UltraSpeed EWA7550 - Kettle AEG - Free user manual and instructions

USER MANUAL UltraSpeed EWA7550 AEG

J16 Read the following instruction carefully before using the appliance for the rst time.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• The appliance may only be connected to a power supply whose voltage and frequency comply with the speci cations on the rating plate!

• Never use or pick up the appliance if – the supply cord is damaged, – the housing is damaged.”

• The appliance must only be connected to an earthed socket. If necessary an extension cable suitable for 10 A can be used.

• If the appliance or the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali ed person, in order to avoid hazard.

• Always place the appliance on a at, level surface.

• The appliance must be switched o and the mains plug withdrawn before cleaning and maintenance.

• The appliance and accessories become hot during operation. Use only designated handles and knobs. Allow to cool down before cleaning or storage.

• The mains cable must not come into contact with any hot parts of the appliance.

• Do not immerse the appliance in water or any other liquid.

• Attention: If the kettle is over lled there is a risk that the boiling water may spray out, which could scald or burn! Therefore never ll the kettle above the maximum marking.

• Never operate appliance with open lid.

• Do not use or place the appliance on a hot surface or near source of heat.

• Only use the kettle for heating water!

• The kettle can only be used with the stand provided.

• Appliance is for indoor use only.

• This appliance is intended for domestic use only. The manufacturer cannot accept any liability for possible damage caused by improper or incorrect use.

3. Place the base unit on a rm and at

surface. Plug the mains plug into a wall socket. Excess cord can be wound into the bottom of base unit.

1. Before rst use, rinse the inside and

wipe the outside of the kettle with a damp cloth.

2. Press the button to open the lid,

pour water into the kettle. It is also possible to ll the kettle through the spout, without opening the lid. Make sure water level is visible in the water level indicator, but not exceeding the Max. mark.

4. Fill at least 0,5 L to ensure that the

temperature shown on the display reliable. Recommended temperatures: 50-60 °C for baby mixtures 80 °C for delicate teas (green/white) 90 °C for instant co ee or soup 100 °C for perfect black tea

The screen will indicate “0” until the temperature reaches 40 °C and then will indicate current temperature. The kettle will switch o automatically when the water is boiling.

5. Close the lid and make sure that it

snaps in correctly. Otherwise, the auto switch o function will not work reliably. Place the kettle on the base. The buzzer will buzz and the screen will indicate “0”. GB18 Getting started

8. To boil water then keep it warm at

selected temperature:

1. Press the Keep warm button to

select the keep warm temperature. 2. Then press the Power button. This function will switch o after 30 minutes. Then the buzzer will buzz.

7. To heat water to selected

temperature (not boiling):

1. Press the Temperature selection

button to select temperature. 2. Then press the Power button. When the selected temperature is reached, the kettle will automatically switch o .

1. Before cleaning, always unplug the

appliance. Never rinse or immerse the kettle or base unit in water. Just wipe with a damp cloth, using no abrasive detergents. Occasionally rinse out the kettle with clean water.

2. To clean the mesh lter, grab the

strainer insert and lift out. Cleaning the heating plate – super cial spots of rust may appear on the base unit. Remove with a stainless steel cleaning agent.

3. Decalcifying is recommended

regularly, depending on water hardness. Fill the kettle with water and decalci er according to decalci er product instructions. Do not boil the solution as it may foam over. Afterwards, rinse kettle thorougly with fresh water. Cleaning

9. To heat water to selected

temperature (not boiling) and keep it warm.

1. Press the Temperature selection

Disposal Packaging materials The packaging materials are environ- mentally friendly and can be recycled. The plastic components are identi ed by markings, e.g. >PE<, >PS<, etc. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city o ce, your household waste disposal service or the shop where you purchased the product. Disposal Troubleshooting Problem Possible cause Solution The appliance switches o before boiling. Too much lime scale at the heating element of the kettle. Run the decalcifying procedure. The appliance does not switch o . Close lid until it locks. Insert the mesh lter correcttly. The appliance cannot be switched on. After operating with little or no water, the appliance has not cooled down su ently. Allow to cool a short time and try again.3482A EWA7550 02011214 Printed on recycled paper www.aeg-home.com Electrolux Hausgeräte GmbH Fürther Strasse 246 D-90429 Nürnberg Germany