KB12 - Ice Maker H.KOENIG - Free user manual and instructions

USER MANUAL KB12 H.KOENIG

It is important that you read these instructions before using your portable ice maker and we strongly recommend that you keep them in a safe place for future reference. Your safety and the safety of others are very important. We have provided many important safety messages manual and your appliance. Always read and obey all safety massages. This is the safety alert symbol: All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”. These words mean: You can be killed or seriously injured if you don’t immediate follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons or property. Read all instructions before using any appliance. l Do not operate this ， or any other appliance with a damaged cord. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. This ice-maker must be positioned so that the plug is accessible . Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle. l Do not run the power cord over carpeting or other heatinsulators. Do not cover the cord. Keep cord away from traffic areas, and do not submerge in water. l We do not recommend the use of an extension cord, as it may overheat and become a risk of fire. If you must use an extension cord, use No. 0.75mm

minimum size and rated no less than 16A/250V~ with a plug. l Unplug the ice maker before cleaning or making any repairs or servicing. l Exercise caution and use reasonable supervision when appliance is used near children. l Do not use your ice-maker outdoors. Place the ice-maker away from direct sunlight and make sure that there is at least 10mm of space between the back of your unit and wall. Keep a minimum distance of 10mm on each side of your unit free. l Do not use other liquid to make the ice-cube other than water. l Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or explosion. l Do not tip over. l If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to room temperature before plugging it in. l This appliance may be used by persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge, provided that they are supervised or instructed in the safe use of the appliance and that they fully understand the potential hazards. l Children should be supervised to ensure that they do not play with the appliance. ● Please according to local regulations regarding disposal of the appliance for its flammable blowing gas. Before you scrap the appliance, please take off the doors to prevent children trapped.● This appliance may be used by children of at least 8 years of age, as long as they are supervised and have been given instructions about using the appliance safely and are fully aware of the dangers involved. ● Cleaning and maintenance should not be carried out by children unless they are at least 8 years of age and are supervised by an adult. ● Keep the appliance and its power cord out of reach of children under 8 years of age. ● When using electrical equipment, safety precautions must always be taken to prevent the risk of fire, electric shock and/or injury in the event of misuse. ● Make sure that the voltage rating on the typeplate corresponds to your main voltage of your installation. If this is not the case, contact the dealer and do not connect the unit. ● Never leave the unit unattended while in operation. ● Please keep this document at hand and give it to the future owner in case of transfer of your device. ● The device is not intended to be operated by external timer means or a remote control system.

WARNING: This appliance must be earthed.

IMPORTANT: The wires in this mains lead are colored in accordance with the following code: Green or Green with a strip yellow: Grounding Blue: Neutral Brown: Live To avoid a hazard due to instability of the appliance, it must be placed at an even or flat surface.l Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. l This appliance is intended for use in domestic and similar applications such as - kitchen areas in shops, offices and other working environments - farmhouses - in hotels, motels and other residential environments - guest rooms. l bed and breakfast type environments; l catering and similar non-retail applications. l Warning: Risk of fire/flammable materials used. Please according to local regulations regarding disposal of the appliance for its flammable blowing gas. Before you scrap the appliance, please take off the doors to prevent children trapped. l WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.GETTING TO KNOW YOUR UNIT l WANING: Do not damage the refrigerant circuit. l WARNING: Do not use mechanical devices or other means to accelerate the defrosting process or ice harvesting process, other than those recommended by the manufacturer. l WARNING: Do not use other type of electrical appliances inside the ice-maker. l This appliance must be earthed. GENERAL INSTRUCTION Before using your device :

• Remove the exterior and interior packing.

• Before connecting the Ice cream maker to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

4. Top cover with transparent window

6. Water drain cap: at front btm side of the unit.

7. MAXIMUM WATER LEVEL

Remove the ice basket, you can see the water level mark.OPERATING PROCEDURES & MAINTENANCE

Control Panel: Easy to use, visible functions touch display setting. A. Selected ice size displaying: Small and Large. B. Power indicator C. Ice-Full indicator D .Water shortage indicator E. Button to turn on/off the unit. F. Button to select ice cube size.UNPACKING YOUR ICE MAKER

1. Remove the exterior and interior packaging. Check if ice basket and ice scoop inside. If any parts

are missing, please contact our customer service.

2. Remove the tapes for fixing ice shovel, ice basket & ice scoop. Clean the tank & ice basket.

3. Put the ice maker on a level & flat counter top without direct sunlight and other sources of heat

(i.e.: stove, furnace, radiator). Maker sure that there is at least 10cm gap between the back & LH/RH sides with the wall. 4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker in.5. The appliance must be positioned so that the plug is accessible.

WARNING: fill with potable water only. Only use drinking water.

• Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged please call our customer service.

1. This unit should be properly grounded for your safety. The power cord of this appliance is

equipped with a grounding plug which mates with standard grounding wall outlets to minimize the possibility of electric shock.

2. Plug your appliance into an exclusive, properly installed, grounding wall outlet. Do not under any

circumstances, damage the grounding means of the plug under any circumstances. Any questions concerning power and/or grounding should be directed toward a certified electrician.

