Backup Battery for HomeBase 2 - Camera batteries eufy - Free user manual and instructions

USER MANUAL Backup Battery for HomeBase 2 eufy

1. Place your HomeBase 2

on the top of the Backup Battery.

2. Unplug the power adapter

from your HomeBase 2's power port, and plug it into the Backup Battery.

3. Connect the cable of the

Backup Battery to your HomeBase 2's power port. INSTALLING BACKUP BATTERY 1EN

Backup Battery Status LED Description Blue Working properly Flashing blue Charging Red Not connected to power Flashing red Low battery NOTICE

FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Notice: Shielded cables All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations. The following importer is the responsible party.EN

Company Name: POWER MOBILE LIFE, LLC Address: 10900 NE 8TH ST, STE 501, BELLEVUE, WA 98004 Telephone: 1-800-988-7973 IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This product complies with the radio interference requirements of the European Community. Declaration of Conformity Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of conformity, visit https://uk.eufylife.com/ This product can be used across EU member states. Due to the used enclosure material, this product should only be connected to a USB interface of version 2.0 or higher. The adapter shall be installed near the equipment and shall be easily accessible. Do not use this device in the environment in extreme hot or cold temperatures. Never expose this device to strong sunshine or a moist environment. The recommended operating temperature range for T8732 and accessories is -10°C-45°C.EN

When charging, please place the device in an environment that has a normal room temperature and good ventilation. It is recommended to charge the device in an environment with a temperature that ranges from 5°C-25°C. Use only the charger offered by the manufacturer. Using an unauthorized charger may be unsafe and violate any warranties. This charger is for indoor use only. The charger type is ASSA67W-120200/KA2401A-1202000DE, and the output voltage/ current is 12Vdc/2A. The plug is considered to be a disconnected device. CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with the RF exposure requirement, use this product while maintaining a 20cm distance between the device and human body. The following importer is the responsible party (contact for EU matters only) Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany This product is designed and manufactured with high quality materials and components, which can be recycled and reused. This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product. This product complies with the radio interference requirements of the United Kingdom. Declaration of Conformity Hereby, Anker Innovations Limited declares that this product is in compliance with Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: https://uk.eufylife.com. Anker Technology (UK) Ltd I Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United KingdomDE

Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are trademarks of Anker Innovations Limited, registered in the United States and other countries. All other trademarks are the property of their respective owners. 51005002913 V01