How to use the METZ MECABLITZ 48 AF-1 DIGITAL flash?

Q: How to use the METZ MECABLITZ 48 AF-1 DIGITAL flash?

Basic Usage Procedure Mounting on the camera Engage the flash foot into the accessory shoe of your camera Turn the knurled nut towards the body until it stops to secure the flash Installing the batteries Open the battery compartment cover (⑨) Insert 4 AA batteries or rechargeable batteries: NiCd, NiMH, alkaline or lithium (strictly observe the polarity) Close the cover Powering on and charging Turn on the main switch (①) to the On position The flash charges automatically: wait for the ready indicator (③) to light up The recycling time is approximately 3.5 seconds Selecting the operating mode Press the Mode button (②) to navigate between available modes: TTL (through-the-lens metering), Manual (M) with power settings from P 1/1 to P 1/128, HSS (high-speed sync), or Remote Slave (wireless control) The LCD screen displays the selected mode and estimated range Adjusting the zoom The motorized zoom head adjusts automatically from 24 mm to 105 mm according to your lens The flash has a wide-angle diffuser (⑧) to extend coverage up to 18 mm Taking a photo Once the flash is charged (indicator ③ lit), you can trigger your camera normally The flash will automatically sync with your shot The ok indicator (④) confirms good exposure after each shot Maintenance Clean the flash with a soft, dry cloth, without detergent Power on the device for 10 minutes every 3 months to preserve the capacitor, even if you do not use it regularly

Question

Accepted Answer

Basic Usage Procedure

Mounting on the camera

Engage the flash foot into the accessory shoe of your camera
Turn the knurled nut towards the body until it stops to secure the flash

Installing the batteries

Open the battery compartment cover (⑨)
Insert 4 AA batteries or rechargeable batteries: NiCd, NiMH, alkaline or lithium (strictly observe the polarity)
Close the cover

Powering on and charging

Turn on the main switch (①) to the On position
The flash charges automatically: wait for the ready indicator (③) to light up
The recycling time is approximately 3.5 seconds

Selecting the operating mode

Press the Mode button (②) to navigate between available modes: TTL (through-the-lens metering), Manual (M) with power settings from P 1/1 to P 1/128, HSS (high-speed sync), or Remote Slave (wireless control)
The LCD screen displays the selected mode and estimated range

Adjusting the zoom

The motorized zoom head adjusts automatically from 24 mm to 105 mm according to your lens
The flash has a wide-angle diffuser (⑧) to extend coverage up to 18 mm

Taking a photo

Once the flash is charged (indicator ③ lit), you can trigger your camera normally
The flash will automatically sync with your shot
The ok indicator (④) confirms good exposure after each shot

Maintenance

Clean the flash with a soft, dry cloth, without detergent
Power on the device for 10 minutes every 3 months to preserve the capacitor, even if you do not use it regularly

User manual METZ External Flash : user manuals and guides in PDF

Models METZ External Flash most viewed

Other categories METZ

Recent questions about External Flash METZ