damage. ■ Do not place heavy objects on the device or the connecting cable. SAFETY DEVICES The device has two safety switches (9,12). The UV-C lamp(13) only switches on if both safety switches are pressed into the motor unit (3) (automatic switch-off func- tion of the UV-C lamp deactivated). This happens automatically when the device is placed on a flat surface. If the safety switches lose contact with the surface below, the automatic switch-off function is activated and the UV-C lamp stops being lit (automatic switch-off function of the UV-C lamp activated). 01114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 1201114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 12 27.07.2023 14:34:2127.07.2023 14:34:21Compact Handheld Dust Mite Vacuum Cleaner

• Always clean mattresses on both sides.

• We recommend cleaning new mat- tresses once a month. Older mattress- es should initially be cleaned every day for a week. We then recommend cleaning them once a month.

• The EPA filter should be replaced every 12 – 18 months; the UV-C lamp(13) should be replaced every 12 – 24 months. If you have any questions about spare parts, please contact the customer service depart- ment via our website: www.ds-group.de/kundenservice USE Please Note! ■ The device should only be used if it has been fully and correctly assem- bled! The dust container and the filter must be inserted and must not be damaged! If the dirt were to get inside the motor unit, this could dam- age the motor. ■ Make sure that the safety switches of the UV-C lamp are not blocked!

1. Plug the mains plug into a properly

installed plug socket that is easily accessible.

2. Place the device down flat on the

surface which is to be cleaned.

3. Press the On / Off switch (1) to switch

on the device. The device starts to vacuum and the UV-C lamp (13) and the vibration head(10) switch on. The UV control lamp(4) lights up.

The vibration shakes up the surface which is to be cleaned and the dust which is agitated is sucked in through the suction opening (11).

4. Guide the device very slowly and

evenly over the surface which is to be cleaned.

5. After vacuuming, press the On / Off

switch to switch off the device. The UV control lamp goes out.

6. Pull the mains plug out of the plug

CLEANING AND STORAGE

Please Note! ■ Empty the dust container each time af- ter you use the device. The filter must also be regularly cleaned in order to prevent overloading of the motor. ■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the device. These may damage the surface.

• Make sure that the mains plug has been pulled out and the device is disconnected from the power.

• Wipe down the motor unit (3) if nec- essary with a damp soft cloth. Then dry with a soft cloth.

• Wipe out the recess for the dust con- tainer(5) with a duster. Cleaning the Dust Container and EPA Filter

1. Reach into the recess in the dust con-

tainer(5) and pull it up and out of the motor unit (3).

2. Pull the EPA filter out of the dust

4. Wipe out the dust container with a dry

duster if necessary.

5. Tap out the EPA filter and clean it

NOTICE: Allow the EPA filter to dry completely before the device is reas- sembled.

6. Insert the EPA filter into the dust

unit. It must engage audibly. Cleaning the UV-C Lamp Please Note! ■ The UV-C lamp will become hot during use. Allow the UV-C lamp to cool sufficiently after using the device. There is a danger of burns!

1. Undo the two screws on the cover(8)

of the UV-C lamp (13) and take off the cover.

2. Wipe down the UV-C lamp with a dry

duster. NOTICE: Make sure that you do not touch the UV-C lamp with your fingers!

3. Place the cover back on and fix it in

place with the two screws. Removing the UV-C Lamp NOTICE: Make sure that you do not touch the UV-C lamp directly with your fingers! Carefully lift the UV-C lamp (13) and dis- connect it from the contacts. When you fit a new UV-C lamp, first insert it into a contact and place it some way into the recess before inserting it into the second contact. Storage Store the device in a cool, dry place which is protected from direct sunlight and is out of the reach of children and animals. TROUBLESHOOTING If the device does not work properly, check whether you are able to rectify the problem yourself. If the problem cannot be solved with the steps below, contact the customer service department. Do not attempt to repair an elec- trical device yourself! The device generates no suction. The mains plug is not inserted in the plug socket correctly. ► Correct the fit. The plug socket is defective. ► Try another plug socket. There is no mains voltage. ► Check the fuse of the electrical dis- tributor (fuse box). The device is not switched on. ► Press the On / Off switch (1). Low suction force. The dust container (5) is too full. ► Empty the dust container. The EPA filter is dirty. ► Clean the EPA filter. The suction opening (11) is blocked. ► Switch off the device, pull the mains plug out of the plug socket and remove the blockage. The UV-C lamp (13) does not light up. The automatic switch-off function of the UV-C lamp has been activated. ► Check the safety switches (see the “Safety Devices” chapter). Unusual odour The device is being used for the first time. ► A new odour is normal when the device is used for the first time; it disappears after a while. 01114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 1401114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 14 27.07.2023 14:34:2127.07.2023 14:34:21Compact Handheld Dust Mite Vacuum Cleaner

DISPOSAL Please Note! ■ The UV-C lamp should be removed prior to disposal of the device and disposed of separately from the device. Notes on how to remove the UV-C lamp can be found in the “Cleaning and Storage” chapter – “Removing the UV-C Lamp”. Dispose of the packaging material in an environmentally friendly manner so that it can be recycled. The adjacent symbol (crossed-out bin underlined) means that used devices should not be disposed of in the domestic waste, but should instead be taken to special collection and return systems. Owners of used devices from private households can take them free of charge to the collection points of the public waste disposal authorities or the disposal points which are set up by manufacturers and distributors under the Electrical Equipment Act so that they can be disposed of in an environmentally friendly way and valuable raw materials can be recovered. If they are not disposed of properly, toxic ingredients may escape into the environment and cause harm to the health of humans, animals and plants. Businesses which market electrical and electronic devices are also obliged to take back used devices. Waste prevention makes an even more valuable contribution to protecting the environment. This means if possible, as well as continuing to use or repair a device yourself, passing it on to another user also represents an ecologically beneficial alternative to disposal. TECHNICAL DATA Article number: 01114 Model number: KB-816 Power supply: 220 – 240 V ~ 50 – 60 Hz Power: max. 300 W Protection class: II ID of operating instructions: Z 01114 M WO V2 0723 mh All rights reserved. 01114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 1501114_Inlay_DE-EN-FR-NL-PL_A5_V2.indb 15 27.07.2023 14:34:2227.07.2023 14:34:22FR