Time & Light 60.2029.10 - Digital Alarm Clock TFA - Free user manual and instructions

USER MANUAL Time & Light 60.2029.10 TFA

Thank you for choosing this instrument from TFA.

Before you use this product: Please make sure you read the instruction manual carefully.

The operating instructions are enclosed with the device or can be downloaded at

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

This product should only be used as described within these instructions. Following and respecting the instructions in your manual will prevent damage to your instrument and loss of your statutory rights arising from defects due to incorrect use.

We shall not be liable for any damage occurring as a result of non-following of these instructions.

Please take particular note of the safety advice! Please keep this Instruction manual safe for future reference.

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

m = 311

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

www.tfa-dostmann.de/en/service/downloads/Instruction-manuals

Digital alarm clock and LED night light Cat. No. 60.2029.10

Delivery contents:

Digital alarm clock
- Micro USB cable
- Instruction manual

Range of application and all the benefits of your new instrument at a glance:

Combination of alarm clock and night light
Simply flip over and the alarm clock becomes a night light (7 brightness levels)
2 different alarm times, shake the device to activate the snooze function
Display backlight in 3 brightness levels, with automatic timer at night
- - Charging via micro-USB cable (included)
High quality, matt rubberised surface

For your safety:

This product is exclusively intended for the range of application described above.
This product should only be used as described within these instructions.

CAUTION! Risk of electrocution!

• Connect the device via the USB cable only to a suitable USB power source such as a computer, USB charger or USB hub with charging output (5V DC).
  The product must not come into contact with water or moisture.
• Do not charge the product if the housing is damaged.
  Charge the device out of reach of persons (including children) who cannot fully appreciate the potential risks of handling electrical equipment.
• Disconnect the device from the charging power source immediately if any fault occurs.

English

WARNING! Risk of injury!

• Small parts can be swallowed by children (under three years old).
• Batteries containing lithium carry a risk of fire or explosion due to heat or mechanical damage! Protect it from high temperatures. Do not throw into fire, short-circuit or take apart. If the device becomes hot while charging or the battery is no longer charged, this is a sign of a defect. Disconnect the device from the charging power source immediately.
  The battery cannot and must not be replaced or removed by you. There is a risk of explosion if the battery is replaced incorrectly. If necessary, a qualified person can obtain instructions on how to dismantle the permanently installed battery from [e-mail], should this be necessary for the purpose of repairing or recycling the product.

CAUTION

Unauthorized repairs, alterations or changes to the product are prohibited.
Do not expose the device to extreme temperatures, vibrations or shocks.
Clean the instrument with a soft damp cloth. Do not use solvents or scouring agents!

Elements:

LCD Display (Fig.1) Buttons (Fig.1) A Time

C-Night light symbol
D-Charging status symbol G-ALARM2 button
F - Alarm symbol 2 H - ALARM 1 button
J - Alarm symbol 1
L-Snoopz symbol N-TIME SET button
M - AM/PM in 12-hour format
0-Time symbol

Housing (Fig.2)

A-Night light
C-Micro USB port

Position digital alarm clock

E ^+ button

• button

B-RESET button
Position night light

B-LIGHT button

Getting started

• Remove the protective film from the display.
• Insert the supplied USB cable with the micro-USB plug into the provided opening on the device (Fig.2-C). Connect the device via the USB cable only to a suitable USB power source.
  The device switches on.

Charging

Before the first use, please charge it fully.
To fully charge, leave the device connected for approximately 3 - 4 hours.
The charging status symbol flashes during charging. The charging status of the device is shown on a symbol with three bars (Fig.1-D).
- When the device is fully charged, the charge icon will appear filled. Disconnect the device from the charging power source.
- Do not leave the fully-charged device connected to the charging power source as this may shorten battery life.
The lowest bar flashes when the battery needs to be recharged.
Please charge the device immediately to preserve battery life.
- Recharge the battery every six months, even if the product is not in use.
- Switch off the device (press and hold the + and - button (Fig.1-E, Fig.1-K) at the same time) if you are not going to use it for a longer period of time.

Operation

• When entering the setting mode and each successful double-click is followed by a beep.
  Press and hold the ^+ or - button (Fig.1-E, Fig.1-K) in the respective setting mode for quick setting.
  The device will automatically quit the setting mode if no button is pressed for 10 seconds.

Time setting

Press and hold the TIME SET button (Fig.1-N) in normal mode to enter the setting mode.

The time symbol appears (Fig.1-0).

The hour digit flashes on the display. Press the ^+ or - button (Fig.1-E, Fig.1-K), to adjust the hours.
Confirm with the TIME SET button
Set the minutes in the same way. Confirm with the TIME SET button.

12- or 24-hour system

• Press the TIME SET button (Fig.1-N) twice in quick succession in normal mode to set the 12 HR or 24 HR system. In the 12 Hr system AM or PM (Fig.1-M) (after 12 o'clock) appears on the display.

