HG02519 - Power bank SILVERCREST - Free user manual and instructions

USER MANUAL HG02519 SILVERCREST

PDF online www.lidl-service.com

POWERBANK

GB IE NI

POWERBANK

Operation and Safety Notes

FR BE

CHARGEURPOWERBANK

GB/IE/NI Operation and Safety Notes Page 5

List of pictograms used and warnings......Page 6

Introduction......Page 6

Intended use ......Page 6

Warnings and symbols used ......Page 7

Trademark notice......Page 8

Scope of delivery......Page 9

Before use......Page 9

Parts description......Page 9

Technical data ......Page 10

Safety notices ......Page 11

Operation and use......Page 14

Charging the power bank......Page 14

Checking the battery status......Page 15

Charging mobile devices with

the power bank ......Page 15

Using the LED torch....Page 17

Troubleshooting......Page 17

Cleaning and care......Page 18

Storage during non-use.....Page 19

Declaration of conformity Page 21

Warranty Page 22

List of pictograms used and warnings
	Direct current
	Observe caution and safety notes!

Power bank

- Introduction

We congratulate you on the purchase of your new product. You have chosen a high quality product. The instructions for use are part of the product. They contain important information concerning safety, use and disposal. Before using the product, please familiarise yourself with all of the safety information and instructions for use. Only use the product as described and for the specified applications. If you pass the product on to anyone else, please ensure that you also pass on all the documentation with it.

Intendeduse

This product is an IT device which is solely intended to be used to charge mobile devices which are normally charged through a

USB port. This product is not intended for commercial use. Manufacturer is not liable for damages, which result from non-Intended use.

Warnings and symbols used

These instructions for use contain the following warnings:

DANGER

This symbol in conjunction with the „danger“ note indicates an imminent dangerous situation which, if not prevented, could result in serious injury or even death.

This symbol in conjunction with the „warning“ note indicates important information for safe operation of the device and the safety of the user.

ATTENTION

A warning with this sign indicates potential property damage.

Failure to observe this warning may result in property damage. Follow the instructions in this warning to prevent property damage.

NOTE

A note provides additional information to improve product use.

CAUTION! EXPLOSION HAZARD!

A warning with this symbol and word "CAUTION! EXPLOSION HAZARD" indicates the potential threat of explosion. Failure to observe this warning may result in serious or fatal injuries and potential property damage. Follow the instructions in this warning to prevent serious injuries, a danger to life or property damage!

This action sign indicates to wear suitable protective gloves! Follow the instructions to avoid hands

striking or being struck by objects or being in contact with thermal or chemical materials!

Trademark notice

-USB ^® is a registered trademark of USB Implementers Forum, Inc.

- Any other names and products may be trademarks or registered trademarks of their respective owners.

- The SilverCrest trademark and trade name is the property of their respective owners.

Scope of delivery

1 Power bank
1 USB cable
1 Instructions for use

Before use

Note: Remove all packaging materials from the product.

☐ Please remove the paper foil on display before use.
☐ Please also check the content of delivery inside packaging to see if any damages. If you notice any damage or missing parts, please contact the dealer who sold this product.

Parts description

1 USB output 1 (Output: 5 V, 2.1 A)
2 LED light
3 USB output 2 (Output: 5 V, 1 A)
4 Charge/discharge status display

5 Display/LED button
6 Powerbank
7 USB cable (USB type A to Micro-USB)
8 Instructions for use
9 Micro USB Input (Input: 5 V, 2 A)

Technical data

Built-in battery: 3.7V/10,000mAh

(Lithium polymer)

Input voltage/

current:5V =-, max. 2 A

Output voltage/

current: USB output 1:

5V=, 2.1A

USB output 2:

5V=1A

total 3.1 A*

Minimum load

current consumption: approx. 60 mA

Operating

temperature: 5^ C -35°C

Storage

temperature: 0^ C - 45^ C

Humidity

(no condensation): 10% - 70%

Dimensions: approx.

145 × 72 × 18 mm

Weight: approx. 230 g

* If all outputs are used at the same time, the total power consumption of the connected devices may not exceed 3.1 A.

