Ride 55 - Electric scooter URBANGLIDE - Free user manual and instructions

USER MANUAL Ride 55 URBANGLIDE

Equipment for protection 2 Driver advice and parental supervision 2 Procedures and driving conditions 2 Using charger 3

Brake 6 Frame, fork, and handlebars 6 Tires 6 Personal protection equipment 6 Battery 6

CAUTION: Driving an electric scooter may be dangerous, so be careful when using it. Misuse of the product does not affect the manufacturer, please pay attention to the tips and safety that you will find in this manual. This product can cause loss of control, a fall or à dangerous situation. If any of these things happen, you risk losing your life, please use the safety equipment and be careful around you. You drive at your risk used your common sense. This manual contains many warnings and tips for using your scooter, please read them carefully and pay attention to them. If a serious accident is caused to occur, itis notthe responsibility of the company. *< Equipements for protection Always wear the following safety equipment: -__ Helmet approved and certified according to your location -__Knee pads and elbow patches -__ Long-sleeved T-shirt and long pants - _Gloves -__ Shoes with rubber soles, never drive barefoot or sandal. Check to make the laces made, and keep them as far as possible from the wheels and the internal system.

• Driver advice and parental supervision The driver should not exceed 50kg, the size and weight do not fully certify that the driver will have full control of the vehicle. This manual contains valuable information, warnings and advice, and it is your responsibility to ensure that all users are aware of the risks. The recommended minimum age for scooter use is 6 years old. Itis your responsibility to put a younger child, taking into account their skills, maturity and ability to follow the rules. Do not touch the engine or the brakes during or immediately after using the vehicle, these parts may be extremely hot. Procedures and driving conditions Please check local laws and rules before using the scooter. Always look around when driving, and pay attention to all possible hazards. Always respect the rights and properties of everyone. Do not engage the throttle without being on the scooter and safe. Please do not try to figure or cascade with the electric scooter. This product is not designed to make jumps, skids etc.

To avoid any risk of accident, parental supervision is necessary. Never drive near vehicles, stairs, hills, swimming pools or other streams. Hold the handlebars with both hands. Never ride more than one person on the product. Keep your fingers and all other parts of your body away from the chain, engine or brakes. Never drive with a smartphone by hand or with an mp3 player. Never hang anything on the scooter to pull it. Never put the product in contact with water, electrical components can be damaged and create a dangerous situation. Roll only on flat, solid surfaces. Avoid surfaces with gravel, holes and ice can lead to loss of control and accidents. Do not drive at night or in areas where visibility is reduced. Do not drive indoors where carpets and carpets can interfere. Before each use, check that each piece is in its place and is in good condition. People who have medical follow-up or treatment such as: cardiac people, pregnant women, people not responsible, people with a problem in the back or neck should not use the product. Maximum speed of the scooter: 10 km/h Before each use, check the following: - The brakes are in good working order. -_ All components are in good condition and in their place. - The parts that showed anomalies during the last use have been repaired or changed according to the manufacturer's conditions. ° Using the charger The charger must be in perfect condition with each use, check the wires, the condition of the tips etc. ifthe product does not charge, it may be that the charger is defective, you will need to change it. Use only the supplied charger. The charger is not a toy and should be used by an adult. Never connect the charger near flammable products or liquids. Always unplug the charger from both sides when not charging.

1. Checkthe charger regularly for any possible damage to cord, plug, cover, or other parts. Ifany is found, do notuse the charger until ithas been repaired or replaced.

2. Only use a charger supplied or recommended by our company

3. The charger is not a toy and must only be used by an adult.

4. Never charge when flammable materials or liquids are nearby

5. Disconnectthe power cord and unplug from the scooter when charging is completed

6. Charge the scooter only forthe time period thatis recommended. Do notovercharge it

7. Always disconnect the charger before wiping or cleaning the scooter

Upon unpacking, please check the contents againstthe packing list.

