Q: How to save a program on the BEHRINGER PRO800?

Backup Procedure To save your program on the BEHRINGER PRO800 : Press the REC button - it will start blinking, confirming that the recording mode is activated Dial a two-digit number to select the save location The program is immediately saved Important: The PRO800 has 400 locations spread over 4 program banks. If you save to a position that is already used, the previous program will be overwritten. Canceling the recording As long as the REC button is blinking, you can interrupt the save by pressing any other key.

Question 1

How to navigate the UBXa MINI without a screen?

Accepted Answer

The Behringer UB-Xa MINI has no screen by design — it is a compact analog synthesizer that is fully controlled via its physical buttons, knobs, and LED indicators. This direct approach allows you to modify parameters without on-screen menus, just like classic analog synths.

Navigation is largely done via the FUNCTION BUTTON (button 3). Hold this button while pressing other controls to access secondary functions and menu options. For example, to access sequencer modes or modify global parameters (tempo range, sync polarity, MIDI channel, etc.), you hold FUNC and press the corresponding key or button. The LEDs on the keyboard keys confirm which mode is active by lighting up.

To keep track of the synth's status without a screen, rely on the built-in LEDs. The TEMPO (control 4) has an internal LED that blinks at the speed of the tempo you have set (10 to 600 BPM depending on the menu). This visual LED allows you to immediately see the rhythm of your sequencer. The MODE SELECT (control 10) lets you switch between Polyphonic, Unison, Octave, Fifth, Ring Modulation, and the LEDs on the keyboard keys confirm the active mode. Similarly, during sequencing, the keyboard LEDs indicate which steps are active in the pattern.

To program the sequencer without a screen, you rely on the keyboard keys with LEDs and dedicated buttons. Hold FUNC and the PLAY/ACTIVE button (27) and slide your finger over the white keys of the keyboard to set the number of steps in your pattern. The keyboard LEDs then indicate which steps are recorded. You can record notes that auto-quantize to the nearest step, or use the Freestyle mode (FUNC + key 35) to record in real-time without quantization.

All sound parameters—VCO, LFO, filter, envelope—are adjusted via the physical knobs that directly control them. There is no screen to display precise values, but each control corresponds to its function (FREQ for filter frequency, ATTACK for attack time, etc.). This design forces you to listen to the changes rather than read a value, encouraging creative exploration of sound.

If you need to memorize a sequence or restore factory settings, these functions unlock by pressing FUNC + certain keyboard keys at startup. An optional metronome (accessible via FUNC + key 33) helps you keep the rhythm while recording. With a bit of practice, this minimalist interface becomes intuitive and allows you to create and tweak sounds without relying on a screen.

Question 2

How to save a program on the BEHRINGER PRO800?

Accepted Answer

Backup Procedure

To save your program on the BEHRINGER PRO800:

Press the REC button - it will start blinking, confirming that the recording mode is activated
Dial a two-digit number to select the save location
The program is immediately saved

Important: The PRO800 has 400 locations spread over 4 program banks. If you save to a position that is already used, the previous program will be overwritten.

Canceling the recording

As long as the REC button is blinking, you can interrupt the save by pressing any other key.

User manual BEHRINGER Synthesizer : user manuals and guides in PDF

Models BEHRINGER Synthesizer most viewed

Other categories BEHRINGER

Recent questions about Synthesizer BEHRINGER