Q: Why does the light only turn on when it detects motion at night?

You are currently in Mode 2 . The Livarno Lux 1020B offers three distinct operating modes (selectable via the light switch): Mode 1: Continuous low light at night + maximum power increase upon motion detection for 15 seconds. Mode 2: Off at night - the light only turns on at full power upon motion detection (as you described), then turns off 15 seconds later. Mode 3: Continuous low light without motion detector. If you prefer permanent lighting at night, switch to Mode 1 or Mode 3 via the light switch. Motion detector: Maximum range 10m, angle 120°. Ensure it is not disturbed by urban lighting (streetlights, etc.) that could affect its operation.

Q: How to replace the LED modules of the luminaire?

The LED modules of this luminaire are not replaceable. Your Livarno Lux lamp IAN 285602 is equipped with 2 LED modules of approximately 5 Watts each, but they form a permanent and integral component of the product. According to the technical specifications, the luminaire has an approximate lifespan of 25,000 hours. When this limit is reached and the lighting stops functioning properly, you must replace the entire luminaire rather than just the LED module. For regular maintenance, you can clean the lamp with a dry, lint-free cloth to maintain its luminous efficiency. Never use water or solvents.

Q: How to replace the power adapter of the diffuser LADG 12 A1?

For your Livarno Lux LADG 12 A1 diffuser, the original power adapter has the reference SL-XQH-2400500ES . If you need to replace it, you will need an adapter with the exact following specifications: Input Voltage: 100-240V AC, 50/60 Hz (universal compatible) Output Voltage: 24V DC Current: 0.5A (total power: 12W) Connector Polarity: positive inside, negative outside The manufacturer specifies in the manual that if the adapter is defective, it must be completely replaced with an identical model - it cannot be repaired. You can look for a 24V 0.5A 12W adapter with the correct polarity from specialized spare parts retailers (Spareka, FixPart) or large online marketplaces. When purchasing, make sure that all these characteristics are mentioned.

Question 1

What do the LED indicators mean during charging?

Accepted Answer

The Livarno Lux flashlight IAN 283392 has LED indicators that inform you of the battery status during charging:

Flashing red light: Charging is in progress. The LED indicator on the car charger flashes red while the battery is recharging.
Flashing green light: The battery is fully charged and ready for use. The LED indicator located under the micro-USB port flashes green once charging is complete.

This simple color code system allows you to monitor the charging status without needing to constantly check the device.

Question 2

What should I do if the power cord of the lamp is damaged or cut?

Accepted Answer

You must not attempt to repair the damaged power cord yourself. For obvious safety reasons, the manual for this Livarno Lux lamp IAN 396691 clearly states that the replacement of a damaged flexible cord is exclusively reserved for the manufacturer, their after-sales representative, or a comparable specialist.

Here’s what you should do immediately:

Stop using the lamp - Do not plug the 230V-240V ~ 50Hz transformer into the power outlet
Do not attempt to repair the wire - You risk serious electrocution (risk of death)
Contact customer service - Reach out to the retailer or manufacturer with your reference IAN 396691
Request a replacement cord - Only a qualified professional can perform this operation while adhering to safety standards

Reminder: your lamp comes with a 36-month warranty. Unauthorized repair attempts may void this warranty and create serious electrical hazards.

Question 3

Does the Livarno Lux HG01768D parasol protect against UV rays?

Accepted Answer

Yes, the Livarno Lux HG01768D parasol protects against direct UV rays.

However, it is important to note a significant limitation: the parasol protects your skin from direct UV rays, but not from reflected UV rays (those reflected by water, sand, light surfaces, etc.).

For optimal protection, the manufacturer recommends using a cosmetic sunscreen in addition to the parasol, even when you are protected under it.

Question 4

Why does the light only turn on when it detects motion at night?

Accepted Answer

You are currently in Mode 2. The Livarno Lux 1020B offers three distinct operating modes (selectable via the light switch):

Mode 1: Continuous low light at night + maximum power increase upon motion detection for 15 seconds.
Mode 2: Off at night - the light only turns on at full power upon motion detection (as you described), then turns off 15 seconds later.
Mode 3: Continuous low light without motion detector.