Safety notices

Please familiarise yourself with all instructions for use and Safety notices before using the product for the first time. When passing this product on to third parties, please be sure to include all documentation.

• Check the product for visible external damage before use. Do not use the product if damaged or dropped.
  This product may be used by children age 8 years and up, as well as by persons with physical, sensory or mental impairments or lacking experience and/or knowledge, provided they are supervised or instructed in the safe use of the product and understand the associated risks. Do not allow children to play with the product. Never allow children to clean or maintain this product unsupervised.

⚠️ DANGER!Packaging materials are not a toy. Keep all packaging materials out of the reach of children. Suffocation hazard!

■ Always use the product on flat and smooth surface. The product could be damaged if it falls.
- Do not expose the product to direct sunlight or high temperatures. It may otherwise overheat and be damaged beyond repair.
- Do not operate the product near heat sources such as radiators or other devices producing heat.
- Do not operate the product near open flames.
The product is not designed for use in rooms with high temperatures or humidity (i.e bathrooms) or those in which a great amount of dust is generated.
- Do not expose the product to extremely high temperatures. This applies in particular if you are thinking about storing the product in your car. Over a prolonged period of time, the car and the glove compartment could become extremely hot. Remove electric and electronic devices from the car.
- Do not use the product immediately after it has brought from a cold room to a warm room. Allow the product to acclimatise before you switch it on.

⚠️ DANGER! Never open the product casing. This product has no internal parts requiring maintenance.

- Do not independently convert or modify the product.

■ Repairs to the product must be performed by authorised specialised companies or customer service. Improper repairs may place the user in considerable danger. They will also void the warranty.

- Do not expose the product to dripping water or splashing water and do not place containers filled with liquids such as vases or open drinks on top of or beside the product.

- Immediately switch the product off and remove the charging cable from the product if you smell burning or see smoke. Have the product examined by a qualified technician before using it again.

If you use a USB power supply, the socket used must always be easily accessible so that the USB power supply can be quickly removed from the socket in the case of emergency. Please also refer to the manufacturer's instruction manual.

⚠️ DANGER! Improper handling of lithium polymer batteries can result in fire, explosions, hazardous substances leaking, or other dangerous situations! Do not throw the product into the fire, as this could lead to the built-in battery exploding.

- Observe the usage restrictions and prohibitions of use for battery-operated

products in situations which may be hazardous such as at petrol stations, airports, hospitals, etc.

WARNING! During charging process, please be noticed that the product must not be covered.

WARNING! Do not look into the light beam.

WARNING! Do not point this LED light directly to persons and animals.

- Operation and use

Charging the power bank

The built-in rechargeable battery must be fully charged before using the product. The required charging time for the power bank 6 depends on the charging source and its output power (max. 5 V/2 A).

To charge the power bank only use power supplies with an output voltage of 5 ~V and an output current of at least 2 A.
Connect the USB cable with the Micro USB Input 9 of the power bank 6.
Connect the other end of the USB cable 7 (USB Type A) to a USB power supply (not included in the scope of delivery) (see fig. A).

☐ The current battery status is displayed by charge/discharge status display 4 and "IN" is illuminated during the charging process.

WARNING! No device to be charged maybe connected to the powerbank, as long as the power bank is charged.

- Checking the battery status

You can check the battery status on the display of power bank 6 anytime even the power bank is in charging or discharging mode (see fig. B).

Lightly press the Display / LED button. The charge / discharge status display 4 shows the current battery status of the power bank 6 for approx. 8 seconds in terms of a percentage.

• Charging mobile devices with the power bank

You can charge up to two devices at the same time using the power bank 6. If all outputs are used at the same time, the sum of the discharging power may not exceed 3.1 A.

Use provided USB cable or other charging cable purchased from reliable supplier. Connect USB Type A port to USB output 1 or 3 of power bank 6.

And then connect USB cable or other charging cable micro-USB port 9 to device to be charged. The charging process will start automatically.

☐ The display will show the charging status (in percentage) and the connected output port.

In case if the charging process does not begin immediately, press the Display / LED button 5 lightly to begin the charging process. The current battery status of the power bank 6 is displayed during the charging process by the display 4.

Note: Usage of 5 V/1A or 5 V/2A output shown on display are only information regarding to the used of USB port and not actual measured values.

