Q: Why does my Vileda JetClean no longer eject water onto the brush?

If your Vileda JetClean no longer ejects water , here are the checks to perform in order: 1. Check the clean water tank The tank must be filled up to the MAX line (capacity: 640 ml) The water must not exceed 40°C Ensure that the blue filling cap is tightly closed 2. Press the blue spray button The blue button located on the handle activates the water ejection system. Press it to distribute water onto the brush. LED indicators will light up to show that the system is working. Press again to stop. 3. Check the spray system cover The cover of the spray head must be properly attached Rinse this cover by hand after each use to prevent clogging 4. Clean the internal passages The water passages may be blocked by debris The suction nozzles may be clogged Thoroughly rinse the spray head under running water 5. Regular maintenance After each use, rinse the spray head cover and the microfiber roller by hand. Use the provided cleaning tray for a quick clean of the roller (150 ml of water, 60 seconds). Tip: You can also manually control the amount of sprayed water by adjusting the pressure on the blue button, allowing you to cover a larger area with a single tank fill.

Question 1

Why does my Vileda JetClean no longer eject water onto the brush?

Accepted Answer

If your Vileda JetClean no longer ejects water, here are the checks to perform in order:

1. Check the clean water tank

The tank must be filled up to the MAX line (capacity: 640 ml)
The water must not exceed 40°C
Ensure that the blue filling cap is tightly closed

2. Press the blue spray button

The blue button located on the handle activates the water ejection system. Press it to distribute water onto the brush. LED indicators will light up to show that the system is working. Press again to stop.

3. Check the spray system cover

The cover of the spray head must be properly attached
Rinse this cover by hand after each use to prevent clogging

4. Clean the internal passages

The water passages may be blocked by debris
The suction nozzles may be clogged
Thoroughly rinse the spray head under running water

5. Regular maintenance

After each use, rinse the spray head cover and the microfiber roller by hand. Use the provided cleaning tray for a quick clean of the roller (150 ml of water, 60 seconds).

Tip: You can also manually control the amount of sprayed water by adjusting the pressure on the blue button, allowing you to cover a larger area with a single tank fill.

Question 2

How to disable the cleaning schedule on the Vileda VR 201 PetPro vacuum cleaner?

Accepted Answer

To disable the cleaning schedule on your Vileda VR 201 PetPro, simply press the PLAN button for 5 seconds when the vacuum cleaner is in standby mode. This will immediately clear the saved cleaning schedule and the device will stop starting automatically at the scheduled time.

Before you begin: make sure the vacuum cleaner is in standby mode. If your robot is in sleep mode, press and hold the POWER button for a few seconds on the device body to activate it. If the vacuum cleaner is currently cleaning, pause it first before changing the schedule.

Quick procedure:

Set the vacuum cleaner to standby mode (if in doubt, press the POWER button once)
Press and hold the PLAN button for 5 seconds
The display will automatically clear and the schedule will be canceled

Important notes: The VR 201 PetPro robot can only be programmed or deprogrammed when it is in standby mode or charging on its docking station. Once the schedule is canceled, the vacuum cleaner will no longer start automatically and will operate exclusively with your manual commands. If you wish to reprogram a new schedule later, press and hold the PLAN button for 5 seconds in standby mode, then use the navigation buttons to set the desired time.

User manual Vileda Vacuum Cleaner : user manuals and guides in PDF

Models Vileda Vacuum Cleaner most viewed

Other categories Vileda

Recent questions about Vacuum Cleaner Vileda