Futura 1363256 - Kettle RUSSELL HOBBS - Free user manual and instructions

USER MANUAL Futura 1363256 RUSSELL HOBBS

почистване на филтъра 39 Уверете се, че по ръцете Ви няма сапун или друго вещество, което може да предизвика замърсяване. 40 Изключете уреда от контакта и го оставете да се охлади. 41 Използвайте кръглата ръчка, за да отстраните капака. 42 Използвайте извития край на филтъра, за да го изтеглите от направляващите елементи, след което го извадете от каната. 43 Изплакнете филтъра под течаща вода, като същевременно го почистите с мека четка. 44 Изплакнете каната, в случай че частици котлен камък са попаднали вътре. подмяна на филтъра 45 Плъзнете го надолу в направляващите елементи. 46 Отстранете капака. внимание не използвайте каната, ако филтърът не е поставен правилно – това може да предизвика пръски от вряла вода. символ „зачеркнато кошче за боклук” За да се избегнат екологични и здравни проблеми поради наличие на опасни субстанции в електрическите и електронни стоки, уредите, обозначени с този символ, не трябва да се изхвърлят заедно с несортирани общински отпадъци, а следва да се върнат обратно, да се използват отново или рециклират.86 Read the instructions and keep them safe. If you pass the appliance on, pass on the instructions too. Remove all packaging, but keep it till you know the appliance works. important safeguards Follow basic safety precautions, including: 1 This appliance must only be used by or under the supervision of a responsible adult. Use and store the appliance out of reach of children. 2 Don’t put the kettle, stand, cable, or plug in any liquid; don’t use the kettle in a bathroom, near water, or outdoors. 3 Don’t touch hot surfaces. Use the handle. 4 Don’t use the kettle without the filter in place – it may spit boiling water 5 Don’t open the lid while the water is heating. 6 Take care when pouring – pour slowly, and don’t over-tilt the kettle. 7 The scald hazard lasts long after boiling. Keep the kettle, stand, and cable away from the edges of worktops and out of reach of children. 8 Put the stand on a stable, level surface. 9 Route the cable so it doesn’t overhang, and can’t be tripped over or caught. 10 Wind excess cable beneath the stand. 11 Unplug the stand when not in use, before moving and before cleaning. Let the kettle cool down before cleaning and storing away.87 instructions 12 Check the lid is fully closed before switching the kettle on, otherwise it may not switch off. 13 Check the kettle is properly located on the stand before switching on. 14 Don’t switch on unless the kettle contains at least 2 cups of water. 15 Don’t fill past MAX, or it may spit boiling water. 16 Remove the kettle from its stand before filling or pouring. 17 Keep the kettle, stand, cable, and plug away from sources of heat. 18 Don’t use the kettle for any purpose other than heating water. 19 Use the kettle only with the stand supplied (and vice versa). 20 This appliance must not be operated by an external timer or remote control system. 21 Don’t operate the appliance if it’s damaged or malfunctions. 22 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or someone similarly qualified, in order to avoid hazard. household use only before using for the first time Fill to MAX, boil, discard the water, then rinse. Do this three times, to remove manufacturing dust, etc. positioning 1 Put the stand on a stable, level surface. 2 Route the cable so it doesn’t overhang, and can’t be tripped over or caught. 3 Wind excess cable beneath the stand filling caution keep clear, steam may escape from the lid. 4 Remove the kettle from the stand. 5 Use the lid knob to remove the lid. 6 Fill with at least 2 cups of water, but not above MAX 7 If you overfill, the kettle may spit boiling water. 8 Replace the lid. 9 Check the lid is closed, or the kettle won’t switch off when it boils. switching on 10 Plug the stand into the wall socket. 11 Put the kettle on the stand – take care not to spill. 12 Move the switch to 1. 13 The light will come on, and the kettle will heat up. switching off 14 When the water boils the kettle will switch off and the light will go out. 15 To switch off manually, move the switch to 0. 16 Lifting the kettle off the stand will also switch the kettle off. general 17 Remove the kettle from the stand before pouring. 18 To avoid the risk of splashing, pour slowly and don’t over-tilt the kettle. 19 Don’t tilt the kettle backwards, water might get on to the control area. If this happens, let the kettle dry before use – sit it somewhere warm for 12 hours. 20 When you lift the kettle, you may see moisture on the stand. Don’t worry – it’s the steam used to switch off automatically, which then condenses and escapes via vents under the kettle. 21 You may see some discolouration on the floor of the kettle. Again, don’t worry – it’s due to the bonding of the element to the kettle floor.88 using with insufficient water 22 This will shorten the life of the element. A boil-dry cut-out will switch the kettle off. 23 To prevent the kettle cycling on and off, remove the kettle from the stand and let it cool before replacing it on the stand. 24 Sit the kettle on the work surface till it’s cold. 25 Don’t fill the kettle till it’s cold, or it may spit. care and maintenance 26 Check that the kettle is switched off – move the switch to 0. 27 Unplug the stand from the wall socket, and let the kettle cool down fully before cleaning. 28 Wipe the kettle, inside and out, with a damp cloth. You may use a little household detergent, but if you do, rinse well to avoid tainting the water. 29 Keep all connectors and sockets dry. 30 Don’t put the kettle or stand in any liquid. 31 Don’t use harsh or abrasive cleaning agents or solvents. descale regularly 32 Limescale may be white, coloured, even rusty-looking. 33 It may cause overheating, and reduce the working life of the element. It may also make the safety cutout operate prematurely, switching the kettle off before the water boils. 45 As the element is mounted beneath the kettle, scale can build up only on the walls and floor of the kettle, where it can be seen and dealt with. 46 If you see scale forming, wipe it off. 36 Descale regularly, (at least monthly) to keep your kettle in good working order. 37 Use a descaler suitable for use in plastic products (most products have plastic parts). Follow the instructions on the descaler, rinse several times, then fill, boil and discard the water, to ensure no residues are left. , Products returned under guarantee with faults due to scale will be subject to a repair charge. water filter 38 Scale particles suspended in the water may give it a cloudy or greasy appearance. The filter will prevent these particles going into your drink. If you see deposits on the filter, clean it, otherwise the performance of your kettle will drop, your drinks may contain scale, and the water inside the kettle may look cloudy. cleaning the filter 39 Check your hands are free from soap, or anything which might leave a taint. 40 Switch the kettle off, and let it cool. 41 Use the lid knob to remove the lid. 42 Use the tab on the filter to pull the filter out of the guides, then lift it out of the kettle. 43 Rinse the filter under a running tap while brushing with a soft brush. 44 Rinse the kettle, in case scale particles have fallen inside. replace the filter 45 Slide it down, into the guides. 46 Replace the lid. caution don’t use the kettle without the filter in place – it may spit boiling water wheelie bin symbol To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol mustn’t be disposed of with unsorted municipal waste, but recovered, reused, or recycled. 550-860