BGX300 - Glue gun RAPID - Free user manual and instructions

Product Type	Cordless Electric Glue Gun
Brand	Rapid
Model	BGX300
Power	30 W
Battery Life	Approximately 1 hour
Battery Charging Time	Less than 4 hours
Battery Model	A300
Nozzle Temperature	Up to 200 °C (400 °F)
Glue Stick Diameter	12 mm
Recommended Glue Type	Rapid ∅12 mm
Charger Input Voltage	100-240 V, 50-60 Hz
Charger Output Voltage	8.4 V DC
Charger Output Current	1000 mA
Ambient Charging Temperature	Between +10 °C and +40 °C
Battery Storage Temperature	Do not exceed 40 °C
Usage	Indoor use only (charger)
Safety	Double insulation of charger, overheat protection
Maintenance	Clean after cooling, do not immerse
Recycling	Battery and device comply with WEEE, separate collection
Included Accessories	Device stand, charger, battery

Frequently Asked Questions - BGX300 RAPID

What type of battery does the Rapid BGX300 glue gun use?

The gun uses an A300 model battery supplied with the device. It is removed by pressing the two unlocking buttons.

How long does it take to charge the battery?

Charging time is less than 4 hours. The charger indicator changes from red to green when the battery is fully charged.

What is the maximum temperature reached by the nozzle?

The nozzle can reach up to 200 °C (400 °F). Avoid any contact with the skin.

Which glue sticks should be used with the BGX300?

Use only Rapid glue sticks with a diameter of 12 mm. Using other types may damage the device.

How to turn the glue gun on and off?

Set the On/Off switch to 'I' to turn on (green indicator) and to '0' to turn off.

Can I use the gun while charging?

No, do not use the device while charging. Set the switch to '0' or remove the battery before charging.

What to do in case of glue burn?

Immediately immerse the wound under cold water. Never attempt to remove a large piece of glue without medical assistance.

How to store the gun after use?

Place it on its stand in a vertical position. Wait for it to cool down before storing.

Does the charger heat up normally?

Yes, during charging, the charger may get slightly warm, which is normal.

How to recycle the used battery?

Do not dispose of the battery with household waste. Drop it off at a local collection point for hazardous waste or WEEE.

USER MANUAL BGX300 RAPID

Black and white photo of a RapidKK BGX300 electric glue gun (no visible text or symbols on body)

GB Corded electric Hot Melt applicator

SAFETY INSTRUCTIONS:

Warning! Read carefully before using the glue gun – hot melt applicator.

Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury.

Save all warnings and instructions for future reference.

Warning! This tool must be placed on its stand when not in use

WORK AREA SAFETY:

• Keep work area clean and well lit. Cluttered or dark areas invite accidents.
• Do not operate tool in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.
• When applying at a height, take all the necessary precautions to ensure that the glue does not run onto the operator or onto any object.
• When you have finished using the tool, wait until it has cooled before to store it.

ELECTRICAL SAFETY:

• Do not use or store the tool in damp or wet conditions. Do not expose it to water or other fluid substances in any way.
• Never pull the cord to unplug the charger.
• The appliance must be disconnected from the supply

means when removing the battery.

- Do not use the tool if any part is damaged or defective.

PERSONAL SAFETY:

- Both the glue and the nozzle of the tool can reach temperatures up to 200°C (400°F).

- Avoid all skin contact. If burnt, plunge the burn under cold water. Never attempt to remove solidified glue from burnt skin without medical assistance.

- THIS APPLIANCE can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

BATTERIES SAFETY:

CAUTION !!

- Use power tools only with specifically designated battery checks. Use of any other battery checks may create a risk of injury and fire.

- Never attempt to open for any reason.

- Do not expose the battery to water and any other liquids.

• Do not expose the battery to heat.
• The battery is to be disposed of safely.
• Rechargeable batteries are to be removed from the appliance before being charged.
• Batteries are to be inserted with the correct polarity
• Be careful not to short-circuit batteries.
• Do not store in locations where the temperature may exceed 40°C.
• Charge only at ambient temperature between 10°C and 40°C.
• Charge only using the charger provided with the tool.
• When not in use for a long time, remove the batteries from the device to prevent them from leaking.
• The battery must be removed from the appliance before it is scrapped
• The appliance must be disconnected from the supply mains when removing the battery

CHARGER SAFETY:

• The charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate.
• The charger is intended for indoor use only.
• Use your charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal

injury and damage.

