K 2 Full Control Car & Home - Pressure washer Kärcher - Free user manual and instructions

USER MANUAL K 2 Full Control Car & Home Kärcher

90 dB(A) Technische Änderungen vorbehalten. Garantie EU-Konformitätserklärung Produkt: Hochdruckreiniger Typ: 1.673-xxx Einschlägige EU-Richtlinien 2000/14/EG 2014/30/EU 2006/42/EG (+2009/127/EG) 2011/65/EU Angewandte harmonisierte Normen EN 50581 EN 55014–1: 2006+A1: 2009+A2: 2011 EN 55014–2: 2015 EN 60335–1 EN 60335–2–79 EN 61000–3–2: 2014 EN 61000–3–3: 2013 EN 62233: 2008 Angewandtes Konformitätsbewertungsverfahren 2000/14/EG: Anhang V Schallleistungspegel dB(A) Gemessen: 88 Garantiert: 90 Winnenden, 2016/08/01 CEO Head of Approbation 7DE– 4 Please read these original operating in- structions and the enclosed safety in- structions prior to the initial use of your device. Proceed accordingly. Keep both booklets for future reference or subsequent owners. DANGER Pointer to immediate danger, which leads to severe in- juries or death. 몇 WARNING Pointer to a possibly dangerous situation, which can lead to severe injuries or death. 몇 CAUTION Pointer to a possibly dangerous situation, which can lead to minor injuries. ATTENTION Pointer to a possibly dangerous situation, which can lead to property damage. 몇 CAUTION Safety installations serve the protection of the user and may not be modified or bypassed. The appliance switch prevents unintentional operation of the appliance. The lock locks the lever of the trigger gun und prevents the accidental start of the device. If the lever on the trigger gun is released, the pressure switch turns off the pump, the high-pressure jet stops. If the lever is pulled the pump is turned on again. This high pressure cleaner is designed for domestic use only. – for cleaning machines, vehicles, buildings, tools, facades, terraces, gardening tools, etc. by means of a high-pressure water jet (if necessary, with ad- ditional cleaning agents). – with accessories, replacement parts and cleaning agents approved by KÄRCHER. Please observe the information accompanying the cleaning agents. Notes about the ingredients (REACH) You will find current information about the ingredients at: www.kaercher.com/REACH Contents Safety ... EN 4 Proper use ... EN 4 Environmental protection... EN 4 Description of the Appliance ... EN 5 Installation and Startup ... EN 5 Operation...EN 5 Transport and storage ... EN 6 Maintenance and care... EN 6 Troubleshooting... EN 6 Accessories and Spare Parts ... EN 7 Technical specifications... EN 7 Warranty ...EN 7 EU Declaration of Conformity ... EN 7 Safety Hazard levels Safety Devices Appliance switch Lock trigger gun Auto-stop function Symbols on the machine The appliance must not be directly connect- ed to the public drinking water network. The high pressure jet must not be directed at persons, animals, live electrical equipment or at the appliance itself. Protect the appliance against frost. Proper use Environmental protection The packaging material can be recycled. Please arrange for the environmentally appropriate dis- posal of the packaging. Old appliances contain valuable recyclable mate- rials that should be recycled properly. Please ar- range for the environmentally appropriate disposal of the old devices. Electrical and electronic devices often contain components which could potentially pose a dan- ger to human health and the environment if han- dled or disposed of incorrectly. However, these components are necessary for the proper opera- tion of the device. Devices marked with this sym- bol must not be disposed of with regular house- hold rubbish. Cleaning operations which produce oily waste wa- ter, e.g. engine washes, underbody washes, may only be carried out using washing stations equipped with an oil separator. Work with detergents must only be performed on liquid-tight work surfaces with a connection to the sewer system. Do not let release detergent into waters or earth. 8 EN– 5 The scope of delivery of the device (depending on the model) is illustrated on the packaging. These operating instructions describe all possible options. Illustrations on the inside of the picture page 1 High pressure connection 2 Appliance switch „0/OFF“ / „I/ON“ 3 Storage hook 4 Carrying handle 5 Transport handle, detachable 6 Storage for spray lance 7 Storage for trigger gun 8 Water connection with integrated sieve 9 Coupling element for water connection 10 Mains cable with mains plug 11 Bearing wheel 12 Trigger gun 13 Lock trigger gun 14 Clamp for high pressure hose 15 High pressure hose 16 Full Control spray lance Dirtblaster For strong contaminations Pressure level: HARD 17 Full Control spray lance Click-Vario Power Carrying out the most common cleaning tasks Pressure levels: HARD / MEDIUM / SOFT / MIX Illustrations on the inside of the picture page Illustrations - Mount loose parts delivered with appliance prior to start-up. Park the appliance on an even surface. Illustrations - Pull out the clamp from the trigger gun and plug the high-pressure hose into the trigger gun. Push the clamp in until it locks. Check the secure connection by pulling on the high-pressure hose. Illustrations - ATTENTION Impurities in the water can damage the high-pressure pump and the accessories. For protection, the use of the KÄRCHER water filter (optional accessory, order no. 4.730-059) is recommended. 몇 CAUTION Dry running of more than 2 minutes leads to damage of the high-pressure pump. If the appliance does not build up pressure within 2 minutes, switch the appliance off and proceed in accordance with the instructions in Chapter "Troubleshooting". 몇 CAUTION Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid damage. ATTENTION Car tyres, paint or sensitive surfaces such as wood should not be cleaned with the dirt blaster, as there is a risk of damage. Illustrations - ATTENTION The sensitivity of the materials can strongly differ de- pending on the age and the condition. The so-called recommendations are non-binding. Note: Detergent can only be added when the device is operated in low pressure mode. Optional Illustrations - Illustration Spray the detergent sparingly on the dry surface and allow it to react, but not to dry. Spray off loosened dirt with the high pressure jet. After operation with detergent: Run the machine for approximately 1 minute for a clear rinse. Description of the Appliance

