HSA701 - Hair straighteners BLAUPUNKT - Free user manual and instructions

Product Type	Automatic Hair Curler
Model	HSA701
Brand	Blaupunkt
Power Supply	100-240 V ~ 50/60 Hz
Power Consumption	30 W
Temperature Range	140 °C - 230 °C (default 190 °C)
Cycle Time	5 - 12 seconds (default 5 seconds)
Curling Directions	Left, Right, Auto (alternating)
Auto Shut-Off	After 60 minutes of inactivity
Barrel Material	Cylinder with tourmaline coating
Display	LCD
Hair Length Limit	Up to 40 cm recommended
Safety Features	Automatic reverse if hair tangled, overheat protection (auto shut-off)
Included Accessories	Travel protective cover, cleaning accessory
Cleaning Instructions	Clean chamber with damp cloth or cleaning accessory; avoid sharp tools
Power Cord	Swivel power cord
Usage	For dry, clean hair; separate sections ≤ 2 cm
Warranty	Contact service: Tel [phone], Email [e-mail]
Compliance	EU Low Voltage Directive, EMC Directive, CE marked
Disposal	Do not dispose with household waste; recycle according to local regulations

Frequently Asked Questions - HSA701 BLAUPUNKT

How do I set the temperature on my Blaupunkt HSA701 curling iron?

Press the temperature adjustment button (8) to cycle through the range of 140°C to 230°C. The default setting is 190°C. Lower temperatures are suitable for fine or dyed hair, while higher temperatures work best for thick or naturally wavy hair.

How do I change the curling time?

Press the timer adjustment button (7). The cycle time can be set from 5 to 12 seconds. A shorter time (e.g., 5 seconds) gives gentle waves, while a longer time (up to 12 seconds) creates tighter curls.

What do the curl direction settings mean?

The switch (9) offers three options: left, right, and auto. Auto mode alternates directions, curling one strand to the right and the next to the left, for a natural look.

How do I use the automatic curler?

1. Plug in and turn on. 2. Set temperature and timer. 3. Wait for the beep indicating readiness. 4. Place a small section of dry, clean hair (≤2 cm) under the rotating hook inside the chamber. 5. Press the curling button (6). The curler winds, holds, and releases the hair automatically. Repeat for each section.

What should I do if my hair gets tangled in the curler?

The curler detects jams and will emit three short beeps, then reverse direction to release hair. If still stuck, turn off the device using the on/off switch (9) and gently remove the hair. Never pull forcefully.

How do I clean the curling chamber?

Ensure the device is unplugged and cool. Use the included cleaning accessory; if needed, dampen it with water and a drop of dish soap. Insert into the chamber and rotate several times. Rinse the accessory and let it dry. Do not use sharp tools to avoid scratching the tourmaline coating.

Does the curler have an auto shut-off feature?

Yes, the curler automatically turns off after 60 minutes of inactivity. To resume, toggle the on/off switch (9) off and on again.

Can I use this curler on wet hair?

No, the hair must be clean, dry, and well-combed before use. Using the curler on wet hair can cause damage and increase the risk of electric shock.

What is the maximum hair length for the HSA701?

The manual recommends not using the curler on hair longer than 40 cm to prevent tangling.

What accessories are included with the Blaupunkt HSA701?

The package includes the curler, a travel protective cover, and a cleaning accessory for maintaining the curling chamber.

USER MANUAL HSA701 BLAUPUNKT

Enjoy it.

Hair curler

Lokówka

Kulma automatická

Kulma automatická

IMPORTANT NOTES

- Before using this device read the instruction manual and follow the instructions inside. The manufacturer is not liable for any damages caused by the misuse of this device due to inappropriate handling. Please keep this manual for future reference.

- This device is for domestic use only. Do not use for any other purposes.

• The device should only be connected to an earthed socket with values corresponding to the values on the rating label.

- It is necessary to check, if total current consumption of all devices plugged into the wall outlet does not exceed the fuse in the circuit.

- If you are using an extension cord, make sure that the total power consumption of the equipment plugged into the extension cord does not exceed the extension cord power rating. Extension cords should be arranged in such a way as to avoid tripping hazards. Do not let cord hang over edge of counter, or touch any hot surface.

- The device is not designed to be controlled via an external timer, separate remote control, or other equipment that can turn the device on automatically.

- Before maintenance work always disconnect the unit from the power supply.

- When unplugging the power cord from electrical outlet, hold it by the plug only and remove the plug carefully. Never pull the cable as it may cause damage to the plug or power cord. Damage to the power cord or plug can lead to an electrocution hazard.

- Never leave the product connected to the power source without supervision.

- Never put the power cable, the plug, or the whole device into water or any other liquid.

- The device should be cleaned regularly in accordance with the recommendations in the cleaning and maintenance section.

- Do not place the device near heat sources, flames, electric heating elements, or hot ovens. Do not place it on any other device.

- This equipment can be used by children aged 8 years and over if they are supervised. People with reduced physical, sensory, or mental capabilities, or those lacking experience and knowledge, must be supervised and instructed regarding the safe use of the equipment and the risks involved. The instruction manual should be used as a reference for safe operation. Children should not play with the equipment. Cleaning and maintenance should not be performed by children without supervision.

- Extra caution should be taken when using this device near children or pets. Do not let children play with the device.

- Never use the product near combustible materials.

- Never expose the product to atmospheric conditions such as direct sunlight or rain. Never use the product in humid environments (e.g., bathroom or camping tent).