• Do not expose the charger to water.
• Do not open the charger.
• Replace the charger if the wire is damaged.
• Appliance is only to be used with the power supply unit provided with the appliance

TECHNICAL FEATURES:

- Specifications:

1 - Tool support
2 - Nozzle
3 - On/off switch
4 - Tool LED light
5 - Trigger
6 - Socket
7 - Battery unlocking button.
8 - Battery
9 - Plug
10 - Charger
11 - Charger LED

- Tool:

Power rating: 30 W

Battery life: ≈ 1 hour

- Battery:

Model: A300

Voltage: 7,4 V

Capacity: 2600 mAh

Time of charging: < 4 hours

- Charger:

Input: 100-240V 50-60Hz

Output: 8,4 V cc

Intensity: 1000 mA

- Glue: Rapid ∅12 mm

OPERATING INSTRUCTIONS OF TOOL:

• Removal and connection of the battery (8): To remove the battery (8), press the unlocking buttons (7) and slide the battery out of the machine. To connect the battery; slide it in the other direction until the connection clicks.
• Stand the tool upright on his support (1) and the battery (8). Never put the tool flat on a table.
• Start-up: switch the “on/off switch” (3) on “I” (on). The green LED (4) light come on.
• Leave the tool warming up several minutes.
• Feed glue sticks in to the rear of the tool.
• Place the nozzle of the tool against the surface and press gently on the trigger to extrude glue. Place the second element in contact with the glue, if need be adjust it and press parts together for an average of 10 seconds.
• Use only glue sticks recommended.
• Never pull/remove a glue stick from the tool once is has been fed into the tool. The resultant molten glue could create irreparable damage to the tool.
• Once finished, put the switch (3) on "0" (off).
• When the battery is decharged, the green LED light (4) will go out.

OPERATING INSTRUCTIONS OF CHARGER:

- Do not use the tool whilst

charging the battery.

Ensure the tool is switched in the “off” position “0”, or remove the battery out off the tool.

• Connect the charging point (9) of the charger into the socket (6) off the battery.
• Connect the charger (10) to the mains. â the LED (11) on the charger will turn red during the charge.
• When the battery is full charged, the LED (11) off the charger turn green.
• Disconnect the plug (9) out off the socket (6) and unplug the charger (10) from the mains.
• During the process of charging, the charger can become warm: this is normal.

BATTERY DISPOSAL

Exhausted batteries are to be removed from the appliance and safely disposed of.

Batteries may not be disposed of with the usual domestic waste, they may contain toxic heavy metals and are subject to hazardous waste regulations.

For this reason, dispose of used batteries at a local collection point

2012/19/EU

Waste Electrical and Electronic Equipment

(WEEE)

Electrical and electronic devices contain materials and substances that can have damaging effects on human health and the environment. This symbol indicates that this device must not be treated as

unsorted municipal waste but must be collected separately. Dispose of the device via a collection point for the recycling of waste electrical and electronic equipment within the EU, UK and in other European countries that operate separate collection systems for waste electrical and electronic equipment. By disposing of the device in the proper manner, you help to avoid possible hazards for the environment and public health that could otherwise be caused by improper treatment of waste equipment. The recycling of materials contributes to the conservation of natural resources.

BGX300

SIKKERHET I ARBEIDSOMRÅDET:

NAVODILA ZA UPORABO NAPRAVE:

• Odstranitev in priključitev baterije: (8): Da bi odstranili baterijo (8), pritisnite na gumb za sprostitev baterije (7) in spustite baterijo iz naprave. Baterijo priključite tako, da jo v obratni smeri vstavite v napravo dokler ne naredi “klik”.
• Naj naprava stoji pokonci na podstavku (1) in na bateriji(8). Orodje naj nikoli ne leži na mizi.
• Začetek uporabe: pretaknite stikalo “on/off” (3) v položaj “I” (on - prižgano). Zelena LED lučka se bo prižgala.
• Naj se naprava v nekaj minutah ogreje.
• Vstavite lepilno paličico z zadnje strani v napravo.
• Nežno pritisnite šobo naprave na površino in pritisnite na sprožilec, da bi iztisnili tekoče

SIGURNA RADNA POVRŠINA:

UK Importer and authorised representative:

ACCO UK Limited

Oxford House Oxford Road

Aylesbury HP21 8SZ

United Kingdom

Isaberg Rapid AB

SE-335 71 Hestra, Sweden

www.rapid.com