SBCSC364-00Y - Baby monitor PHILIPS - Free user manual and instructions

USER MANUAL SBCSC364-00Y PHILIPS

Guarantee certificate

Garantiebewijs

Dealer's name, address and signature

6 month guarantee on rechargeable batteries

This document is printed on chlorine free produced paper

Data subject to change without notice

Printed in China

€0682

baby monitor

SBC SC364

Instructions for use

A-1 Power light - lights when unit is powered; flashes when batteries are low
A-2 Transmit light - lights when a sound is being transmitted
A-3 Talk pushbutton push this button to talk
A-4 Microphone high-sensitivity microphone
A-5 DC power supply socket ---- plug mains adapter connector into this socket
A-6 Mode switch

VOICE: baby monitoring mode; microphone is sound activated OFF: switches off the Baby unit completely

A-7 Channel selection switch select channel A or B (whichever has least interference)
A-8 Battery compartment cover ---- unscrew and unclip to insert batteries
A-9 AC power adapter plug into AC mains socket and into DC power supply socket

PARENT UNIT

B-1 Power light - lights when unit is powered; flashes when batteries are low
B-2 Sound-level lights the more sound your baby makes, the more lights that light
B-3 Loudspeaker provides clear sound
B-4 Loudspeaker Volume control / Off switch
B-5 Charging base place unit in base to operate it on mains power and when batteries are low
B-6 Battery compartment cover unscrew and unclip to replace batteries
B-7 Channel selection switch select channel A or B (same as Baby unit)
B-8 Belt clip handy clip for carrying the unit
B-9 DC power supply socket ---- plug mains adapter connector into this socket
B-10 AC power adapter -- plug into AC mains socket and into DC power supply socket
B-11 Charging base light - lights when unit is in the base and charging

CONGRATULATIONS

You have just purchased a high-performance, cordless Baby Monitor that lets you listen to your child from wherever you are in and around the house. Please read this guide carefully before using the monitor, and keep it for future reference.

IMPORTANT!

This Baby Monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such.

Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away.

Never place the Baby unit inside the baby's bed or playpen!

The antennas on the Parent and Baby units are fixed; do not try to extend them.

Never cover the Baby unit (with a towel, blanket, etc.)

GETTING THE UNITS READY FOR USE

Baby unit

Connect the AC power adapter (A-9) to an AC mains socket, and then connect the cord to the DC power supply socket (A-5) of the Baby unit.

If you want to use batteries, remove the battery compartment cover (A-8) using a screwdriver. Insert four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw.

The Baby unit operates cordlessly for up to 30 hours on fresh batteries. The red POWER light (A-1) flashes when battery power is low. If this happens install new batteries.

Note: To switch off the Baby unit completely set the mode switch (A-6) to OFF.

Parent unit

The Parent unit uses rechargeable batteries. These are already installed, but first they must be charged for at least 14 hours as follows before using the unit outside the charging base:

• Connect the AC power adapter (B-10) to an AC mains socket, and then connect the cord to the DC power supply socket (B-9) of the charging base (B-5).
• Place the Parent unit inside the charging base. The red charging light (B-11) lights.

The Parent unit can be operated now but you should leave it in the charging base until the batteries are fully charged (at least 14 hours). When the batteries are fully charged, take the Parent unit out of the charging base and use cordlessly for up to 12 hours.

When the red POWER light (B-1) on the Parent unit flashes, the battery power is low. Place the Parent unit inside the charging base to recharge the batteries.

If the rechargeable batteries begin to lose their effectiveness, replace them with four new batteries (1.2V, AA NiMH) as follows: remove the battery compartment cover (B-6) using a screwdriver and insert the batteries noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw. Only use 1.2V, AA NiMH rechargeable batteries!

Monitoring baby's sounds

To use the units to listen to your baby:

• Position the Baby unit at least 1 metre away from the baby so that the microphone (A-4) can pick up baby's sounds.
• Set the channel switch to the same position on both units.
• Set the mode switch on the baby unit (A-6) to VOICE; the red POWER light (A-1) lights.
• Move away from the Baby unit with the Parent unit.
• Switch on the Parent unit using the Volume control/Off (B-4) and adjust the volume to the level you prefer; the red POWER light (B-1) lights.
• The green TRANSMIT light (A-2) lights when a sound is picked up by Baby unit.