- The power cable should be checked periodically for damage. If the cable is damaged, the product should be taken to a professional service center for repair or replacement to prevent hazards.

- Never use the product with a damaged power cable, or if it has been dropped or damaged in any way, or if it does not work properly. Do not attempt to repair the defective product yourself,

as this may cause electric shock. Always return the damaged device to a professional service center for repair. All repairs should be performed only by authorized service personnel. Any unauthorized repair attempts may pose a hazard to the user.

• Only original accessories or those recommended by the manufacturer should be used. Using non-recommended accessories may damage the device and make it unsafe. Warning: Do not use this equipment near bathtubs, showers, sinks, swimming pools, or similar water sources.
• For additional protection, it is recommended to install a residual current device (RCD) in the power circuit with a rated residual current not exceeding 30 mA. Consult a qualified electrician for this.
• Do not immerse the unit in water or allow it to get wet. If it falls into water, unplug it immediately. Do not reach into water while the device is plugged in. Before next use, have the appliance checked by a qualified electrician.
• Do not touch the appliance with wet hands.
• Do not wrap the cord around the appliance.
• Some components get very hot. Avoid direct contact of the hot surface with the skin, especially the eyes, ears, face and neck.
• Do not use curling irons for hair longer than 40 cm.
• A device should be placed on the surfaces resistant to heat during operation, or when it cools down. • Make sure that the device cool down completely before

storing.

Device is compliant with EU directives:

- Low voltage directive (LVD)

- Electromagnetic compatibility (EMC)

Device marked CE mark on rating label

When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2012/19/EU. Please inform yourself about the local separate collection system for electrical and electronic products. Used appliance should be delivered to the dedicated collecting points due to hazardous components, which may affect the environment. Do not dispose this appliance In the common waste bin.

Environmental information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and poly ethylene (bags, protective foam sheet). Your system consists of material which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Your products is designed a manufactured with high quality materials and components, which can be recycled and reused.

TECHNICAL DATA

Power: 30W

Power supply: 100-240V\~50/60Hz

1. Travel protective cover
2. Curling chamber
3. Cylinder with tourmaline coating
4. Rotating hook
5. LCD
6. Curling button
7. Timer adjustment button
8. Temperature adjustment button
9. On/Off switch with curling direction option
10. Swivel power cord
11. Accessory for cleaning

WORKING PARAMETERS OF THE AUTOMATIC CURLER

1. The time of a single cycle

Range: 5-12 seconds

The default setting is 5 seconds. To change the time, press the timer button (7).

Select a shorter winding time for gentle waves or a longer one for stronger curls.

1. Temperature adjustment

Range: 140-230°C

The default setting is 190°C. To change the temperature, press the temperature adjustment button (8).

Select a lower temperature for gentle waves or a higher one for stronger curls.

NOTE: The lower temperature is recommended for fine and dyed hair. Higher temperature is recommended for thicker hair or naturally wavy hair.

1. Direction of curling

There are three settings available: left, right, and automatic. Auto mode alternately turns the curler to the right and then to the left.

Select the operating mode with the switch (9).

HAIR PREPARATION

Make sure the hair is clean, well-combed, and dry. Separate the sections of hair not wider than 2 cm.

USING THE AUTOMATIC CURLER

1. Connect the device to a power source.
2. Set the curler as described in section WORKING PARAMETERS OF THE AUTOMATIC CURLER.
3. Wait until the curler beeps to indicate readiness.
4. Insert the strand of hair into the curling chamber (2) so that the hair goes under the rotating hook (4) as shown in figure No. 2.
5. Press the curling button (6).
6. The curler winds the hair around the cylinder and holds it for the set amount of time. Then it releases the hair.
7. Repeat steps 4 - 6.
8. After finishing use of the curler, turn off the switch (9) and unplug the power cord. NOTE: After 60 minutes, the curler turns off automatically. To resume operation, turn off the switch (9) and restart. It is recommended not to comb hair just after curling. When the hair cools down, the effect will be stronger.

WHEN HAIR GETS TANGLED

If the curler is used as advised and hair is combed through, it should not happen that hair is drawn in and tangled. It is important that the hair section is not too big and the comb runs easily through the hair. The curler automatically monitors the operation of the winding engine. In case hair gets improperly drawn in, the device will give three short beep signals and start to curl in the opposite direction in order to release the hair.

If however hair gets stuck in the curler, turn the device off using the on/off switch (9) and then try to gently take the hair out.

CLEANING AND MAINTENANCE

Before cleaning, make sure that the curler is unplugged and cool.

It is important to regularly clean the curler's chamber of hair. Do not use sharp tools as they can scratch the tourmaline coating.

In case of dirt that is hard to remove, use the cleaning accessory. If necessary, wet the accessory slightly with water with a small amount of dishwashing liquid added. Then put the accessory into the curling chamber and turn it several times. If necessary, repeat the activities.

The cleaning accessory can be reused numerous times. It has to be rinsed and left to dry after use.

Before re-using the curler, make sure that all its elements have dried thoroughly.

IMPORTANT INFORMATION

02-801 Warsaw, Poland

phone: [phone]

e-mail: [e-mail]

www.blaupunkt.com

In case of questions or problems

please contact our service.

Tel. [phone]

E-mail: [e-mail]

All rights reserved. All brand names are registered trademarks of their respective owners. Specifications are subject to change without prior notice.

Enjoy it.