BPS - Projection screen Duronic - Free user manual and instructions

USER MANUAL BPS Duronic

• Remove all packaging and set aside.

• Clear a large enough area to assemble the screen. Make sure the area is larger than the sides of the screen.

• Do not assemble the screen in areas of high temperature to avoid incurring any damage to the screen.

• Ensure that you read through this manual entirely before beginning to assemble the screen. Wall Mounted: Using the hooks on the top of the screen to guide you, hold the screen up onto the wall where you wish to install it and mark the two places where you need to put the screws. a. Use a spirit level to check that the screen will be level and straight on the wall. b. Set the screen aside. c. Use a drill to make two holes in the places you marked, ensuring they are the same size to correspond with your raw plugs. Then insert raw plugs.7 Cleaning If the screen gathers dust, simply clean with a dry cloth or duster. The screen is made of PVC. If the screen has a mark or stain that needs to be removed, use a wet cloth with a mild soap to gently clean the screen. Use minimal pressure to prevent damaging the fabric. Do not use any abrasive chemicals or cleaning agents on any part of the screen. Note: You will need to nd suitable raw plugs and screws for your type of wall.

Insert screws into the raw plugs and tighten in place. e. Lift the projector screen into place, hooking the screen onto the screws. f. Check to make sure the screen is level on the wall. The screen can be stored away by rolling it back up and using the rip-tape fasteners (provided) to hold it together.8 Warranty 1 Year Guarantee from Shine-Mart Ltd, Trademark owners of Duronic Products. NOTE: THESE STATEMENTS DO NOT AFFECT YOUR STATUTORY RIGHTS AS A CONSUMER This product has been manufactured under the strictest or quality control procedures, and using the highest quality of materials, to ensure excellent performance and reliability. It will give very good and long lasting service, provided it is properly used and maintained. The product is guaranteed for 1 years from the date of original purchase. If any defect arises due to a faulty materials or poor workmanship, the faulty product must be returned to the original place of purchase. Refund or replacement is at the discretion of that company. Duronic Products are offered with a 1 year guarantee under the following conditions:

1. The product must be returned to the retailer with original proof of purchase.

2. The product must be installed and used in accordance with the instructions

contained in this operating manual.

3. It must be used only for domestic purposes.

4. It does not cover wear and tear, malicious damage, misuse, neglect,

inexpert repairs or consumable parts.

5. Shine-Mart Ltd has no responsibilities for accidental or consequential loss or damage.

6. Shine-Mart Ltd are not liable to carry out any type of servicing work,

7. Valid in the UK only

This product is tted with CE:1363 plug and fuse Imported by Shine-Mart Ltd, RM3 8SB Information on waste Disposal for Consumers of Electrical & Electronic Equipment. This mark on a product and/or accompanying documents indicates that when it is to be disposed of, it must be treated as Waste Electrical & Electronic Equipment, (WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for the treatment, recovery and recycling of the materials used. For proper treatment, recovery and recycling; please take all WEEE marked waste to your Local Authority Civic waste site, where it will be accepted free of charge. If customers dispose of Waste Electrical & Electronic Equipment correctly, they will be helping to save valuable resources and preventing any potential negative effects upon human health and the environment, of any hazardous materials that the waste may contain.9 Manuel d’utilisation en français10 Avant d'assemblageInstructions