How do I detach the blade handle from the SILVERCREST EDS SSM 600 D2 mixer housing for cleaning?

Question

Accepted Answer

To properly detach the blade handle from your SILVERCREST EDS SSM 600 D2, first ensure that the device is completely unplugged from the power outlet. This is essential for your safety, especially when handling sharp blades. Once unplugged, you can safely proceed to remove the mixing accessory.

The detachment procedure is simple: turn the motor block (motor block|2) until the alignment mark aligns with the unlocking mark located on the housing. Once correctly aligned, you can gently pull the motor block towards you to remove it from the accessory. This action unlocks the blade handle from the housing.

Before cleaning, observe the following precautions to handle the blades safely:

The blades are very sharp: always handle them with care
Use sufficiently clear water when cleaning by hand to see the blades well and avoid injury
Do not place any parts in the dishwasher

To clean the detached blade handle, you can wash it by hand with warm water and a mild detergent. Never use acidic or aggressive detergents that may damage the part. Then rinse thoroughly with clear water to remove any soap residue, and completely dry before reattaching it to the motor block.

It is recommended to clean the blade handle as soon as possible after use to prevent food residues from drying and sticking to the surface. If you regularly detach the handle for cleaning, this preventive maintenance will extend the lifespan of your device.

For reassembly, align the blade handle with the motor block and turn the motor block in the opposite direction until you feel and hear the click of the locking mechanism re-engaging.

User manual SILVERCREST Mixer : user manuals and guides in PDF

Models SILVERCREST Mixer most viewed

Other categories SILVERCREST

Recent questions about Mixer SILVERCREST