IAN 292066 - Lamp Livarno Lux - Free user manual and instructions

Product Type	LED Solar Lights
Brand	Livarno Lux
Model	IAN 292066
Power Source	Solar panel and rechargeable battery
Rechargeable Battery	1 x Ni-MH AAA 1.2V 150mAh
Light Source	1 x LED (non-replaceable)
Rated Power per LED	approx. 0.06 W
Protection Rating	IP44 (splash proof)
Lighting Duration	approx. 8 hours (fully charged)
Solar Cell Dimensions	approx. 30 x 30 mm
Operating Voltage	1.2 V DC
Suitable Temperature	down to -21°C
Intended Use	Outdoor use, not for household room illumination
Scope of Delivery	5 lamp heads, 5 lamp shades, 5 poles, 5 ground stakes, 1 assembly instruction
Battery Replacement Interval	every 12 months
Switch	ON/OFF switch
Operation	Automatic dusk-to-dawn
Maintenance	Clean with dry, lint-free cloth; avoid harsh cleaners
Safety	Keep out of reach of children; do not short-circuit battery
Disposal	Recycle according to local regulations; do not dispose with household waste
Warranty	3 years (subject to conditions)

Frequently Asked Questions - IAN 292066 Livarno Lux

How do I install the solar light?

Rotate the solar cell housing anticlockwise out of the lamp shade, move the ON/OFF switch to ON, insert the housing back and tighten clockwise. Place the light on the pole, insert the ground stake into the pole with tip downward, then push the assembled product into the ground until stable. Avoid using force or hammer blows.

How do I replace the rechargeable battery?

Separate the solar cell housing from the lamp shade by turning anticlockwise. Switch off the light. Loosen the fastening screws with a small cross-head screwdriver, then lever out the battery compartment lid with a slot screwdriver. Turn over the lid carefully, replace the old battery with a new one of the same type (Ni-MH AAA 1.2V 150mAh), ensuring correct polarity. Reassemble in reverse order and set the switch to ON.

Why isn't my light turning on?

Possible causes: artificial light sources (e.g., street lighting) interfering, rechargeable battery is dead or insufficient sunlight. Relocate the product away from other light sources, or place it where it receives more direct sunlight. If the battery is old, replace it.

How long does it take to fully charge the battery?

Charging time depends on sunlight intensity and angle. For best results, position the solar cell perpendicular to the sunlight. The battery reaches maximum capacity after several charge/discharge cycles.

How long will the light stay on after a full charge?

The lighting duration is approximately 8 hours when the battery is fully charged, depending on sunlight conditions and temperature.

Can I use the light indoors?

No, the product is intended for outdoor use only. It is not suitable for household room illumination.

What should I do with the light in winter?

If not using for a long time (e.g., winter), clean the product and store it in a dry, warm room. Cold temperatures reduce battery performance. Also, keep the solar cell free of snow and ice.

Is the LED replaceable?

No, the LED is not replaceable. If the LED fails, the entire product must be replaced.

How do I clean the solar panel?

Clean the solar cell regularly with a dry, lint-free cloth. For stubborn dirt, use a slightly dampened cloth. Ensure the solar cell is free of dirt, snow, and ice to maintain performance.

What type of battery should I use for replacement?

Use the same type: Ni-MH rechargeable battery AAA 1.2V 150mAh. Ensure correct polarity when inserting.

USER MANUAL IAN 292066 Livarno Lux

Operation and Safety Notes

HR

LED SOLARNE SVJETILJKE

GB / CY Operation and Safety Notes Page 5

HR Upute za posluživanje i za Vašu sigurnost Stranica 13

Description of parts and features......Page 6

Scope of delivery....Page 6

Technical data...... Page 7

Safety instructions......Page 7

Product-specific safety instructions ...... Page 7

Safety instructions for batteries /

rechargeable batteries...... Page 8

Functioning......Page 9

Preparing for use Page 9

Installing the product...... Page 9

Setting up the product...... Page 9

Replacing the rechargeable battery....Page 10

Charging the rechargeable battery......Page 10

Maintenance and care Page 10

Troubleshooting Page 11

Disposal Page 11

Warranty Page 12

LED Solar Lights

- Introduction

We congratulate you on the purchase of your new product. You have chosen a high quality product. The instructions for use are part of the product. They contain important information concerning safety, use and disposal. Before using the product, please familiarise yourself with all of the safety information and instructions for use. Only use the product as described and for the specified applications. If you pass the product on to anyone else, please ensure that you also pass on all the documentation with it.