WARNING:Before assembling the scooter, please make sure power switch is turned

be completed in 25 minutes, notincluding the time of charging forthe firsttime. Assembly can typicall hours for the first time. Time of Charging is

2pcs 4mm hex keys {Provided along with the scooter) 1pc 12—14mm open spanner (Not provided along with scooter) 1pc 13—15mm open spanner (Not provided along with scooter) 1pc 4mm socket hexagon spanner (Not provided along with the scooter 1 pc screw driver (Not provided along with the scooter) ASSEMBLY Assembling the steering handle According to the figure 1, align the steering T-bar and push itonto the fork tube. Ensure all four hales are aligned with each other. (The throttie knob on the handle shall be on the right hand side when installed.) drawing, and tighten them using two 4mm hex keys

WARNING: The scooter must always be switched off while being charged.

insert a hexagon round flat head nut and bolt into the lock hole, as indicated in the

Time of charging for the first time: 7 hours.

1. Time of any subsequent charging: about 4 hours.

2. To keep the scooter in good performance, you need to charge it at least once a

month whenitis not regularly used. Check thatthe power switch is in the "OFF" position before plugging in your charger. Plug the charger cord into the charging socket, which is on the right side of the battery box Plug the charger into the mains outlet and turn on. The charger indicator will come on. À red color indicates that the battery is being charged, and a green color indicates that the battery is fully charged.

Ensure the power switch is on the 'ON' position. The switch is located on the right side of the deck. Put one foot onto the deck and place both hands onto the handlebar To accelerate, press the throttle knob next to the right handlebar grip. The further you push, the faster the scooter will go. Make sure that both feet are on the scooter deck while riding. To turn, rotate the handlebars left or right to go the desired direction. To slow down, release the throttle knob and push down on the rear brake with your foot. Once you have finished using your scooter, please turn the power switch to the 'OFF' position.

Using as a kick scooter Using your other foot, kick yourself along by pushing your feet along the ground. To turn, rotate the handlebars left or right to go the desired direction. To slow down, gently push down on the rear brake. To stop, push the rear brake all the way. HARDWARE MAINTENANCE BATTERY Make sure the power switch is in the "OFF" position when the scooter is not in use. Never store the scooter in a frigid or icy place! Low temperature may degrade or damage the battery permanentiy ALWAYS CHECK:

PERSONAL PROTECTION EQUIPMENT

Always wear proper protection equipment, such as: A safety helmet of reliable quality. (Wearing a safety helmet may be mandatory according to the local law or regulation). - Elbow pads and kneepads: - _ Long-sleeve shirt and long pants; - Gloves; - Sports shoes Make sure that shoelaces are tied and are kept out of the way of the wheel and the driving system. BRAKE Check the brake for proper function. When you Sep the brake pedal, the rear wheel shall stop roating: When îhe brake is applied, the power shall be off and the motor shall stop working Make sure the wheels are able to rotate freely, and do not rub against the brake pedal when not applied. Never ride the scooter if its brake malfunctions. THROTTLE KNOB Ifthe power switch in the "ON" position, rotate the throttle knob and the motor will start to drive the scooter forward. Make sure you are in an open and safe place before rotating the knob. Balance your body and hold the steering handle with both hands while riding. TIRES Check the tires far excessive wear/aging and replace them when necessary.

FRAME, FORK, AND STEERING HANOLE

Always carefully inspect your scooter before every ride. Check far cracks, wearing, or loosening; and make repairs or replace parts where necessary

REPLACEMENT OF THE REAR WHEEL

Tools needed: 1 pc screw driver, 1 pc 12--14mm open spanner, and 1 pc 13--15mm open spanner. Loosen the locking screws on the motor cover using a Philips screwdriver and take off the cover. Loosen the fixing screws using Philips screwdriver

REPLACING THE REAR WHEEL

14mm solid spanner. Remove the rear wheel axle nut using a 13mm and a Take note ofthe location of the parts on the rear wheel and make sure all these parts are in their correct position when re-mounted. Mount the replacement rear wheel assembly onto the frame by inserting the assembly into the rear wheel axle housing by reversing the operation described in step 2 above. Make sure the rear wheel axle has slid home in the rear wheel axle housing on the frame. Then tighten the motor fixing screws using a Philips screwdriver. Tighten the rear wheel axle nut with a 13mm and a 14mm spanner and then check that the wheel is able to rotate freely Mount the motor cover using a screwdriver. Do not overs- tighten the screws or the motor cover might be damaged.

