TYMEK ZSVC622 - Vacuum Cleaner Zelmer - Free user manual and instructions

Product Type	Cylinder Vacuum Cleaner
Brand	Zelmer
Model	TYMEK ZSVC622
Colour	Black/Red
Dimensions (L x W x H)	400 x 280 x 240 mm
Weight	5.2 kg
Power Consumption	1800 W
Suction Power	350 Air Watts
Dust Capacity	2.0 L
Filtration System	HEPA H13 Washable Filter
Bagless	Yes
Noise Level	78 dB
Cable Length	6 m
Operating Radius	9 m
Attachments Included	Crevice tool, upholstery brush, combination brush
Power Cord Type	Automatic cord rewind
Dust Container Type	Cyclonic
Filter Cleaning	Washable HEPA filter
Energy Efficiency Class	A
Warranty	2 years

Frequently Asked Questions - TYMEK ZSVC622 Zelmer

How often should I clean the HEPA filter?

It is recommended to clean the HEPA filter every 3 months or when the suction power decreases. Tap the filter gently to remove dust, or wash it with cold water if it is washable. Let it dry completely before reinstalling.

How do I empty the dust container?

Press the release button to remove the dust container. Open the bottom lid over a trash bin to empty the contents. You can also remove the cyclonic unit for deeper cleaning. Make sure the container is properly locked back in place.

What should I do if the vacuum loses suction?

Check if the dust container is full, the filter is clogged, or there is a blockage in the hose or brush head. Clean the filter and empty the container. If the problem persists, inspect the hose for obstructions.

Can I use the vacuum on hardwood floors?

Yes, the vacuum is suitable for hardwood floors. Use the combination brush in floor mode or switch to the bare floor setting if available. Avoid using the rotating brush on delicate surfaces.

How do I replace the HEPA filter?

Open the filter compartment, remove the old filter, and insert a new one. Make sure it is properly seated. Use only genuine Zelmer replacement filters for optimal performance.

What attachments are included with the TYMEK ZSVC622?

The vacuum comes with a crevice tool, upholstery brush, and a combination brush that can be used for both floor and carpet.

Is the vacuum bagless or does it use bags?

The TYMEK ZSVC622 is a bagless model with a 2.0L cyclonic dust container. No bags are required.

What is the noise level of this vacuum?

The noise level is approximately 78 dB, which is typical for a mid-range cylinder vacuum cleaner.

How long is the power cord?

The power cord is 6 meters long, with an automatic rewind feature for easy storage.

Where can I find spare parts or accessories?

Spare parts and accessories are available from Zelmer authorized dealers or online. Common parts include filters, brushes, and hoses. Refer to the manual for part numbers.

USER MANUAL TYMEK ZSVC622 Zelmer

EN USER MANUAL Cordless vacuum cleaner

DE BENUTZERHANDBUCH Akku-Staubsauger

FIG. 2

FIG. 3

FIG. 4

FIG. 5

FIG. 6

FIG. 7

FIG. 8

FIG. 9

FIG. 10

FIG. 11

FIG. 12

OSTRZEŻENIE

PRZED UŻYCIEM PRODUKTU NALEŻY UWAŻNIE PRZECZYTAĆ INSTRUKCJĘ UŻYTKOWANIA. PRZECHOWUJ JĄ W BEZPIECZNYM MIEJSCU DO WYKORZYSTANIA W PRZYSZŁOŚCI

OPIS

WE WOULD LIKE TO THANK YOU FOR CHOOSING ZELMER. WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE

WARNING

PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT. STORE THESE IN A SAFE PLACE FOR FUTURE REFERENCE

DESCRIPTION

1. Cordless vacuum cleaner main unit
2. Conductive aluminum tube
3. Electrical floor brush
4. On/off button
5. Bottom cover release button
6. Removeable dust cup
7. Battery Indicator light
8. Conductive aluminum tube release button
9. Floor brush release button
10. Charge port
11. Battery pack
12. Dust cup release button
13. Adapter
14. 2 in 1 brush

SAFETY INSTRUCTIONS

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

The adaptor cable cannot be replaced.

If the cable is damaged, the adaptor will be discarded.