- Proper use

The product is intended for outdoor use. The product is not intended for commercial use or for use in other applications.

■ Not suitable for household room illumination.

This product is suitable for extreme temperature up to -21°C.

• Description of parts and features

1 Solar cell housing
2 Lamp shade
3 Pole
4 Ground stake

5 ON/OFF switch
6 Fastening screws
7 Battery compartment lid
8 Rechargeable battery

- Scope of delivery

5 Lamp heads with solar cell, LED and rechargeable battery
5 Lamp shades
5 Poles
5 Ground stakes
1 Assembly instruction

- Technical data

Operating voltage: 1.2V (direct current)

Rechargeable battery: 1 x Ni-MH rechargeable battery /

$$ \mathrm{AAA} / 1. 2 \mathrm{V} = - (\text { direct current }) / $$

$$ 1 5 0 \mathrm{mAh} $$

Bulb: 1 x LED (not replaceable)

Rated power LED: approx. 0.06 W per LED

Degree of protection: IP44 (splash proof)

Solar cell: approx. 30 x 30 mm (L x W)

Lighting Duration

(with full charge): approx. 8 hours

Safety instructions

YOU SHOULD STORE ALL SAFETY INFORMATION AND INSTRUCTIONS IN A SAFE PLACE IN CASE YOU NEED TO REFER TO THEM AGAIN IN THE FUTURE!

This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children shall not play with the product. Cleaning and user maintenance shall not be made by children without supervision.
- Do not use the product if you detect any kind of damage.
■ The illuminant is not replaceable.
If the illuminant fails at end of its life, the entire product must be replaced.

Product-specific safety instructions

■ Make sure that the solar cell is free of dirt and free of snow and ice in winter. Otherwise the performance of the solar cell will diminish.
- Cold temperatures have a negative influence on the operating life of the rechargeable battery. If the product is not going to be used for a long time, e.g. in winter, it should be taken up, cleaned and stored in a dry, warm room.

Safety instructions for batteries / rechargeable batteries

■ DANGER TO LIFE! Keep batteries/rechargeable batteries out of reach of children. If accidentally swallowed seek immediate medical attention.
DANGER OF EXPLOSION! Never

recharge non-rechargeable batteries. Do not short-circuit batteries/rechargeable batteries and / or open them. Overheating, fire or bursting can be the result.

• Never throw batteries / rechargeable batteries into fire or water.
  Do not exert mechanical loads to batteries / rechargeable batteries.

Risk of batteries / rechargeable batteries leakage

• Avoid extreme environmental conditions and temperatures, which could affect batteries / rechargeable batteries, e.g. radiators / direct sunlight.
  If batteries / rechargeable batteries have leaked, avoid contact with skin, eyes and mucous membranes with the chemicals! Flush immediately the affected areas with fresh water and seek medical attention!

WEAR PROTECTIVE GLOVES! Leaked or

damaged batteries/rechargeable batteries can cause burns on contact with the skin. Wear suitable protective gloves at all times if such an event occurs.

In the event of a leakage of batteries / rechargeable batteries, immediately remove them from the product to prevent damage.
Only use the same type of batteries / rechargeable batteries. Do not mix used and new batteries / rechargeable batteries.
■ Remove batteries / rechargeable batteries if the product will not be used for a longer period.

Risk of damage of the product

■ Only use the specified type of battery / rechargeable battery!
Insert batteries / rechargeable batteries according to polarity marks (+) and (-) on the battery / rechargeable battery and the product.
- Clean the contacts on the battery / rechargeable battery and in the battery compartment before inserting!
■ Remove exhausted batteries / rechargeable batteries from the product immediately.

Functioning

The solar cell installed in the product converts sunlight into electrical energy and stores it in 1 Ni-MH battery. Switches on the light as it begins to get dark. The in-built light-emitting diodes are a very long-life and energy-saving light source. The light duration depends on the amount of sunlight, the angle of light on the solar cell and the temperature (the battery capacity is temperature-dependent). A vertical angle of light at temperatures above the freezing point is ideal. The battery does not achieve maximum capacity until after several charge and discharge cycles.

● Preparing for use

• Installing the product

Install the product in accordance with Figures A, C, D:

1. Rotate the solar cell housing 1 anticlockwise out of the lamp shade 2 (see Fig. A).
2. Move the ON / OFF switch 5 into the ON position to switch the light on.
3. Insert the solar cell housing 1 into the lamp shade 2 and tighten by turning it clockwise.
4. Place the light on to the pole 3.
5. Take out the ground stake 4 from the pole 3 and insert it into the pole 3 with the tip facing downwards (see Fig. C).
6. Your product is ready for use (see Fig. D).

