UM 3188 - Food Processor CLATRONIC - Free user manual and instructions

USER MANUAL UM 3188 CLATRONIC

Black and white photo of a modern blender with clear glass and control knob (no visible text or symbols)

CE

UNIVERSALMIXER

Universele mixer • Mixeur multifonctions • Batidora multifunción • Batedeira universa Fru llatore universale • Universalmikser • Universal Mixer • Mikser uniwersalny • Univerzální mixé Univerzális mixer • Универсальный миксец

UM 3188

DEUTSCH

Inhalt

D-47906 Kempen/Germany

General Safety Instructions

Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors. Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull the plug itself, not the lead) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you leave the room you should always turn the device off. Remove the plug from the socket.
• The device and the mains lead have to be checked regularly for signs of damage. If damage is found the device must not be used.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Children and Frail Individuals

- In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

WARNING!

Caution! Do not allow small children to play with the foil as there is a danger of suffocation!

• This device is not intended to be used by individuals (including children) who have restricted physical, sensory or mental abilities and/or insufficient knowledge and/or experience, unless they are supervised by an individual who is responsible for their safety or have received instructions on how to use the device.
• Children should be supervised at all times in order to ensure that they do not play with the device.

Special Safety Instructions

• The machine should only be used under supervision!
• Do not manipulate any of the safety switches!
• Do not remove the lid during operation.

• When mixing, keep your hands and other objects out of the jug!

• Warning: Please handle the blade with extreme care! There is a danger of injury particularly when removing the blade from the mixing vessel, when emptying the mixing vessel and during cleaning!

• Never pour liquids hotter than 60°C into the jug! Danger of scalding!
• Never use the mixer when it is empty!
• The device must only be switched on after you have inserted the seal in the hole in the lid.
• Do not carry or lift the appliance during use. Always switch it off fi rst and pull out the plug. Carry the appliance always with both hands!
• Clean the appliance only as described in „Cleaning“.
• Do not overfill! Do not exceed the maximum quantity stated on the mixing vessel!

Overview of the Components
1 Filling slot seal / Measuring jug

2	Lid
3	Mixer	vessel
4	Sealing	ring
5	Knife	block
6	Safety	switch
7	Motor	housing
8	Rotary	switch
9	Cable	take-up
10	Rubber	feet
11	Screw	top

Installation

Mains Lead

Unwind the required mains lead from the base.

Mixing Vessel

- Check the decanter (3). The screw top (11), knife block (5) and sealing ring (4) have to be assembled in the correct order. Please ensure that the sealing ring (4) is located centrally on the knife block below the carafe and that the screw top is tight. Do not forget to insert the sealing ring as otherwise the carafe will leak.

- Place the carafe on the motor housing (7). The arrow ▼ on the mixing vessel is positioned above the ▲ arrow on the motor housing.

Important notice on the safety switch

• The all-purpose mixer is equipped with a safety switch (6) that avoids that the motor run without the decanter mounted on it (danger of injury!).
• When the vessel is attached the motor block presses on the safety switch of the motor housing. The universal mixer can now be switched on. If the motor block is not fully in contact with the safety switch, the motor does not start.

Seal and Knife Block

The knife block can be removed if necessary, e.g. for cleaning.

• You can loosen the knife block by turning in a clockwise direction (LOOSEN) or tighten by turning in an anticlockwise direction (TIGHTEN). On the inside of the screw top you will find the markings LOOSEN and TIGHTEN.
• When you reinsert the knife block, please ensure that the seal forms a tight closure and that the container is tight.
• Do not forget to insert the sealing ring as otherwise the carafe will leak.

