EWA7800 - Kettle AEG - Free user manual and instructions

USER MANUAL EWA7800 AEG

7-SERIES WATERKETTLE EWA7800

D·GR·NL·F·GB

D Anleitung 3-13

GB Instruction book.15-19

Before using the appliance for the first time, please read the safety advice on page 16 carefully.

D

Teile

A. Gehäuse

ExTe OpiEi ME To PAnKToP IpoeAIOyNc

to nktpo Turbo yia 1 qaii cavi eiva o 100 ^ C .Eniewn: Hpuon autn oac enipene i va pae tmupe np nootna vepu ano tvx axiotn enitpneovn (0,5 itpa).Me tn aeitoupyia Turbo yia 1 qaii cavi mnpoeite va bpae tewc kai 200 ml vepou oe epuokpaa 20C oe lyotepo ano 60 deutepoleeta.

Read the following instruction carefully before using the appliance for the first time.

persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

frequency comply with the specifications on the rating plate!

extension cable suitable for 10A can be used.

manufacturer, its service agent or similarly qualified person, in order to avoid hazard.

after use, before cleaning and maintenance.

designated handles and knobs. Allow to cool down before cleaning or storage.

Do not immerse the appliance in water or any other liquid.

spray out, which could scald or burn! Therefore never fill the kettle above the maximum marking.

boiling or just after it has switched off. Do not be anxious to uncover the lid.

accept any liability for possible damage caused by improper or incorrect use.

GB

1. Before first use: Boil water in the

2 or 3 times. This will remove any remaining dust or residues.

(See the following steps on how to use the kettle).

Wipe the outside of the kettle with a damp cloth.

1. Place the base unit on a firm and flat surface. Plug the mains plug into a

wound up at the bottom of base unit.

1. Press the Open lid button to open the lid. Fill the kettle with fresh tap water to the desired level (Min. 0.5L - Max.1.7L).

1. Close the lid and make sure that it snaps in correctly. Otherwise, the auto switch off function will not work reliably.

Place the kettle on the base.

The LCD display will be illuminated, (followed by one long beep sound), to indicate that the appliance is plugged in. The appliance is now in standby mode.

5. Press the Start/Cancel button to start or stop boiling water.

(One short beep will sound)

Note: Press and hold the Start/Cancel button longer to enter energy saving mode (LCD turned off). (One long beep will sound)

When the boiling process is finished, two short beep followed by one long beep sound will sound.

6. The automatic switch off function.

When the water has boiled or the kettle is moved from the base, it will switch off automatically. If you wish to stop the heating process before the water is boiling, simply press the Start/Cancel button.

7. Press the Preset button (A) and repeat to set a specific temperature (50 - 100^)

Depending on the temperature set, the indicator for the recommended beverage (Coffee, White Tea, Oolong Tea, Green Tea) will appear on the LCD display. Press the Start/Cancel button (B) to start boiling water.

Note: One short beep will sound when a button is pressed.

8. Press the 1-Cup Turbo button to boil one cup of water (max 200 ml) in less than 60 seconds. The setting will cancel the temperature set by the Preset button. The default temperature for the 1-Cup Turbo button is 100^ .

Note: This setting only allows to boil less water than required by the minimum water level (0.5L). The 1-Cup Turbo function can boil max 200 ml of water at 20^ temperature in less than 60 seconds.

9. Press the Keep warm button (A), then press the Start/Cancel button (B), to start boiling water.

Once the water has reached the preset temperature the appliance will enter the keep warm mode, keeping the water at the preset temperature for 40 min without reboiling it.

CAUTION: Keep enough water on the minimum water level (0.5L).

Note: If the Preset temperature is set to 100^ , the keep warm function will be unavailable.

Cleaning and Care

1. Before cleaning, always unplug the appliance. Wipe the outside of the kettle with a damp cloth. Occasionally rinse out the kettle with clean water.

Warning! Never immerse the

housing, plug, and cord in water or any other fluid.

2. To clean the mesh filter, grab the

under clean, running water, and insert it back into the kettle in the correct orientation.

steel cleaning product may be used to clean the metal of the base plate.

3. Decalcifying is recommended every three months for best performance.

Fill the kettle with water and decalcifier according to decalcifer product instructions. Do not boil the solution as it could foam over. Afterwards, rinse kettle thoroughly with fresh water.

Troubleshooting

GB

Problem Possible cause Solution
The appliance does not switch off. Close lid until it locks.
		Instert the strainer correctly.
The appliance cannot be switched on. After operating with little or no water, the appliance has not cooled down sufficiently.		Allow to cool a short time and try again.

D

GR

NL

F

GB

Disposal

GB

• Put the packaging in applicable packers to recycle it.

Help protect the environment and human health and to recycle waste of electrical and electronic appliances.

Do not dispose appliances marked with

with the household

local recycling facility or contact your municipal office.

www.aeg-home.com