BOUILLOIRE - LAGRANGE - Free user manual and instructions

USER MANUAL BOUILLOIRE LAGRANGE

1.7-litre stainless steel body

Removable stainless steel cover with handle

Switch with indicator

Stainless steel and elastomer handle

Removable scaling prevention filter

10. Steam nozzle for automatic switch-off

11. Heating base (concealed element)

Description and technical characteristics

Before using the appliance

Model: Kettle ref. 359901

1. 1.7-litre stainless steel body 2. Spout 3. Removable stainless steel cover with handle 4. Stainless steel and elastomer handle 5. 360° freely-rotating base 6. Cord holder 7. Switch with indicator 8. Water level window 9. Removable scaling prevention filter 10. Steam nozzle for automatic switch-off 11. Heating base (concealed element) Pre-set thermostat. 220-240 V-1800-2200 W 50 Hz

Carefully read these user instructions and keep them so you can consult them at a later date.

• Never leave your kettle operating unattended, and do not leave it within reach of children or people who are not responsible.

• Never place your kettle on supports that are unstable, not level, flexible or fragile (oilcloth, glass, varnished wood, etc.). • Always place your kettle as far away as possible from the edge of your benchtop and adjust the cord’s length by rolling it up under the base and fastening the cord using the slot designed for this purpose. (see Figure 1). • In order to avoid any danger, do not use the appliance if it has fallen on the floor or if it shows visible signs of damage. Should this have happened, return it to the after-sales service. • Never use the kettle without the filter fitted, and do not exceed the maximum water level in order to avoid boling water splashing out of the spout (see Figures 2 and 3).

Before you use the unit each time, you must examine the power supply cable carefully. If it is damaged, you must not use the appliance. In order to avoid any danger, the cord should only be replaced by the manufacturer, its after-sales service, or a qualified person approved by the manufacturer. This appliance complies with Directives 73/23/EEC, 89/336/EEC and 93/68EEC.

• This kettle was designed solely for boiling water.

• Be careful of the steam that comes out of the spout - it is very hot. • Only use the power supply base provided with the appliance, and keep it clean and dry. • Before filling the kettle with water, remove it from its base. • Check that the cover is properly clip-fastened before using the kettle to heat water. • Never remove the cover when heating water, or so long as there is hot water inside. • Connect your appliance to a 10/16 A socket fitted with an earth contact and check that your installation complies with the standards in force and is compatible with the power and voltage levels indicated on your appliance. • Never place your kettle or its base on a gas or electric cooking plate. • Never submerge either the kettle, its base or the cord in water. • We recommend you connect the appliance to an installation that has a device with a residual differential current with a breaking current that does not exceed 30mA. • Never move your appliance while it is in operation. • Before any cleaning operation, unplug the appliance and let it completely cool down. • Do not touch the sides (other than the handle) when the kettle is operating, as they are very hot (there is a risk of being burnt). • Never use the kettle without water. • This appliance is solely for domestic use.

• When unwrapping your appliance, make sure you carefully remove all the packing. • Rinse the inside of your kettle. • Fill your kettle up to the maximum water mark, boil the water, and then empty it into the kitchen sink. • Repeat the operation twice. 2 Start-up • Remove the cover and fill the kettle with water to the desired level between the Min. and Max. marks (look at the window). • Put the cover back on by clipping it securely into place. • Place the kettle on its base. • Plug in the cord. • Press the On button and the indictor will light up. The kettle will switch off automatically when boiling temperature is reached. • Your kettle is fitted with a filter that will catch calcium particles. • Each time you use your kettle, empty it afterwards. Operation without water: If you use your kettle without any water in it, it will switch to safety mode and stop operating. Leave it to cool down for 15 minutes before using it again. Do not worry if you find a few drops of water underneath your kettle - this is the result of condensation. 7

General warranty conditions

Always unplug your kettle and let it cool down completely before cleaning it.

Never use abrasive sponges, solvents, scouring or caustic oven powder, which could seriously damage your product. • External body: clean using a damp cloth, and dry properly. • Base and cord: clean using a dry cloth. • Inside the kettle: rinse using tap water. • Filter: Leave the kettle to soak in distilled vinegar one night every month, then rinse it and put it back in place. Depending on the region where you live, the water will have a greater or lower level of calcium in it. After boiling, water can be clouded and may leave calcium deposits on the kettle’s walls; this is normal and will not disrupt operation of the appliance. You may have to remove scaling more frequently, depending on the amount of calcium. • Scaling removal: Once a month, fill your kettle with distilled vinegar diluted in water (1/3, 2/3). Leave it to act for two hours or more (cold) and then rinse several times using tap water. You can also use a scale-removing agent for coffee machines (follow the manufacturer’s instructions). Be careful not to pour water on the electrical components. Never soak your kettle or its base and cord in water.

The warranty covers any manufacturing fault or materials defect.

It does not cover: • Breakage of the appliance due to dropping it or impacts suffered by it. • Damage caused by abnormal use of the appliance or incorrectly plugging it in. This appliance is subject to a 2-year warranty (parts and labour). Appliances that have been used (even once) will not be exchanged, but they will be restored to perfect operating condition. In order to fully maintain your warranty rights, fill in section 2 of the warranty form and send it to our Warranty Service within 30 days of purchase. Carriage costs: During the warranty period, you will only have to pay for carriage costs for returning the product to the factory. We will send the product back to you at our expense as soon as possible. Please note that in the event of misuse, the warranty will be declared null and void. Professional or semi-professional use: This apparatus is not designed for such use and no warranty will be granted for it.