WARNING: For the purpose of recharging the battery, only use the detachable supply unit provided with this appliance.

This appliance contains batteries that are not replaceable.

Plug must be removed from socket-outlet before cleaning

or maintaining the appliance.

Follow the charging the product instructions in order to charge it.

Due to the plastic housing of the vacuum cleaner, keep the appliance away from all heat sources (radiators, stoves, etc.).

Do not block the vacuum cleaner inlet and outlet openings!

Turn off the vacuum cleaner before replacing equipment.

This appliance is intended for use at a maximum altitude of 2000m above sea level.

IMPORTANT WARNINGS

Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the product label.

The mains connection cable must not be tangled or wrapped around the product during use.

Do not pull on the connection cord in order to unplug it.

Do not use, connect or disconnect the device to the mains with your hands or feet wet.

Proceed according to the conservation and cleaning section of this manual for cleaning.

Unplug the product immediately from the mains in the event of any breakdown or damage and contact an authorised Technical support service.

In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from the brand's Official Technical support service may carry out repairs or procedures on the device.

Any incorrect use or improper handling of the product shall render the warranty null and void. Only an authorised technical support service centre may carry out repairs on this product.

This appliance is designed exclusively for domestic use, in no case should be a commercial or industrial use. In case of misuse or tampering with the product, it will be out of warranty.

Do not use the appliance to vacuum liquids (water, etc), sharp objects (pins, pins, nails, glass, etc), incandescent objects (matches, cigarettes).

Never use the turbobrush to: Polish floors, suck (Liquids, wet or damp dust, hot ash, burning objects, such as cigarettes, matches, sharp and hard items, such us: razors, pins, thumbtacks, pieces of glass, etc), flour, cement, plaster, printer or photocopier toner, etc.

B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for the non-observance of these warnings.

INSTRUCTION OF USE

Note:

Before using the Cordless Vacuum cleaner for the first time, clean it with a soft, damp cloth and dry thoroughly.

Do not immerse the Cordless Vacuum cleaner in water or any other liquid.

1. Remove the vacuum cleaner from the carton, remove all stickers, shipping blocks, bags, and fillers.
2. Inspect the vacuum cleaner for any damage that may have occurred in transit. Contact your dealer if you suspect damage.
3. Assemble the vacuum cleaner properly (see section: "Assembling the Vacuum Cleaner").
4. Charge the battery (see section "CHARGING THE BATTERY").
5. Make sure that your mains supply corresponds with the data on the charger's name plate.

Assembling the Cordless Vacuum cleaner

1. Assembling the aluminum tube (Rys.1)
   Fit the tube into the main body's air inlet until it clicks into position.
   If need to remove the tube, hold the main body, press the release knob and remove the tube
2. Assembling the electrical floor brush (Rys.2)
   Fit the electrical floor brush onto the tube until it click into the position.

If need to remove the electrical floor brush, hold the aluminum tube, press the floor brush release knob and remove the brush from the tube.

1. Assembling the 2 in 1 brush (Rys.3)

Fit the accessory on the main body's air inlet and/or on the tube until it clicks into position.

The 2 in 1 brush is good for cleaning stairs, corners.

Operating the Cordless Vacuum cleaner

Before first time use, ensure the vacuum cleaner has been charged 4-4.5 hours.

Turn on the Cordless vacuum cleaner by pressing the ON/OFF button.

Press the "Power" button sequentially to obtain a change in the vacuum cleaner speed.

The appropriate vacuum cleaner speed will be indicated by the corresponding "MIN" or "MAX" indicator light

Note: Battery indicator light represents battery capacity and will illuminate during use. The indicator light will turn off one by one as the battery runs out.

To turn off the vacuum cleaner press the "ON/OFF" button again

Warning: Do not use the Cordless Vacuum without the removable filter or dust bin in position.

Charging product (Rys.4; *-charge port)

1. Turn off the Cordless vacuum cleaner.
2. Connect the adapter to the charge port on the main unit.
3. Plug the adapter into the main power supply.
   The battery indicator display light (Rys.5; *-battery indicator lights) will flash in a ring. Once the battery is fully charged, the battery indicator lights indicated by the battery are always bright in a ring.

