CR2032 - Balances de cuisine SILVERCREST - Free user manual and instructions

USER MANUAL CR2032 SILVERCREST

Battery indicator Technical data Max. measuring range: 5000 g / 11 lb / 176 oz / 5000 ml / 175 fl’oz Graduation: 1g / 0 lb:0.1 oz / 0.05 oz / 1ml / 0.05 fl’oz Battery: button cell, type CR2032, 1 x 3 V (Direct current) Rated current: 10 mA Model numbers: see figure A Scope of delivery Check that all the items are present and that the product and all its parts have no defects immediately after un- packing. Do not under any circumstances use the p roduct if the package contents are incomplete. 1 Kitchen scale 1 Battery (preinstalled) 1 Set of instructions for use Safety notices

KEEP ALL THE SAFETY ADVICE

AND INSTRUCTIONS IN A SAFE

AND CHILDREN! Never leave15 GB/IE children unsupervised with the packaging material. The packag- ing material represents a danger of suffocation. Children frequently underestimate the dangers. Always keep children away from the pack- aging material. This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capa- bilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards in- volved. Children shall not play with the product. Cleaning and user maintenance shall not be made by children without supervision. 5 kg

INJURY! Do not place more than 5 kg on the product. This could damage the product. Do not expose the product to – extreme temperatures, – direct sunlight – magnetic fields, – moisture. These can damage the product. This product has delicate electronic components. This means that if it is placed near an object that trans- mits radio signals, it could cause interference. This could be, for ex- ample, mobile telephones, walkie talkies, CB radios, remote controls and microwaves. If the display in- dicates a problem, move such ob- jects away from it. Electromagnetic interference / high- frequency emissions can lead to the product failing. In cases of the product failing to work, remove the battery for a short while and then replace it. Do this as described in the “Replacing the battery“ section. Protect the product from electrostatic

harge / discharge. This could hinde

the internal data exchange, which causes errors in the LC display

Check the product for damage before use. Never use a damaged product. FOOD-SAFE! The taste and smell of your food are not detrimentally affected by this product.16 GB/IE Safety instructions for batteries / rechargeable batteries DANGER TO LIFE! Keep batter- ies / rechargeable batteries out of reach of children. If accidentally swallowed seek immediate medi- cal attention.

SION! Never recharge non-rechargeable batteries. Do not short-circuit batteries / rechargea- ble batteries and / or open them. Overheating, fire or bursting can be the result. Never throw batteries / rechargea- ble batteries into fire or water. Do not exert mechanical loads to batteries / rechargeable batteries. Risk of leakage of batteries / rechargeable batteries Avoid extreme environmental con- ditions and temperatures, which could affect batteries / rechargea- ble batteries, e.g. radiators / direct sunlight. Avoid contact with the skin, eyes and mucous membranes. In the event of contact with battery acid, thoroughly flush the affected area with plenty of clean water and seek immediate medical attention. WEAR PROTECTIVE GLOVES! Leaked or damaged batteries / rechargeable batteries can cause burns on con- tact with the skin. Wear suitable protective gloves at all times if such an event occurs. In the event of a leakage of batteries / rechargeable batteries, immediately remove them from the product to prevent damage. Remove batteries / rechargeable batteries if the product will not be used for a longer period. Risk of damage of the product Only use the specified type of battery / rechargeable battery! Insert batteries / rechargeable batteries according to polarity marks (+) and (-) on the battery / recharge- able battery and the product.17 GB/IE Clean the contacts on the battery / rechargeable battery and in the bat- tery compartment before inserting! Remove exhausted batteries / rechargeable batteries from the product immediately. Before first use (Fig. C) Remove all packaging materials from the product. Turn the product over and place it on a soft under- lay to avoid scratching the surface. Loosen the screw located at the cover of the battery compart- ment

on the back of the product. Open the cover of the battery compartment

on the back of the product. Pull out the insulation strip from the battery compartment

Close the cover of the battery compartment

and tighten the screw. Replacing the battery (Fig. C) Turn the product over and place it on a soft underlay to avoid scratching the surface. Loosen the screw located at the cover of the battery compartment

on the back of the product. Open the cover of the battery compartment

on the back of the product. Remove the used battery, if present. Insert a battery type CR2032 in the battery compartment

Note: Make sure you insert the batteries with the correct polarity. This is indicated on the cover of the battery compartment

Close the cover of the battery compartment

and tighten the screw. Operation Set the product on a solid, level and flat surface to weigh. Weighing Note: Always place the object you wish to weigh gently onto the weighing surface

to switch on the product. The LC display

will show all dis- plays for approx. 3 seconds. Note: A slight touch of the button / TARE

is sufficient to operate the product. If there is too much pressure, the product may cause tilting. During this time the weighing equipment on the product is adjusting. Afterwards the numerical display

will show the last unit selected. Note: if an object (e.g. a key) is already on the weighing surface

will still read „0“. Place the item you wish to weigh onto the product. The numerical display

will show the weight of the item you are weighing. Incremental weighing Touching the button / TARE

with the product on will change the numerical display

will appear. Now add another item to weigh onto the product. The numerical display

will show the weight of the newly added item. If you remove the item added to the product, the numerical display

will again read „0“.18 GB/IE If you remove all items from the product, the LC display

will show a negative value indicated by the minus symbol

will disappear. Important! Be sure never to add more than 5 kg to the weighing surface

. Overloading the product can damage it. Changing the measuring unit The product will display the weight in the official Euro- pean measuring unit „g“ (grams), as well as the tradi- tional unit of weight „oz“ (ounce, 1 oz ≈ 28.35 g) or „lb’oz“ (pound: ounce, 1lb = 16 oz ≈ 453.59 g). When measuring the volume of water, the product calculates it by the weight using the official European unit of volume „ml“ (millilitres) or the traditional unit of measure fl’oz (fluid ounces, 1fl’oz ≈ 28.41 ml). To switch the unit of measure, briefly touch the UNIT button

. After each time it is touched, the unit display

will switch to the next unit listed: g → oz → lb’oz → ml → fl’oz Switching off

for approx. 3 seconds will off the product. If no movement is detected on the weighing surface

for 2 minute and no button is pressed, the product will automatically switch off. Troubleshooting = Fault = Cause = Solution

= The product is overloaded. = Remove the overload.

= The battery is low. = Replace the battery (see chapter „Replacing the battery“).

= The batteries are too weak to weigh. You cannot operate the product. = Replace the battery (see section “Replacing the battery”). Note: The product contains sensitive electronic compo- nents. For this reason it is possible that it can be disr upted by radio transmitting equipment in the immediate vicinity. If the LC display

indicates a problem, move such objects away from it. Electrostatic discharges can lead to malfunctions. In cases of the product failing to work, remove the batteries for a short while and then replace them. Cleaning and Care Never immerse the product in water or other liquids. This can damage the product. Clean the product with a slightly dampened, fluff- free cloth. To remove more stubborn dirt, you can also dampen the cloth with a weak soap solution. Note: You may store the product using the moun- ting bracket

for wall mounting.19 GB/IE Disposal The packaging is made entirely of recycla- ble materials, which you may dispose of at local recycling facilities. The Green Dot is not valid for Germany.