Question 1

How to connect a microphone to the Soundcore Rave Party 2?

Accepted Answer

To connect a microphone to the Soundcore Rave Party 2, plug it into the MIC jack located at the back of the speaker. Once the microphone is connected, you can adjust the sound quality using the two dedicated control knobs:

Gain knob - to increase or decrease the microphone volume
Reverb knob - to add reverb effects and enhance the acoustics

The microphone provided with this speaker includes built-in reverb effects, allowing you to achieve optimal audio quality for karaoke or performances.

Question 2

How to set the time on the Soundcore Wakey speaker?

Accepted Answer

To set the time on your Soundcore Wakey speaker, follow the steps below:

Turn on the speaker by pressing the power button.
Access the time setting mode by pressing the Settings button located on the top of the device. The LED display should start blinking, indicating that you are in setting mode.
Set the hours using the + or - buttons to increase or decrease the displayed hour. Make sure to select AM or PM if the 12-hour format is used.
Confirm the setting by pressing the Settings button again. The display will stop blinking and the time will be saved.

Your clock is now correctly set. If you encounter difficulties, ensure that the speaker is powered on and that you are following the steps in order.

User manual soundcore Loudspeaker : user manuals and guides in PDF

Models soundcore Loudspeaker most viewed

Other categories soundcore

Recent questions about Loudspeaker soundcore