Remove the front wheel axle Take note of the location of the Tighten the front wheel axle by by twisting counterclockwise parts on the front wheel and make twisting clockwise 2pcs 5mm hex 2pcs 5mm hex keys. sure all these parts are in their keys correct position when re-mounted. (The front wheel is removed in à similar way to the way the rear wheel is removed.)

Do not store the battery in an environment above 252C or below O2C. This scooter contains sealed lead-acid batteries, which shall be recycled in accordance with your local laws and regulations. Please read and understand the following instructions on disposal of the batteries. Disposal: This product contains sealed lead-acid batteries, which must be disposed of in an environmentally sound manner. Do not dispose of a lead-acid battery in tire. The battery may explode or leak. Do not dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a local, approved lead-acid battery recycler ora local seller of automotive batteries. Charger: The charger supplied with the scooter should be regularly examined far damage to the cord, plug, enclosure and other parts, and in the events of such damage the scooter must not be charged until the charger has been repaired or replaced. Wheels: Wear and tear is unavoidable in the wheels and the driving system in the course of operation. This is not a product fault. The user shall check regularly the wheels and the driving system for wearing and make adjustment or replacement when necessary.

WARNING: ff a battery leak occurs, avoid contact with the leaking acid and place the damaged battery in a

plastic bag. Refer to the disposal instructions above. If acid comes into contact with skin or eyes, wash with cool water for at least 15 minutes and contact a doctor.

TROUBLESHOOTING Problem Possible Cause Solution The scooter won't start. Power Switch is in OFF position. Battery is not charged. Wires orconnectors areloase or unplugged. Switch the Power Switch to ON. Chargethe battery fully. Chargethe batte7c for 7 hours for the very firsttime and 4 hours for subsequent charging. Dismantle the scooter and check the power connection and controller connection for any loosening. Reconnect themwhennecessary. Scooter run time is short. Battery requires charging Thebattery willnotaccept full charge Fully charge the battery. Charge the battery 7 hours forl the very firsttime and 4 hours for a subsequent charging. See that the charger plug is connected to a 230V powersupply. Makesure the walLoutletswitch is on. Battery may need] to be replaced. Even with proper care, rechargeable batteries do notlas!forever. The average rechargeable battery lite is 1to 2 years dependingonscooterconditions anduse The scooter runs very slowly. The scooter is overloaded Theriding surface is not suitable. Brakes are not adjusted correctly. Make sure the scooter is notoverloaded. This product is designed to sustain a maximum of 50kg. An excessive overload triggers off automatic protection and makes the scooter refuse to start. Do not ride uphill or use the scooterto tow any cargo. Do notoverloadthe scooter, which may cause the battery and the electronics to age prematurely and damage the power system. On ride on solid, even, clean, and dry surfaces such as sidewalks and flatground Refer to the instruction manual on adjusting brakes.

DECLARATION OF CONFORMITY

(6618)068-1008 All radio emission tests were carried out by the laboratories mentioned below: Intertek Testing Services Shenzhen Ltd. Guangzhou Branch Burea Veritas Consumer Products Services, Inc. Block E, No 7-2 Guang Dong Software Science Park, BVCPS (Shanghai) No. 368 Guangzhou Road, Zhuangiao Caipin Road,Guangzhou Science City, GETDD Guangzhou, Town, Minhang, Shanghai 201108, China China Contact details of the manufacturer or agent: PACT Informatique 33 rue du ballon 93160 Noisy le Grand — France Contact details of the person authorized to edit the technical document: Michael Barreira 33 rue du ballon 93160 Noisy le Grand - France This declaration shall be issued under the responsibility of the manufacturer and, where appropriate, of his representative 03/12/2018. Representative of the company: PACT INFORMATIQUE 33 rue du ballon - Noisy le Grand - France Maurice Bodokh CEO ND - FRAN T L ù torn pactin = 3 a c Z- TVA FR22397801 11