Talk pushbutton

To use the Baby unit manually to talk to the Parent unit:

• Set the mode switch on the Baby unit (A-6) to OFF.
• Switch on the Parent unit using the Volume control/Off (B-4) and adjust it to about mid-range; the red POWER light (B-1) lights.
• On the Baby unit, press and hold the TALK pushbutton (A-3) and talk clearly into the microphone (A-4). Release the TALK pushbutton when you are finished.

Avoiding interference

Both units use anti-interference technology to reduce the chance of interference from other signals. If interference does occur or if sound reception is poor, try switching both units to the other channel to improve the sound quality.

Note: Always make sure that the channel selection switches (A-7, B-7) on both units are set to the same position.

Sound-level lights

The Parent unit has sound-level lights (B-2), which visually alert you to baby's sounds even when the volume control is turned down. The louder the sound received from the Baby unit, the more lights light.

Belt clip

When the batteries of the Parent unit are charged, the unit can be carried around giving you freedom of movement while still monitoring your baby. Use the belt clip (B-8) to attach the unit to your clothing and so keep your hands free. The belt clip can be removed by unclipping the top and sliding it downwards.

PROBLEM SOLVING

Problem	Possible Cause	Solution
Power light does not light (Parent unit).	Unit is not turned on.	Turn Volume control/Off switch clockwise (B-4).
	Batteries are low.	Recharge batteries.
Power light does not light (Baby unit).	Unit is not turned on.	Set mode switch (A-6) to the VOICE position.
	AC adapter is not plugged in or Batteries are exhausted.	Plug in AC adapter or replace batteries.
	AC adapter plugged into an outlet that is not working.	If the power socket has a switch, turn it on.
High pitched noise.	Units are too close together.	Move Parent unit away from Baby unit.
	Volume too high.	Turn volume control on Parent unit counter-clockwise.
Parent unit batteries do not charge.	Battery life is at an end.	Replace rechargeable batteries, using only 1.2V, AA NiMH batteries.
No sound.	Volume control on Parent unit is set too low.	Turn volume control/Off switch clockwise (B-4).
	Units are out of range.	Move Parent unit closer to Baby unit.
Power light blinking.	Batteries are low or empty.	Parent unit:- recharge batteries. Baby unit:- replace batteries or connect to mains power.
Interference or poor reception.	Mobile or cordless phones too close to the baby monitor can cause interference.	Move the phones away from the units.

TECHNICAL SPECIFICATIONS

Power supply

• Batteries 4 × 1.2V AA; rechargeable NiMH for Parent Unit (included);
• Optional batteries 4 × 1.5V ; AA alkaline for Baby Unit (not included);
• AC power adapter 230V AC, 50Hz (two included): - Output voltage 9V DC, 200mA .

Only use the AC power adapter included or a type that complies with safety standard EN60950 and that has the following specification: 9 Volt DC / 200mA.

Operating range

• up to 150 metres in ideal conditions (walls and floors can limit this distance).
• 10^ to 40^

Pilot tone

• Continuous communication link (hidden signal ensures a continuous link between both units so you only hear your baby's sounds).

Transmission frequencies

SBC SC364/00Y

Channel A Channel B

40.695 MHz 40.675 MHz

UNITE BÉBÉ

A-1 Témoin d'alimentation ----- s'allume quand l'unité est active; clignote quand les piles sont faibles
A-2 Témoin de transmission s'allume quand un son est en cours de transmission
A-3 Bouton «Parlez» appuyez sur ce bouton pour parler
A-4 Microphone - microphone très sensible
A-5 Prise d'alimentation élect. c.c. --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- enfichez le connecteur d'adaptateur réseau dans cette prise
A-6 Selecteur de mode

A-7 Sélecteur de canal --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- ---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

---

--- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � --- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- � ---- �

---

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

----

---

TALK (tale) trykknap

TALK-trykknapp (tale)