☐ To end the charging process, separate the USB charging cable from the mobile device and the power bank 6. The charge/discharge status display 4 will switch off after approx. 8 seconds.

Using the LED torch

To switch on the light, press and hold the Display/LED button 5 on the side of the product about 2 seconds.
Press and hold the Display / LED button 5 again to switch the light OFF again.

- Troubleshooting

● = Problem
= Cause
O = Solution

● The power bank 6 is not being charged.
It may be that the power bank is not connected properly.
○ Check that it is connected.

● A connected device is not being charged.

The battery is drained.
○ Charge the battery.
The device is not connected.
- Check that it is connected. Lightly press the Display / LED button 5 to begin the charging process.

The current consumption of the connected device might be too low.

- Check with your connected device manual and see if your connected device current consumption comply with this product.

● The power bank 6 does not react when the button is pressed or when a device is connected, even though the battery is charged

The power consumption of the connected devices is too high. Therefore, the internal overcurrent protection device was activated.

○ Reduce the number of devices connected and press the Display / LED button 5

- Cleaning and care

This product has no internal parts requiring maintenance. Moisture entering the product may result in damage.

■ Ensure no moisture enters the product during cleaning to prevent damaging the product beyond repair.

☐ Do not use abrasive, solvent-based or aggressive cleaners. These can damage the surface of the product.
☐ Only clean the product with a slightly damp cloth and mild washing-up liquid.

- Storage during non-use

Store the product in a dry, dust-free location, protected from direct sunlight.
☐ If the product is not used for a long time, the built-in battery should be fully charged to prolong its operating life. Regularly charge the built-in battery if you do not use the product for a long period of time. This is necessary to preserve the battery.

●Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling

facilities. The Green Dot is not valid for Germany.

Observe the marking of the packaging materials for waste separation, which are marked

with abbreviations (a) and numbers (b) with following meaning: 1–7: plastics / 20–22: paper and fibreboard / 80–98: composite materials.

The product and packaging materials are recyclable, dispose of it separately for better waste treatment. The Triman logo is valid in France only.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out

product.

The adjacent symbol of a crossed out dustbin on wheels indicates this device is subject to Directive

2012/19/EU. This directive states at the end of the life this device must not be disposed of through regular household refuse but must be returned to special collection sites, recycling depots or waste management companies.

The built-in rechargeable battery cannot be removed for disposal.

This disposal is free of charge to you. Protect the environment and dispose properly.

Please contact your local waste management company or the city / municipal administration for more information.

Improper disposal of batteries can harm the environment!

Never dispose of batteries in your household waste. They may contain toxic heavy metals and are subject to hazardous waste regulations. The chemical symbols of the heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead. Therefore return used batteries to your local collection site!

Built-in rechargeable battery cannot be removed. For this reason, the powerbank must be handed over entirely at a collecting point for waste electronic equipment for a professional disposal.

- Declaration of conformity

We, OWIM GmbH & Co. KG, Stiftsbergstraße 1, DE-74167 Neckarsulm, GERMANY, hereby declare under our sole responsibility that the product: Power Bank, Model No.: HG02519, to which this declaration refers, this device complies with the basic standards

and other relevant requirements of EMC directive 2014/30/EU and the RoHs Directive 2011/65/EU.

The full text of the EU declaration of conformity is available at the following internet address: www.owim.com

Warranty

The product has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of product defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.

The warranty for this product is 3 years from the date of purchase. Should this product show any fault in materials or manufacture within 3 years from the date of purchase, we will repair or replace it – at our choice – free of charge to you.

The warranty period begins on the date of purchase. Please keep the original sales receipt in a safe location. This document is required as your proof of purchase. This

warranty becomes void if the product has been damaged, or used or maintained improperly.

The warranty applies to defects in material or manufacture. This warranty does not cover product parts subject to normal wear, thus possibly considered consumables (e.g. batteries) or for damage to fragile parts, e.g. switches, rechargeable batteries or glass parts.

CE

condensation): 10% - 70%

Dimensions : env. 145 x 72 x 18 mm

Poids : env. 230 g

Kondensation): 10% - 70%

Last Information Update