Q: What type of bulb and what article number for the GORENJE DKG9330E?

The GORENJE DKG9330E hood uses LED or halogen bulbs . According to the manual, to replace the bulbs: Remove the protective glass (C) by lifting it at the notches provided for this purpose (see Fig. 7) Replace the bulb with an identical model (LED or halogen) Important: if you use halogen bulbs, do not touch them with bare hands The PDF of this manual does not specify the exact article numbers for the replacement bulbs. To obtain the exact commercial reference and order the suitable parts, we recommend contacting an authorized GORENJE dealer or the manufacturer's customer service, mentioning the model DKG9330E.

Question 1

What type of bulb and what article number for the GORENJE DKG9330E?

Accepted Answer

The GORENJE DKG9330E hood uses LED or halogen bulbs.

According to the manual, to replace the bulbs:

Remove the protective glass (C) by lifting it at the notches provided for this purpose (see Fig. 7)
Replace the bulb with an identical model (LED or halogen)
Important: if you use halogen bulbs, do not touch them with bare hands

The PDF of this manual does not specify the exact article numbers for the replacement bulbs. To obtain the exact commercial reference and order the suitable parts, we recommend contacting an authorized GORENJE dealer or the manufacturer's customer service, mentioning the model DKG9330E.

Question 2

How to install the charcoal filters on the GORENJE WHI649EB hood?

Accepted Answer

To install the circular charcoal filters on your GORENJE WHI649EB hood, first ensure that the appliance is turned off and unplugged. This hood is equipped with a recirculation version that uses active charcoal filters to neutralize unpleasant cooking odors.

The installation procedure for the filters is simple: you have two circular charcoal filters that need to be placed on either side, directly on the two grids protecting the fan blades. Once in position, turn each filter clockwise until it is securely fixed. To remove them, simply perform the same operation in reverse (counterclockwise).

Important: these active charcoal filters cannot be cleaned, washed, or regenerated. You must replace them completely, at least every 4 months. The exact duration before replacement depends on the type of cooking practiced and the regularity of cleaning the grease filter. When the grease filter (located at the front) becomes saturated, it also reduces the efficiency of the charcoal filter, hence the importance of regular maintenance.

To access the grease filter before the charcoal filters, simply pull the small spring handle. You can clean the grease filter in the machine (short program, moderate temperature) or in the dishwasher to maintain the overall efficiency of the filtration.

Question 3

How to switch the GORENJE DF 6316 BX hood to air recirculation mode?

Accepted Answer

The GORENJE DF 6316 BX hood is designed to operate in two versions: external ventilation or internal recirculation. To switch to air recirculation mode, you need to install the compatible activated charcoal filters. Here’s how to proceed:

Prerequisite: you must obtain the compatible activated charcoal filters, available from Gorenje technical service or retailers. This hood requires one filter on each side.

Installation of activated charcoal filters:

Remove the two metal grease filters (one on each side) by pulling on the spring release handles.
Attach an activated charcoal filter on each side by hanging it directly onto the hood at the designated locations (Fig. 20 of the manual).
Replace the metal grease filters over the charcoal filters.

Modification of the ventilation system: unlike the ventilation mode, the recirculation mode does not need a duct leading outside. If your hood is currently equipped with a duct attached to the connection flange (above the hood), you can remove it or completely close it off. The hood will draw air from the kitchen, filter it through the grease and charcoal filters, and then release purified air back into the room.

Important maintenance: the activated charcoal filter should be replaced approximately every 4 months, depending on how often the hood is used. Unlike the grease filter, the charcoal filter cannot be cleaned or regenerated: it must be completely changed. You will notice a decrease in efficiency after several months of use, indicating the saturation of the charcoal.

Once the filters are installed and the duct removed, simply turn on the hood. It will now operate in recirculation mode with a maximum airflow of 161 m³/h. The 3 speeds will allow you to adjust the ventilation level according to your needs.

Question 4

How to clean the GORENJE DF 6316 BX kitchen hood?

Accepted Answer

To effectively clean your GORENJE DF 6316 BX kitchen hood, follow these simple steps:

1. Unplug the hood

Before any cleaning operation, ensure that the hood is unplugged to avoid any electrical risk.

2. Remove the filters

The hood is equipped with metal or charcoal filters. Carefully remove them:

Metal filters: These filters can be washed in soapy hot water.
Charcoal filters: They are not washable and should be replaced when saturated.

3. Clean the metal filters

Soak the metal filters in hot water with a mild detergent. Let them soak for a few minutes, then gently scrub with a non-abrasive brush. Rinse thoroughly with clear water and let them dry completely before reinstalling.

4. Clean the body of the hood

Use a soft cloth or sponge soaked in a solution of warm water and mild soap to clean the exterior and interior surfaces of the hood. Avoid abrasive or corrosive products that could damage the finish.

5. Reinstall the filters

Once the filters are dry, reinstall them ensuring they are securely fixed.

6. Plug in and test the hood

Plug in the hood and check its proper functioning.

Regular cleaning ensures better performance and a longer lifespan for your GORENJE DF 6316 BX hood.

User manual GORENJE Basket : user manuals and guides in PDF

Models GORENJE Basket most viewed

Other categories GORENJE

Recent questions about Basket GORENJE