14983 - Clock Kienzle - Free user manual and instructions
Find the device manual for free 14983 Kienzle in PDF.
User questions about 14983 Kienzle
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Clock in PDF format for free! Find your manual 14983 - Kienzle and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 14983 by Kienzle.
USER MANUAL 14983 Kienzle
Remove the locking pin.
natural_image
Close-up of a mechanical component with two circled features and an arrow indicating direction (no text or symbols)5
Battery is not included.
EN Visit our website via the following QR Code or web link to find further information on this product or the available translations of these instructions.
Paper | Supporting responsible forestry
FSC® C145597
DE BEDIENUNGSANLEITUNG......6
EN INSTRUCTION MANUAL....10
FR MODE D'EMPLOI.... 14
NL HANDLEIDING....18
ES INSTRUCCIONES DE USO....22
IT ISTRUZIONI PER L'USO 26
Zu dieser Anleitung
About this Instruction Manual
These operating instructions are to be considered a component of the device.
Please read the safety instructions and the operating instructions carefully before use.
Keep these instructions for renewed use at a later date. When the device is sold or given to someone else, the instruction manual must be provided to the new owner/user of the product. The device is intended only for indoor use.
General Warnings
RISK OF CHOKING!
This product contains small parts that could be swallowed by children. There is a RISK OF CHOKING.
RISK OF CHEMICAL BURN!
Leaking battery acid can lead to chemical burns. Avoid contact of battery acid with skin, eyes and mucous membranes. In the event of contact, rinse the affected region immediately with a plenty of water and seek medical attention.
RISK OF FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use only the recommended batteries. Do not short-circuit the device or batteries, or throw them into a fire. Excessive heat or improper handling could trigger a short-circuit, a fire or an explosion.
NOTE!
Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will contact the Service Centre and can send the device in to be repaired, if necessary.
Protect the device from severe shocks! The manufacturer is not liable for damage related to improperly installed batteries.
CONTENT
Wall Clock (A), base (B), operating instructions
A 1.5V AA/LR battery is required for operation (not included).
PARTS LIST
① Clock face
② Hanging hole
③ Stand (inside)
④ Suction cups
⑤ Protective rubber ring
⑥ Battery compartment
⑦ Stand receptacle
⑧ Temperature and humidity display
9 Cover
FEATURES
- Water resistant
- LCD display with indoor temperature and humidity (°C)
- Easy to install with four strong suction cups
- Modern design with an elegant aluminum frame
START-UP/POWER SUPPLY
- Turn the housing cover (9) with a little force, counter-clockwise and detach it.
- Remove the locking pin from the clockwork. The clock can be operated only after the pin has been removed.
- Insert a 1.5V battery into the battery compartment (6) AA/LR6. Pay attention to the correct polar direction (+ / - ) of the battery as indicated inside the battery compartment.
RADIO CONTROLLED TIME
The radio controlled signal for time (DCF) is transmitted from the central atomic clock in Frankfurt/Main in short intervals. It has a reception range of approx. 1500 km.
- During night-time hours, atmospheric disturbances are typically less severe and radio signal reception may improve. A single daily reception is sufficient enough to keep the clock accuracy within 1 second.
- Make sure the unit is positioned at 8 feet (2 meters) distance from any interference source such as a TV, computer monitor, microwave, etc.
- Within concrete wall rooms such as basements or office buildings, the received signal may be weakened.
After inserting the battery, the indoor temperature and humidity are shown on the LCD display (8). The measuring range is between 0^ C \~ +50°C (temperature) and 20% \~ 95% (humidity).
MOUNTING/POSITIONING OF THE CLOCK
There are 3 ways to mount this clock on the wall or on a flat surface:
- Open the housing cover (9) and remove the pedestal stand (3). Insert it into the receptacle for the stand (7) and position the clock on a flat surface (e.g. bathroom cabinet).
- Hang the clock using a screw or nail (not included) onto the desired and suitable wall (2).
- Slightly moisten the suction cups (4) and press the clock with the suction cups against a flat wall surface.
CAUTION:
Always make sure to mount or stand the clock securely. Dropping the unit may cause serious damage, for which the manufacturer takes no responsibility! The suction cups must be placed on a perfectly flat, clean and dry surface. Moisture favours slipping!
INITIATE TO RECEIVE THE DCF TIME SIGNAL MANUALLY
! NOTE!
Use this function when e.g. automatic summer/winter time change does not work or the wall clock temporarily receives no time signal.
- Press and hold the REC button (11) for 3 seconds to start manual search for the DCF signal.
- The clock hands will move to their start position (12:00 a.m.) and a the wall clock then tries to receive the signal.
- Wait approx. 2-5 minutes until the current time will be displayed.
MANUAL TIME SETTING
! NOTE!
It is necessary to set the time manually in places where no radio signal is received.
- Press and hold the M.SET button (12) for approx. 3 seconds.
- When the minutes hand starts moving you can the set the time manually:
- Press the M.SET button shortly to set the time in minutes steps.
- Press and hold the M.SET button to set the time continuously.
- Release M.SET button to stop manual setting and save the time automatically and exit manual time setting mode.
TROUBLESHOOTING
Signals from other household devices, such as door bells, home security systems and entry controls, may interfere with those of this product and cause temporarily reception failure. This is normal and does not affect the general performance of the product. The transmission of the radio signal will resume once the interference recedes.
OTHER MALFUNCTIONS
If there is no response from the wall clock by keystrokes or if any other malfunctions occur perform the following steps.
!NOTE!
With this procedure all received data will be deleted.
- Press RESET button (10) with a pointed instrument (e.g. pen).
- The clock hands will move to their start position (12:00 a.m.) and the wall clock then tries to receive the signal.
- Wait approx. 2-5 minutes until the current time will be displayed.
NOTES ON CLEANING
Before cleaning the device, disconnect it from the power supply (remove batteries).
Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not use any cleaning fluid.
DISPOSAL
Dispose of the packaging materials properly, according to their type, such as paper or cardboard. Contact your local waste-disposal service or environmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage!
As per Directive 2012/19/EU of the European Parliament on waste electrical and electronic equipment and its adaptation
into German law, used electronic devices must be collected separately and recycled in an environmentally friendly manner.
In accordance with the regulations concerning batteries and rechargeable batteries, disposing of them in the normal
household waste is explicitly forbidden. Please make sure to dispose of your used batteries as required by law — at a local collection point or in the retail market. Disposal in domestic waste violates the Battery Directive.
Batteries that contain toxins are marked with a sign and a chemical symbol. "Cd" = cadmium, "Hg" = mercury, "Pb" = lead.
EC DECLARATION OF CONFORMITY
Hereby, Bresser GmbH declares that the equipment type with part number: 14983 is in compliance with Directive: 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
http://www.bresser.de/download/14983/14983_CE.pdf
WARRANTY
The regular guarantee period is 2 years and begins on the day of purchase. To benefit from an extended voluntary guarantee period as stated on the gift box, registration on our website is required.
You can consult the full guarantee terms as well as information on extending the guarantee period and details of our services at www.bresser.de/warranty_terms.
DÉCLARATION DE CONFORMITÉ CE
Errors and technical changes reserved.
Manual_14982_DCF-Bathroom-Clock_de-en_KIENZLE_v122024a
