CSWL1C20CBK - Surveillance Camera NEDIS - Free user manual and instructions

USER MANUAL CSWL1C20CBK NEDIS

Wireless Camera Max. Transmit Power: 10 dBm Antenna gain: 2 dBi2 ENGLISH Introduction: Watch over your properties with this new 2.4 GHz digital wireless security camera system. The 7” LCD monitor can support up to 4 cameras and has an integrated digital video recorder. The camera oers a very sharp and stable image with night vision and the technology used improves the image quality even further. The system uses digital wireless technology and is equipped with advanced frequency signal encryption capabilities, which reduce interference caused by other applications using the 2.4 GHz frequency band. This digital technology ensures your privacy and allows you to use it over an extra long distance. THE BEST THAT WIRELESS HAS TO OFFER. The monitor and camera are paired by factory default already. When adding the additional camera CSWL1C20CBK (4 cameras max.) to the system, please refer to the section PAIRING for adding cameras.

• We recommend that you read this manual before installing/using the camera system.

• Keep this manual in a safe place for future reference. Technical specications: Transmitting frequency: 2.4-2.4835 GHz Digital Modulation: 16QAM, QPSK, BPSK Range: Indoor ±50 m, open area ±150 m (depending on local conditions) Image chip: 1/4” CMOS Lens: 2.0mm View angle: 73° Infrared illumination (LED): 5 M Protection: IP54 Microphone: mono Working temperature: -10°C ~ 50°C Voltage: 5 V DC/400 mA Dimensions: 132x64x57mm (without bracket) Weight: 287 g (included cable) Safety precautions:

• Do not open the camera or monitor in the event of a malfunction. These products should only be opened by a qualied engineer.

• Do not submerge the camera in liquid.

• Do not expose the monitor to water or humidity.

• Do not expose the monitor or camera to high temperatures (see technical specications).

• Do not install the system close to strong magnetic elds, such as a speaker. This may aect the quality.3 ENGLISH Product description:

3. PIR infrared sensor

Installation instructions: The camera can be mounted in dierent ways. For ceiling mounting use the screw thread on top of the camera. After mounting the camera connect the AC/DC power supply to the camera and a wall outlet. When adding the additional camera CSWL1C20CBK (max. 4) the camera needs to be paired to the system for the system to recognize the camera. Press the right arrow button in the main menu to select the camera settings and press OK. Pairing:

1. Press OK to enter the pairing menu.

2. Select the camera with the up and down arrow buttons.

3. Press OK, and the following screen will appear.4

4. Press the pair button within 60 seconds for 2 seconds on the backside of the camera.

5. After the successful pairing of the camera and the monitor, the monitor shows PAIRING OK.

6. Press the menu button to return to the camera menu.

Note: if pairing fails, retry the above steps and be sure that the monitor and camera are not further away than 2 metres for pairing procedure. Maintenance: Clean the product only with a dry cloth. Do not use cleaning solvents or abrasives. Warranty: Any changes and/or modications to the product will void the warranty. We cannot accept any liability for damage caused by incorrect use of this product. Disclaimer: Designs and specications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective holders and are hereby recognized as such. Disposal:

• This product is designated for separate collection at an appropriate collection point. Do not dispose of this product with household waste.