If you prefer permanent lighting at night, switch to Mode 1 or Mode 3 via the light switch.

Motion detector: Maximum range 10m, angle 120°. Ensure it is not disturbed by urban lighting (streetlights, etc.) that could affect its operation.

Question 5

How to replace the LED modules of the luminaire?

Accepted Answer

The LED modules of this luminaire are not replaceable. Your Livarno Lux lamp IAN 285602 is equipped with 2 LED modules of approximately 5 Watts each, but they form a permanent and integral component of the product.

According to the technical specifications, the luminaire has an approximate lifespan of 25,000 hours. When this limit is reached and the lighting stops functioning properly, you must replace the entire luminaire rather than just the LED module.

For regular maintenance, you can clean the lamp with a dry, lint-free cloth to maintain its luminous efficiency. Never use water or solvents.

Question 6

How to replace the power adapter of the diffuser LADG 12 A1?

Accepted Answer

For your Livarno Lux LADG 12 A1 diffuser, the original power adapter has the reference SL-XQH-2400500ES. If you need to replace it, you will need an adapter with the exact following specifications:

Input Voltage: 100-240V AC, 50/60 Hz (universal compatible)
Output Voltage: 24V DC
Current: 0.5A (total power: 12W)
Connector Polarity: positive inside, negative outside

The manufacturer specifies in the manual that if the adapter is defective, it must be completely replaced with an identical model - it cannot be repaired. You can look for a 24V 0.5A 12W adapter with the correct polarity from specialized spare parts retailers (Spareka, FixPart) or large online marketplaces. When purchasing, make sure that all these characteristics are mentioned.

Question 7

Why is the LADG 12 A1 diffuser flashing red?

Accepted Answer

A red flash on the LADG 12 A1 indicates that the water tank is empty. The device has an automatic shut-off feature that triggers this warning light when there is a lack of water.

What to do:

Turn off the diffuser and unplug it from the power source
Fill the water tank with tap water (between 20 and 100 ml, up to the MAX line marked)
Add 2 to 4 drops of essential oil if desired
Replace the lid and cover
Plug it back in and press the power button

Is the red still flashing after filling? The ceramic disc (ultrasonic membrane) may be clogged or scaled. Gently clean it with a damp cotton swab, possibly with a bit of commercial descaler. Never use a sharp object.

Important: Never use the diffuser with an empty tank, and change the water every 3 days to prevent the proliferation of microorganisms.

Question 8

What is the diameter of the pole of the Livarno Lux HG01768D parasol?

Accepted Answer

The exact diameter of the pole of the Livarno Lux HG01768D parasol is not specified in the manual or in the available public technical sheets.

However, for this type of parasol, the diameter of the tubes is generally between 32 and 38 mm.

How to obtain the precise measurement:

Direct measurement: If you have the parasol, use a digital caliper to measure the outer diameter of the pole.
Contact manufacturer: You can contact OWIM GmbH & Co. KG, the manufacturer, to request the exact dimensions.
Customer service: If you purchased the parasol from Lidl, their customer service may sometimes provide this information.

These options will allow you to obtain an accurate measurement if necessary for accessories or spare parts.

Question 9

Where can I buy a power connector compatible with the Livarno Lux HG09583B?

Accepted Answer

To purchase a power connector compatible with your Livarno Lux device model HG09583B, here are several options to consider:

Specialty stores: Visit electronics or DIY stores that offer spare parts and accessories. They may have compatible connectors or direct you to a suitable supplier.
Online sales sites: Check platforms like Amazon, eBay, or other sites specializing in electronic spare parts. Search by specifying your device model or looking for a compatible universal power connector.
Spare parts retailers: Some websites specialize in selling parts for household and electronic devices. They may offer connectors suitable for your model.
Livarno Lux customer service: Contact Livarno Lux's after-sales service directly for precise information on original spare parts and official sales points.

By following these leads, you should be able to find a suitable power connector for your device.

User manual Livarno Lux : user manuals and guides in PDF

Models Livarno Lux most viewed

Browse manuals Livarno Lux by appliance type

Recent questions about devices Livarno Lux