How do I remove a drill bit from the METABO BZ 12 SP cordless drill?

Question

Accepted Answer

To remove a drill bit from the METABO BZ 12 SP cordless drill, start by turning off the device and removing the battery to avoid any risk of accidental startup. This drill is equipped with a 1 to 10 mm keyless chuck, which allows for quick drill bit changes with one hand, without any additional tools.

The removal procedure is very simple. Hold the drill firmly with one hand. With the other hand, grasp the chuck (the cylindrical part that holds the drill bit) and turn it counterclockwise to gradually loosen it. Continue turning until the chuck is sufficiently loosened.

Once the chuck is well loosened, gently pull the drill bit forward to completely remove it from the drill. Be careful when handling the drill bit to avoid injuries from its sharp tip or edges.

If you want to install a new drill bit, insert it into the chuck, aligning its shank with the axis, then turn the chuck clockwise to tighten it securely. Make sure the drill bit is firmly held and does not move before reattaching the battery and using the drill. A good fixation of the drill bit is essential for safety and work quality.

User manual METABO Cordless drill : user manuals and guides in PDF

Models METABO Cordless drill most viewed

Other categories METABO

Recent questions about Cordless drill METABO