A-500S - MIDI Keyboard ROLAND - Free user manual and instructions

USER MANUAL A-500S ROLAND

A-500S_f.book Page 4 Thursday, December 10, 2009 11:52 AM

A-500S_f.book Page 6 Thursday, December 10, 2009 11:52 AM Sommaire

A-500S_f.book Page 11 Thursday, December 10, 2009 11:52 AM Description Face avant fig.rear_50

A-500S_f.book Page 12 Thursday, December 10, 2009 11:52 AM Description Insertion de piles

A-500S_f.book Page 58 Thursday, December 10, 2009 11:52 AM Annexes

A-500S_f.book Page 70 Thursday, December 10, 2009 11:52 AM Implémentation MIDI

• 1 GM2 SYSTEM ON only.

A-500S_f.book Page 76 Thursday, December 10, 2009 11:52 AM MÉMO

A-500S_f.book Page 77 Thursday, December 10, 2009 11:52 AM MÉMO

A-500S_f.book Page 78 Thursday, December 10, 2009 11:52 AM For EU Countries For China

A-500S_f.book Page 79 Thursday, December 10, 2009 11:52 AM For the U.K.

THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN-AND-YELLOW. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

IMPORTANT: For EU Countries This product complies with the requirements of EMC Directive 2004/108/EC. For the USA

FEDERAL COMMUNICATIONS COMMISSION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Unauthorized changes or modification to this system can void the users authority to operate this equipment. This equipment requires shielded interface cables in order to meet FCC class B Limit. For Canada NOTICE This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. AVIS Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. For C.A. US (Proposition 65) WARNING This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead. For the USA

DECLARATION OF CONFORMITY

A-500S_f.book Page 80 Thursday, April 15, 2010 9:03 AM