Question 1

How to install and mount the Glem Gas GHP945BK hood?

Accepted Answer

Installation of the Glem Gas GHP945BK hood - 8 essential steps:

The installation must be carried out by at least 2 people to avoid any risk of injury. Before starting, check that the electrical voltage corresponds to that indicated on the nameplate inside the hood and remove the protective plastic film from all external surfaces.

Mandatory installation distances: The hood must be installed at a minimum of 650 mm above an electric cooktop and minimum of 750 mm above a gas stove (follow the manufacturer's instructions for your stove if they require a greater distance). A distance of 750 mm is strongly recommended for better capture of cooking vapors.

Installation steps:

Attach the mounting bracket of the hood to the wall with 3 ST 5 x 45 mm screws and wall plugs (suitable for your wall type)
Align the body of the hood with the bracket and gently lower it until securely engaged in the bracket
Attach the discharge collar to the air outlet adapter
Connect an appropriate length of round duct of 150 mm to the air outlet adapter (prefer metal ducts to reduce fire risks)
Slide the decorated upper part of the chimney down by fitting it into the lower part, then position the whole assembly in the recess of the hood body
Secure the chimney mounting bracket to the wall with 2 ST 5 x 45 mm screws and wall plugs
Lift the upper part of the chimney until the holes align with the wall bracket, then tighten 2 chimney support screws
Secure the body of the hood with 2 internal screws from inside the body

Recommendations for ducts: Always use metal ducts (aluminum or steel) to comply with fire safety standards. Prefer short and straight runs to optimize suction performance up to 700 m³/h. Avoid unnecessary bends and use tape to seal joints between duct sections. The electrical connection must be made by a qualified electrician in accordance with current standards.

Filter installation: Once the hood is in place, first install the activated carbon filter by locking it until it clicks into place, then the aluminum grease filter (dishwasher safe) by aligning its tabs with the slots of the hood and pushing the latch tab down.

Question 2

What types of filters are used in the Glem Gas GHC631IX hood and how should they be maintained?

Accepted Answer

The Glem Gas GHC631IX hood is equipped with two essential types of filters that work together to ensure optimal performance: aluminum grease filters and, depending on your installation mode, activated charcoal filters.

Aluminum grease filters: These filters capture grease and particles from cooking. According to the manual, they should be cleaned regularly every two months of use, or more frequently in case of intensive cooking. Clean them with a warm detergent solution and a soft brush. These filters are washable and dishwasher-safe, which greatly facilitates their maintenance.

Activated charcoal filters: The GHC631IX hood can operate in two modes. In recirculation mode, the activated charcoal filters purify the air by neutralizing odors before releasing it back into the room. In this case, these filters need to be replaced regularly to maintain the efficiency of the purification. In exhaust mode, charcoal filters are not necessary since the air is expelled directly outside.

For optimal maintenance of your GHC631IX hood, adhere to a regular schedule: clean the grease filters at least every two months, and replace the activated charcoal filters (if you are using recirculation mode) according to the intensity of use in your kitchen. Regular maintenance ensures better filtration efficiency, more effective purification, and prolongs the lifespan of your appliance.

User manual Glem Gas Basket : user manuals and guides in PDF

Models Glem Gas Basket most viewed

Other categories Glem Gas

Recent questions about Basket Glem Gas