3. This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good grounding

CLEANING AND MAINTAINING YOUR ICE CREAM

Before using your ice maker, it is strongly recommended to clean it thoroughly.

1. Unplug the ice maker before cleaning or making any

repairs or servicing.

2. Take out the ice basket.

3. Clean the interior with diluted detergent, warm water and

4. Then use the water to rinse the inside parts, and drain out

the water by unplugging the drain cap on front bottom side.

5. The outside of the ice maker should be cleaned regularly

with a mild detergent solution and warm water.

6. Dry the interior and exterior with a clean soft cloth.

7. When the machine is not to be used for a long time, drain

water completely & dry the interior.

Keep water level below the MAXIMUM water level mark.

2. Press “ON/OFF” button on the control panel to begin the ice making cycle.

3. Select the ice cube size by pressing the “SELECT” button. If the room temperature is lower than

15℃, it is recommended to select small ice cube in order to avoid ice sticking together.

4. The ice making cycle lasts approx. 6 to 13 minutes, depending on seletion of ice cube size and

the room temperature. The recommended room temperature is 10℃ to 43℃5. If water pump can’t inject water, the ice maker will stop automatically, and the “Add Water” indicator will be on.Press “ON/OFF” button, fill water up to the max. water level mark and press “ON/OFF” button again to turn on the unit again.Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.

6. The unit stops when the ice basket is full and the “Ice Full” indicator will be on. Warning: Direct

sunlight or sunlight reflection may cause infared sensor malfunction. If the unit doesn’t stop even ice cubes obstruct sensor, move the unit where no sunlight.

7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.

If unit isn’t to be used, drain all the water and dry the tank. PROBLEM POSSIBLE CAUSE SOLUTION: “Add Water” indicator is on. Lack of Water. Stop the ice maker, fill water, and press “ON/OFF” button again to restart the unit. “Ice Full” indicator is on. Ice is full in basket. Remove ice from ice basket. Continuous press “Select” button 5 seconds, the unit could make ice 10 cycles even “Ice” indicator is on. Ice cubes stick together. The ice making cycle is too long. Stop the ice maker, and restart it when the ice blocks melt. Select the small size ice cube selection. Water temperature in inner tank is too low. Replace the water. Temperature of water recommended at 8-32℃ Ice making cycle is normal but no ice formed. Room temperature or water temperature in inner tank is too high. The room temperature should be 10-43℃, water temperature should be 8-32℃ Refrigerant in cooling system leaks. Verify by a qualified technician. Pipe in the cooling system is blocked. Verify by a qualified technician.TECHNICAL PARAMETERS Protection Type I I Climate Type SN/N/ST/T SN/N/ST/T Power 220-240V/50Hz 220-240V/50Hz Ice Making Current 0.7A 0.7A Ice Harvest Current 1.0A 1.0A Refrigerant R600a/26g R600a/26g Net Weight 8Kg 8kg Vesicant C

Enclosure Plastic Stainless

WARRANTY The warranty period for our products is 2 years, unless otherwise stated, starting from the date of initial purchase or the date of delivery. If you have any problems or questions, you can easily access our help pages, troubleshooting tips, FAQ, and user manuals on our service site: https://sav.hkoenig.com. By typing the reference name of your device in the search bar, you can access all available online support, designed to best meet your needs. If you still cannot find an answer to your question or problem, then click on “Did the answer solve your problem?”. This will direct you to the Customer Support Request Form, which you can fill out to validate your request and get help. WARRANTY CONDITIONS The warranty covers all failures occurring under normal use, in accordance with the usage and specifications in the user's manual. This warranty does not apply to packaging or transportation problems during shipment of the product by the owner. It also does not include normal wear and tear of the product, nor maintenance or replacement of consumable parts.

EXCLUSION OF WARRANTY

- Accessories and wearing parts (*). - Normal maintenance of the device. - All breakdowns resulting from improper use (shocks, failure to comply with power supply recommendations, poor conditions of use, etc.), insufficient maintenance or misuse of the device, as well as the use of unsuitable accessories.- Damage of external origin: fire, water damage, electrical surge, etc. - Any equipment that has been disassembled, even partially, by persons other than those authorized to do so (notably the user). - The products whose serial number would be missing, deteriorated or illegible that would not allow its identification. - The products subjected to leasing, demonstration, or exhibition. (*) Some parts of your device, called wear parts or consumables, deteriorate with time and frequency of use of your device. This wear and tear are normal but can be accentuated by poor conditions of use or maintenance of your device. These parts are therefore not covered by the warranty. The accessories supplied with the device are also excluded from the warranty. They cannot be exchanged or refunded. However, some accessories can be purchased directly through our website: https://sav.hkoenig.com/.

ENVIRONMENT CAUTION: Do not dispose of this product as it has with other household products. There is a separation of this waste product into communities, you will need to inform your local authorities about the places where you can return this product. In fact, electrical and electronic products contain hazardous substances that have harmful effects on the environment or human health and should be recycled. The symbol here indicates that electrical and electronic equipment should be chosen carefully, a wheeled waste container is marked with a cross. Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin, 77290 Mitry-Mory, France www.hkoenig.com - https://en.hkoenig.com - Tél: [phone] FRANÇAIS