• Optional 18 Washing brush Suitable for use with detergents. 19 Foam nozzle For effective detergent foam. 20 Detergent 21 Detergent suction hose (with sieve) ** Additionally required 22 Fabric-reinforced water hose with commercially available coupling. – Minimum diameter, 1/2 inches (13 mm). – Minimum length 7.5 m. Installation and Startup Operation High pressure operation Full Control System Pressure level For example, recommended for HARD Stone terraces made of paving stones or exposed aggregate con- crete, asphalt, metal surfaces, gar- den utensils (wheelbarrow, spade, etc.) Turn the Full Control spray lance Click-Vario Power as far as it will go for maximum possi- ble pressure. MEDIUM Motorcar / motorcycle, brick sur- faces, plastered walls, plastic furni- ture SOFT Wooden surfaces, bicycles, sand stone surfaces, rattan furniture MIX Operation with detergent Operation with detergent Recommended cleaning method After operation with detergent 9EN– 6 ATTENTION Risk of damage to the paintwork When working with the washing brush, it must be free of dirt or other particles. Note: If required, the washing brushes can be used to work with detergent. Illustration Release the lever of the trigger gun and lock it. During longer breaks (more than 5 minutes), also turn the appliance off using the "0/OFF" switch. 몇 CAUTION Only separate the high-pressure hose from the trigger gun or the device when there is no pressure in the sys- tem. Release the lever of the trigger gun. Turn off the appliance "0/OFF". Disconnect the mains plug from the socket. Turn off tap. Press the lever on the trigger gun to release any remaining pressure in the system. Lock the lever of the trigger gun. Detach the appliance from the water supply. 몇 CAUTION Risk of personal injury or damage! Mind the weight and storage of the appliance during transport. Lift appliance by the carrying handle and carry it. Pull out the transport handle until it audibly snaps into place. Pull the appliance by its transport handle. Secure the appliance against shifting and tipping over. Park the machine on an even surface. Stow away the accessories on the appliance ac- cording to the device. Prior to extended storage periods, as during the winter, also observe the instructions in the Care section. ATTENTION Appliances and accessories that are not completely drained can be destroyed by frost. Completely drain ap- pliance and accessories and protect them against frost. To avoid damage: Completely drain all water from the appliance: Switch the appliance on with detached high pres- sure hose and detached water supply (max. 1 min- ute) and wait, until no more water exits at the high pressure connection. Turn off the appliance. Store the appliance and the entire accessories in a frost free room. The appliance is maintenance free. DANGER Risk of electric shock. Prior to all work on the appliance, switch off the ap- pliance and pull the power plug. Clean the sieve in the water connection regularly. ATTENTION The sieve must not be damaged. Remove coupling from the water connection. Illustration Pull the sieve out (e.g. using flat pliers), clean un- der running water and then reinsert it. DANGER Risk of electric shock. Prior to all work on the appliance, switch off the ap- pliance and pull the power plug. Push the lever of the trigger gun, the device will switch on. Check whether the voltage indicated on the type plate corresponds to the voltage of the mains sup- ply. Check the mains connection cable for damages. Check setting at the spray lance. Completely open the water tap. Remove air from appliance before operation. Switch on the appliance without connection the HP hose (max. 2 minutes) and run it until the water dis- charging from the HP outlet is free of bubbles. Switch off appliance and reconnect HP hose. Pull out the sieve in the water connection using flat- nose pliers and clean under running water. Clean high-pressure nozzle: Remove dirt and de- bris from the nozzle bore, using a needle and rinse through with water from the front. Check water flow quantity. Slight leakage from the appliance pump is normal. If the leakage increases contact the authorized customer service. Use Vario Power spray lance. Turn the spray lance to "Mix" position. Remove filter from suction hose for detergent and clean under running water. Check the detergent suction hose for kinks. Operation with washing brush Interrupting operation Finish operation Transport and storage When transporting by hand When transporting in vehicles Storing the Appliance Frost protection Maintenance and care Care Clean the sieve in the water connection Troubleshooting Appliance is not running Pressure does not build up in the appliance Strong pressure fluctuations Appliance is leaking No detergent infeed 10 EN– 7 Only use original accessories and spare parts, they en- sure the safe and trouble-free operation of the device. For information about accessories and spare parts, please visit www.kaercher.com. The warranty terms published by the relevant sales company are applicable in each country. We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in manufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service centre. Please submit the proof of purchase. Addresses can be found under: www.kaercher.com/dealersearch We hereby declare that the machine described below complies with the relevant basic safety and health re- quirements of the EU Directives, both in its basic design and construction as well as in the version put into circu- lation by us. This declaration shall cease to be valid if the machine is modified without our prior approval. The undersigned act on behalf and under the power of attorney of the company management. Authorised Documentation Representative S. Reiser Alfred Kärcher GmbH Co. KG Alfred-Kärcher-Str. 28 - 40 71364 Winnenden (Germany) Phone: +49 7195 14-0 Fax: +49 7195 14-2212 Accessories and Spare Parts Technical specifications Electrical connection Voltage 220-240 1~50-60

Sound pressure level L

www.kaercher.com/REACH