QFC60700X - Range hood Husqvarna-Electrolux - Free user manual and instructions

Brand	Husqvarna-Electrolux
Model	QFC60700X
Product Type	Range Hood (Extractor Hood)
Suction Speeds	Low, Medium, High, Intensive (timed 5 minutes)
Control Panel	Touch or button controls for motor, speeds, light, filter reset
Lighting	LED lighting, energy saving (up to 90% less energy)
Grease Filter	Washable, clean monthly (hand or dishwasher at low temp)
Charcoal Filter (Type 20)	Washable long-life, wash every 2 months, replace mattress every 3 years
Charcoal Filter (Type 15)	Non-washable, replace every 4 months
Filter Reset Indicator	Grease filter after 40 hours, carbon filter after 160 hours
Power Supply	220-240 V / 50 Hz (typical, see rating plate)
Minimum Installation Height	50 cm above electric hobs, 65 cm above gas or mixed hobs
Operation Modes	External evacuation or recirculation (with charcoal filter)
Safety Features	Double-pole switch disconnect, overload protection, thermal protection
Maintenance Required	Clean hood interior and exterior monthly, check filters
Environmental Compliance	WEEE directive, recyclable materials
Accessories	Ducting kit (not included), charcoal filter (depending on version)
Country of Origin	Not specified, likely EU
Warranty	Contact local service center for details

Frequently Asked Questions - QFC60700X Husqvarna-Electrolux

How do I install the range hood?

Installation must be done by a qualified technician. Ensure the minimum distance from hob: 50 cm for electric, 65 cm for gas. Connect to mains with a double-pole switch. Refer to the installation manual for ducting or recirculation setup.

How often should I clean the grease filter?

Clean the grease filter once a month using non-aggressive detergents. You can wash it by hand or in a dishwasher at low temperature and short cycle. Discoloration is normal and does not affect performance.

What is the difference between Type 15 and Type 20 charcoal filters?

Type 20 is a washable long-life filter that can be cleaned every 2 months with hot water or in dishwasher at 65°C; the mattress should be replaced every 3 years. Type 15 is non-washable and must be replaced every 4 months.

How do I reset the filter indicator?

After cleaning or replacing filters, reset the indicator by pressing the filter reset key while the hood is switched off. The symbol will light up or flash for 3 seconds to confirm.

What should I do if the hood does not work?

First, disconnect the hood from the mains for 5 seconds, then reconnect. If it still fails, check the fuse or circuit breaker. If problem persists, contact the Technical Service. Do not attempt to repair yourself.

Can I use the hood without a charcoal filter?

If the hood is installed in recirculation mode, a charcoal filter is mandatory to absorb odors. In extraction mode (ducted outside), no charcoal filter is needed. Always follow the installation manual.

How do I replace the LED lights?

The hood uses LED lighting which should be replaced only by authorized service personnel. Do not attempt to replace LEDs yourself; contact Technical Service.

What is the intensive speed function?

Press the high-speed key again to activate intensive mode. It runs for 5 minutes at maximum power, then automatically returns to medium speed. Use it for concentrated kitchen vapors.

How do I clean the exterior of the hood?

Use a cloth dampened with neutral liquid detergent. Do not use abrasive products or alcohol. Clean regularly (at least once a month) to prevent fire risk.

Where can I buy spare parts or accessories?

Original spare parts and accessories are available at www.husqvarna-electrolux.se/shop or through authorized service centers. Always use original parts for safety and performance.

USER MANUAL QFC60700X Husqvarna-Electrolux

Modern kitchen interior with stainless steel appliances and large windows in the background (no visible text or symbols)

BÄSTA KUND FÖR PERFEKT RESULTAT

Illustration of a hand using a tool to cut or adjust a mechanical component (no text or symbols visible)

4.2 Aktivt kolfilter

www.husqvarna-electrolux.se/shop

MILJ∅VERN

Illustration of a hand using a tool to cut or adjust a mechanical component (no text or symbols visible)

Illustration of a hand using a tool to cut or adjust a mechanical component (no text or symbols visible)

4.2 Hillisuodatin

MOOTTORIN OFF painike

www.husqvarna-electrolux.se/shop

MILJ∅HENSYN

Illustration of a hand using a tool to adjust or install a mechanical component (no text or symbols visible)

Thank you for choosing this Husqvarna-Electrolux product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.

Visit our website to:

Get usage advice, brochures, trouble shooter, service information: www.husqvarna-electrolux.se

Register your product for better service: www.husqvarna-electrolux.se

Buy Accessories, Consumables and Original spare parts for your appliance: www.husqvarna-electrolux.se/shop

ENVIRONMENT CONCERNS

Recycle the materials with the symbol. Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.

CUSTOMER CARE AND SERVICE

We recommend the use of original spare parts.

When contacting Service, ensure that you have the following data available.

The information can be found on the rating plate. Model, PNC, Serial Number.

Warning / Caution-Safety information.

General information and tips

Environmental information.

Subject to change without notice.

SAFETY INSTRUCTIONS

Caution! Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The extractor hood has been designed exclusively for domestic use.

Caution! Do not connect the appliance to the mains until the installation is fully complete. Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply.

Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating! The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is stalled must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite.

Caution! Accessible parts of the hood may become hot when used with cooking appliance.

With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual.

Warning! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

2. USE

The hood serves to aspirate the fumes and vapors resulting from cooking.

The attached installation manual indicates the version to be used depending on the model you have, the suction version with

external evacuation of filtering with

internal recirculation

iltering with

3. INSTALLATION

The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.

The hood is provided with a special power cable; if the cable is damaged, request a new one from Technical Service. The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.

4. MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

Warning! Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

4.1 Grease filter - The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.

Illustration of a hand using a tool to cut or adjust a mechanical component (no text or symbols visible)

4.2 Charcoal fi Iter

Type 20 LONG LIFE - Washable activated charcoal fi Iter

The charcoal fi Iter can be washed once every two months using hot water and a suitable detergent, or in a dishwasher at 65°C (if the dishwasher is used, select the full cycle function and leave dishes out).

Eliminate excess water without damaging the fi Iter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100^ to dry completely. Replace the mattress every 3 years and when the cloth is damaged.

Type 15 - NON-washable activated charcoal fi Iter

The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every four mounths.

The charcoal fi Iter may NOT be washed or regenerated.

5. CONTROLS

The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

The control switches are located on the hood's front panel:

1 Motor key OFF (stand by) – Excludes the electronics MOTOR OFF

Press briefly to switch the motor off. EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood command electronics will be excluded. This function can be useful during the product cleaning operations. Just repeat the operation to reinsert the electronics.

2 Low-speed selection key (suction power)

3 Medium-speed selection key (suction power) power);

4 High-speed selection key (suction power);

press again to activate the intensive timed function - duration 5 minutes (the hood will automatically go back to the medium extraction power)

5 RESET FILTERS SIGNALS - ON function:

press the key while the hood is switched off; the symbol lights up for 3 seconds to confirm the activation;

- OFF function:

press the key while the hood is switched on; the symbol flashes for 3 seconds to confirm the disabling;

After 40 hours of use, the symbol lights up, indicating that the grease filter

needs washing;

After 160 hours of use, the symbol flashes, indicating that the carbon filter needs replacing.

In both cases the indication lasts 60 seconds after the hood has been switched off; to reset the indicator and restart the count, press the key while the hood is switched off.

6 Light key ON/OFF

Attention! If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service.

6. LIGHTING

The hood is equipped with a lighting system based on LED technology.

The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.

Caution! Do not look directly into the LED light.

For replacement, contact the technical service.

www.husqvarna-electrolux.se/shop

CE