- Setting up the product

☐ Insert the assembled product far enough into the ground (lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all times. Do not use any force when assembling or setting-up the product, e.g. hammer blows. This will damage the product. In order to achieve the best result, set the product up in a place where the solar cell will get direct sunlight for as long as possible.
☐ Make sure that the solar cell is not influenced by any other source of light such as yard or street lighting as otherwise the light will not come on in twilight.
☐ The light automatically switches on in twilight conditions and off again when normal outdoor lighting conditions return.

● Replacing the rechargeable battery

The battery should be replaced every 12 months to ensure optimum performance.

1. Separate the solar cell housing 1 from the lamp shade 2 by moving it anti-clockwise (see Fig. A). Switch off the light with the ON-/OFF-switch 5.
2. Loosen the fastening screws 6 by using a small cross head screwdriver and then lever out the battery compartment lid 7 of the solar cell housing 1 with the help of a slot screwdriver (see Fig. B).
3. Turn over the battery compartment lid 7, take care not to damage the cables and cable connections (see Fig. B).
4. Exchange the old rechargeable battery 8 to a new one. Take care to the correct polarity, when inserting the new rechargeable battery. The polarity is indicated in the battery compartment. The new rechargeable battery has to have the same technical data like the old one.
5. Now again fasten the battery compartment lid 7, fasten the fastening screws 6 by using a small cross head screw-driver. Slide the On / Off switch 5 to the position ON.
6. Connect the solar cell housing 1 again to the lamp shade 2 and then connect every part of the product to each other (see Fig. C).

● Charging the rechargeable battery

Note that the product must be switched on when the battery is charging.

The charging time of the battery when the solar cell is used depends on the intensity of the sunlight and the angle of incidence of the light on the solar cell. Place the solar cell as perpendicular as possible to the angle of incidence of the light. In this way you will receive the highest light levels.

● Maintenance and care

The light-emitting diodes cannot be replaced. The product is maintenance-free, except for any necessary change of battery.

☐ Clean the product regularly with a dry, lint-free cloth. Use a slightly dampened cloth to remove more stubborn dirt.

- Troubleshooting

Note: This product has delicate electronic components. This means that if it is placed near an object that transmits radio signals, it could cause interference. If you notice that the product is malfunctioning, remove any sources of interference from the area of the product.

Note: Electrostatic discharges may cause product to malfunction. In the event of such malfunctions, remove the batteries briefly and reinsert them.

Error Cause Solution
The light will not switch on even though the sun shone on the product all day.	Artificial sources of light, e.g. street lighting, are interfering with the product.	Mount the product in a place where it cannot be disturbed by other sources of light.
The light does not come on or comes on only briefly.	The rechargeable battery is broken or there was not enough daylight.	Replace the rechargeable battery or mount the product in a place where it can receive more sunlight.

●Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Observe the marking of the packaging materials for waste separation, which are marked with abbreviations (a) and numbers (b) with following meaning: 1–7: plastics / 20–22: paper and fibreboard / 80–98: composite materials.

The product and packaging materials are recyclable, dispose of it separately for better waste treatment. The Triman logo is valid in France only.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

To help protect the environment, please dispose of the product properly when it has reached the end of its useful life and not in the household waste. Information on collection points and their opening hours can be obtained from your local authority.

Faulty or used batteries / rechargeable batteries must be recycled in accordance with Directive 2006/66/EC and its amendments. Please return the batteries / rechargeable batteries and / or the product to the available collection points.

Environmental damage through incorrect disposal of the batteries / rechargeable batteries!

Batteries / rechargeable batteries may not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are subject to hazardous waste treatment rules and regulations. The chemical symbols for heavy metals are as follows: Cd = cadmium, Hg = mercury, Pb = lead. That is why you should dispose of used batteries / rechargeable batteries at a local collection point.

- Warranty

The product has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of product defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.

The warranty for this product is 3 years from the date of purchase. Should this product show any fault in materials or manufacture within 3 years from the date of purchase, we will repair or replace it - at our choice - free of charge to you.

The warranty period begins on the date of purchase. Please keep the original sales receipt in a safe location. This document is required as your proof of purchase. This warranty becomes void if the product has been damaged, or used or maintained improperly.

The warranty applies to defects in material or manufacture. This warranty does not cover product parts subject to normal wear, thus possibly considered consumables (e.g. batteries) or for damage to fragile parts, e.g. switches, rechargeable batteries or glass parts.

CE IP44

Uvod....Stranica 14

Namjenska uporaba....Stranica 14