Instructions for Use

• Place the device on a firm and fl at surface. Position it is such that it cannot tip over.
• Please cut the items that are to be mixed into small pieces beforehand.
• Do not overfill! Do not exceed the maximum quantity stated on the mixing vessel!
• Ingredients: Do not put any hot items into the mixing vessel.
• Seal: The seal can also be used as a measuring jug (15-30 ml).
• Short-term operation: The device is only suitable for short-term operation of not more than 3 minutes. After this time it should be switched off.
• Pulse operation: Pulse mode is turned on by turning the switch to the "P" position and releasing it again. The maximum operating time must not exceed 3 minutes in each case. You should then wait until the device has cooled down to room temperature before using it again.
• Chopping up Ice Cubes: The blade in the mixing vessel is also suitable for chopping up ice cubes. Please only fill the carafe up to 1/3 full with ice cubes. Only pulse mode "P" should be used for chopping up ice cubes.

Operation

Preparation

• Place the mixing vessel in position.
• Now put the ingredients that are to be mixed into the mixing vessel (max. 1.5 litres).
• Position the lid in such a way that the small recess on the lid closes the spout of the carafe. The lid must be positioned firmly.
• Close the lid with the seal. Tighten the seal in an anticlockwise direction. Note the recesses on the inside of the lid.
• Please hold the carafe firmly during mixing.

Electrical Connection

• Ensure that the function switch (8) is in the "OFF" position.
• Connect the mains lead to a properly installed 230 V, 50 Hz safety power socket.

Mixing

- For constant mixing (continuous mode):

During operation on levels 1 to 5 the switch locks into the respective position. The setting can be read off on the round scale.

Level 1 = low rpm

Level 5 = high rpm

Shift the selector to "OFF" to switch off the appliance.

- For pulse mode (mixing at brief intervals):

For pulse mode (mixing at brief intervals) shift the switch to "OFF" position. The switch snaps into place. The appliance is off now. Turn the switch now to position "P". The switch must be kept in this position for the desired interval. When the switch is released, it returns automatically to "OFF" position.

CAUTION! Short-term operation: 3 Minute

Adding further ingredients to be mixed

Please switch off the machine before doing so. Spices or other ingredients that are to be mixed can be inserted through the hole in the seal.

Stopping Operation

• Turn the switch to the "OFF" position.
• Remove the mixing vessel.
  • Take off the lid before pouring.

IMPORTANT NOTE

Citrus juices and food containing acids should never be stored in metal vessels.

The carafe containing the items that have been mixed can be stored in the refrigerator, for example. Seal the pouring spout with the lid. However, it should only be left in the refrigerator for a short time.

Mains Cable Take-up Device

The mains cable can be wound up on the base.

Cleaning

Preliminary Cleaning

• Half fill the mixing vessel with water and turn the switch to P for approximately 10 seconds. Then pour out the liquid.
• Remove the mains plug from the socket.

For thorough cleaning, please remove the mixing vessel.

• Always disassemble the mixer after use. Wash and dry all the parts of the decanter.

Warning: The electric plug must be removed before the mixer is taken apart!

- The carafe can be placed in the dishwasher for cleaning. The lid, screw top, knife block and sealing ring should only be rinsed off with hot water (Caution: Beware of injury!).

• After cleaning and drying the decanter must be reassembled so that the gasket is located between the blade block and the decanter.
• Before using each time the blade block must be screwed securely onto the decanter.
• Dry the external surface of the mixer base with a moist cloth.

Troubleshooting

• Device is not working.

Remedy:

Check the mains connection.

Check the position of the rotary switch.

Other possible causes:

The device is fitted with a safety switch.

This prevents the motor from starting up unintentionally.

Remedy:

Check that the mixing vessel and lid are properly installed.

Technical Data

Model: UM 3188

Power supply: 220-240 V\~, 50/60 Hz

Power consumption: 700 W

Protection class: II

Short-term operation: 3 Min.

Filling quantity: 0,5-1,5 Litre

Net weight: 4,1 kg

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment in the domestic waste.

Please return any electrical equipment that you will no longer use to the collection points provided for their disposal.

This helps avoid the potential effects of incorrect disposal on the environment and human health.

This will contribute to the recycling and other forms of reutilisation of electrical and electronic equipment.

Information concerning where the equipment can be disposed of can be obtained from your local authority.