How to insert paper into the OLYMPIA CPD 3212 S printer calculator?

Q: How to insert paper into the OLYMPIA CPD 3212 S printer calculator?

Before you begin: make sure to use an original OLYMPIA thermal paper roll with a width of 57 mm and a maximum diameter of 80 mm (reference 06.840.0200). Never use low-quality paper or a reused roll, as this could damage the printer. Steps to insert the paper: Install the roll holder: Locate the roll holder inside the paper compartment, usually above or at the back of the device. Position the roll: Place the paper roll on the roll holder so that it unwinds from the bottom . The paper should come out from underneath the roll. Turn on the calculator: Before inserting the paper, power on the device using the power switch (I/O). Guide the paper: Take the end of the paper and insert it into the rear slot marked with an arrow until it reaches the stop (the back of the slot). Advance the paper: Press the paper feed button (usually marked with an arrow) to feed the paper further into the device until it comes out of the print slot. Important points to remember: never print without paper, do not pull the paper while the printer is operating, and pay attention to markings indicating the end of the roll. When the paper is nearing its end, change the roll immediately to avoid any malfunction. If print quality decreases, also change the ink roll (reference 06.840.0134).

Question

Accepted Answer

Before you begin: make sure to use an original OLYMPIA thermal paper roll with a width of 57 mm and a maximum diameter of 80 mm (reference 06.840.0200). Never use low-quality paper or a reused roll, as this could damage the printer.

Steps to insert the paper:

Install the roll holder: Locate the roll holder inside the paper compartment, usually above or at the back of the device.
Position the roll: Place the paper roll on the roll holder so that it unwinds from the bottom. The paper should come out from underneath the roll.
Turn on the calculator: Before inserting the paper, power on the device using the power switch (I/O).
Guide the paper: Take the end of the paper and insert it into the rear slot marked with an arrow until it reaches the stop (the back of the slot).
Advance the paper: Press the paper feed button (usually marked with an arrow) to feed the paper further into the device until it comes out of the print slot.

Important points to remember: never print without paper, do not pull the paper while the printer is operating, and pay attention to markings indicating the end of the roll. When the paper is nearing its end, change the roll immediately to avoid any malfunction. If print quality decreases, also change the ink roll (reference 06.840.0134).

User manual OLYMPIA Calculator : user manuals and guides in PDF

Models OLYMPIA Calculator most viewed

Other categories OLYMPIA

Recent questions about Calculator OLYMPIA