Alarm clock function

Press the ALARM 1 (Fig.1-H) or ALARM 2 (Fig.1-G) button in normal mode. The last adjusted alarm time will be displayed for a short moment. The corresponding alarm symbol flashes.

Alarm time setting

Press and hold the ALARM (Fig.1-H) button in normal mode to enter the alarm setting mode.
The hour digit and the alarm symbol 1 (Fig.1-J) start blinking.
Press the + or - button (Fig.1-E, Fig.1-K) to set the hours.
- Confirm the setting with the ALARM 1 button.
Set the minutes in the same way.
- Confirm the setting with the ALARM 1 button.
- ALARM 2^品 can be adjusted in the same way.

Activate and deactivate the alarm

• Press the ALARM 1 (Fig.1-H) or ALARM 2 (Fig.1-G) button twice in quick succession in normal mode.
  The alarm is activated. The corresponding alarm symbol |^|_D (Fig.1-J| Fig.1-F) appears permanently on the display.
  Press again the ALARM 1 or ALARM 2 button to deactivate the alarm. The alarm symbol disappears.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached. The backlight turns on.
• Press any button or flip over the alarm clock to stop the alarm.
  If the alarm is not stopped manually, the ascending alarm tone automatically turns off after 3 minutes and it will be reactivated at the same set time on the following day.
• When the alarm goes on, activate the snooze function by shaking it with a quick, lateral movement.
  The snooze symbol (Fig.1-L) will appear on the display.
  The alarm will be interrupted for 5 minutes.

Display light

The backlight is activated by a sensor that reacts to vibrations, e.g., by lifting and setting down the device.
- Alternatively, press any button. The backlight tums on for ten seconds.
In normal mode, press + or - button (Fig.1-E, Fig.1-K) button to adjust the brightness in 3 steps or switch off the backlight completely (OFF - LOW - MIDDLE - HIGH).
From 9 p.m. to 7 a.m., a permanent backlight automatically switches on at the set brightness level. Note: If the brightness is set to "OFF", the automatic backlighting at night is also switched off.

Night light

Press the LIGHT button (Fig.1-B) twice in quick succession in normal mode.
The night light symbol 品 (Fig.1-C) appears on the display. The function is activated.
- Flip over the alarm clock to turn on the night light. The night light faces up.
In this position you can now use the + or - button (Fig.1-E, Fig.1-K) to set the brightness to 7 different levels.
To turn off the night light, flip over to the alarm clock side. The digital alarm clock faces up again.
To deactivate the night light function, press the LIGHT button twice in quick succession in normal mode. The night light symbol disappears.

Troubleshooting

Problem: Solution:
No display on the device Charge the device via micro-USB cable (incl.)
Incorrect indication Press the RESET button (Fig.2-8) for 3 seconds using a pin
Device makes a noise when shaken or flipped over	Not a malfunction! The device has a ball switch that may make a slight noise when the ball rolls around.

If your device fails to work despite these measures, contact the retailer where you purchased the product.

Specifications

Power consumption: Built-in Li-Ion rechargeable battery

Capacity / Energy: 1200 mAh

Charging power source: Micro-USB 5V DC | max. 500mA

Accessories: Charging cable (USB to Micro-USB)
Charging time: Approx. 3-4 hours

Battery runtime: Up to 200 hours (depending on the light level)
Housing dimension: 81 × 115 × 93 mm

Weight: 159 g (device only)

Waste disposal

This product and its packaging have been manufactured using high-grade materials and components which can be recycled and reused. This reduces waste and protects the environment.

Dispose of the packaging in an environmentally friendly manner using the collection systems that have been set up.

Disposal of the electrical device

Caution! This device contains a built-in battery that cannot be removed without damaging it. Improper removal represents a safety risk. Hand in the device unopened at the point; the device and battery will be disposed of properly.

This product is labelled in accordance with the EU Waste Electrical and Electronic Equipment Directive (WEEE).

Please do not dispose of this product in ordinary household waste. As a consumer, you are required to take end-of-life devices to a designated collection point for the disposal of electrical and electronic equipment, in order to ensure environmentally friendly disposal. Observe the current regulations in place!

WARNING! Batteries containing lithium can explode

Old batteries and rechargeable batteries containing lithium (Li-lithium) present a high risk of fire and explosion due to heat or mechanical damage with potentially serious consequences for people and the environment. Pay particular attention to correct disposal.

No part of this manual may be reproduced without written consent of TFA Dostmann. The technical data are correct at the time of going to print and may change without prior notice.

The latest technical data and information about this product can be found in our homepage by simply entering the product number in the search box.

www.tfa-dostmann.de

97877 Wertheim, Germany

09/21

Français

Affichage LCD (Fig.1) Touches (Fig.1)

E-Touche+
G-Touche ALARM 2

K-Touche
N-Touche TIME SET

Alimentation: Batterie Li- ion rechargeable incorporee

m = 311

Behuizing (Fig.2)

A-Nachtlicht

B-RESETtoets