What does error code E01 mean on the SILVERCREST SWM 1400 A1 washing machine?

Q: What does error code E01 mean on the SILVERCREST SWM 1400 A1 washing machine?

The error code E01 on your SILVERCREST SWM 1400 A1 washing machine indicates a water supply issue. The machine was unable to fill the drum at the start of the wash cycle, and the digital display on the control panel shows this code. Checks to perform in this order: Water inlet tap: Fully open the cold water inlet tap (connected to the machine with the inlet hose). Check that the water flows normally and without restriction. Supply hose: Inspect the water inlet hose along its entire length. Ensure it is not kinked, crushed, twisted, or frozen. Make sure it is properly connected at both ends: to the cold water tap on one side and to the machine on the other (on the connector provided with the mechanical Aquastop valve). Water inlet filter: Turn off the water tap, then unscrew the inlet hose at the machine. Check that the small filter at the hose entry (near the Aquastop valve) is not clogged with limescale or debris. Clean it under running water if necessary, then reconnect the hose. Water pressure: Check that the water pressure in your home is normal. The machine requires a pressure between 0.1 and 1 MPa. Too low a pressure (water flowing very slowly) will prevent filling. After these checks, press the On/Off button to stop the machine, then restart the cycle. If the E01 error persists, contact Lidl customer service (www.lidl-service.com, product reference IAN 375803_2104) for technical assistance or replacement of the inlet hose and the Aquastop valve.

Question

Accepted Answer

The error code E01 on your SILVERCREST SWM 1400 A1 washing machine indicates a water supply issue. The machine was unable to fill the drum at the start of the wash cycle, and the digital display on the control panel shows this code.

Checks to perform in this order:

Water inlet tap: Fully open the cold water inlet tap (connected to the machine with the inlet hose). Check that the water flows normally and without restriction.
Supply hose: Inspect the water inlet hose along its entire length. Ensure it is not kinked, crushed, twisted, or frozen. Make sure it is properly connected at both ends: to the cold water tap on one side and to the machine on the other (on the connector provided with the mechanical Aquastop valve).
Water inlet filter: Turn off the water tap, then unscrew the inlet hose at the machine. Check that the small filter at the hose entry (near the Aquastop valve) is not clogged with limescale or debris. Clean it under running water if necessary, then reconnect the hose.
Water pressure: Check that the water pressure in your home is normal. The machine requires a pressure between 0.1 and 1 MPa. Too low a pressure (water flowing very slowly) will prevent filling.

After these checks, press the On/Off button to stop the machine, then restart the cycle. If the E01 error persists, contact Lidl customer service (www.lidl-service.com, product reference IAN 375803_2104) for technical assistance or replacement of the inlet hose and the Aquastop valve.

User manual SILVERCREST Washing machine : user manuals and guides in PDF

Models SILVERCREST Washing machine most viewed

Other categories SILVERCREST

Recent questions about Washing machine SILVERCREST