Warning: Do not use any main power adaptor other than that supplied, as using an alternative will increase the risk of injury and/or damage to main product.

CARE AND MAINTENANCE

Filter replacement and cleaning

1. Turn off the Cordless vacuum cleaner
2. Press and hold the dust cup release button and rotate the dust cup at a clockwise angle of 30° , then remove the whole dust cup. (Rys.6; *-dust cup release button)
3. How to clean the dust cup

Without removing the dust cup □Press the dust cup release button directly, Then drop the dust into waste container.(Rys.7; fig. A)

Or you can remove the dust cup and Press the dust cup release button directly, Then drop the dust into waste container.(Rys.7; fig. B)

1. Remove filter assembly: Filter, Hepa, Dust cup (Rys.8)

2. Cleaning the filter/hepa in water, wait for it to dry completely (Rys.9).

3. Put the filter/hepa back into the dust cup carefully (Rys.10). (

4. Put the dust cup back into the main body: Dust cup counterclockwise rotation into the slot, hear the sound of "ka", that means the dust cup installed in place (Rys.11).

Rotating brush cleaning

1. Turn the brush bottom screw to unlock position (Rys.12)
2. Open the brush bottom fixed device.
3. Show brush, clean the rotating brush on the twisting thing.
4. Put the rotating brush back.
5. Turn the brush bottom screw to lock position

TROUBLE SHOOTING GUIDE

PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
HAND VACUUM WILL NOT OPERATE	1. no power in electrical outlet supplying transformer2. unit needs servicing	1. check fuse or breaker.Replace fuse/reset breaker.
HAND VACUUM WILL NOT PICK-UP OR SUCTION POWER IS WEAK	1.Dust cup is full.2.Dust cup filter needs cleaning.	1.Empty dust cup.Remove dust cup filter and check for object(s) in air duct and remove.
DUST ESCAPING FROM HAND VACUUM	1.Dust cup is full.2.Dust cup filter is not installed correctly.3. Puncture/hole in dust cup filter.	1.Empty dust cup .2. Review dust cup filter instruction.3. Replace dust cup filter.
HAND VACUUM BRUSHES WILL NOT PICK-UP	1.Dust cup is full. 1.Empty and clean dust cup container.

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal framework applicable in the European Union for the disposal and reuse of waste electronic and electrical devices. Do not dispose of this product in the bin, instead going to the electrical and electronic waste collection centre closest to your home.

The product may contain batteries. Remove them before disposing of the product and dispose in special containers approved for this purpose.

DANKE FÜR IHRE WAHL DER MARKE ZELMER. WIR WÜNSCHEN IHNEN GENUSS, DAS GERÄT ZU BENUTZEN

WARNUNG

ELIMINAREA PRODUSULUI

B&B TRENDS, S.L. guarantees compliance of this product for the use for which it is intended for a period of two years. In the case of breakdown during the term of this warranty, users are entitled to repair or else the replacement of the product at no charge if the former is unavailable, unless one of these options proves impossible to fulfill or is disproportionate. In this case, you can then opt for a reduction in price or cancellation of the sale, which must be dealt with directly with the sales vendor. This also covers replacement of spare parts provided that the product has been used according to the recommendations specified in this manual for both cases, and has not been tampered with by any third party that is not authorised by B&B TRENDS, S.L. The warranty will not cover any parts subject to wear and tear. This warranty does not affect your rights as a consumer in accordance with the provisions in Directive 1999/44/EC for member states of the European Union.

USE OF WARRANTY

Customers must contact a B&B TRENDS, S.L. authorised Technical Service for repair of the product. Since any tampering of the same by anyone not authorised by B&B TRENDS, S.L., or the careless or improper use of the same shall render this warranty null and void. The warranty must be fully completed and delivered along with the receipt or delivery docket for the effective exercise of rights under this warranty.

This warranty should be retained by the user as well as the invoice, receipt or the delivery docket to facilitate the exercise of these rights. For technical service and after-sales care outside the Polish territory, please submit your query to the point of sale where you purchased the item or check for further aftersales information at www.zelmer.com