KA CH 1 - Heating KALORIK - Free user manual and instructions

USER MANUAL KA CH 1 KALORIK

Please read these instructions carefully before using the appliance.
Check that your mains voltage corresponds to that stated on the appliance.
Never leave the appliance unsupervised when in use. Keep out of reach of children or incompetent persons.
From time to time check the cord for damages. Never use the appliance if cord or appliance show any signs of damage.
Only use the appliance for domestic purposes and in the way indicated in these instructions.
Never immerse the appliance in water or any other liquid for any reason whatsoever. Never place it into the dishwasher.
Never use the appliance near hot surfaces.
Should the cord be damaged, it must be replaced by a competent qualified service*
Before cleaning, always unplug the appliance from the power supply.
All repairs should be made by a competent qualified service (^*)
Never use the appliance outside and always place it in a dry environment.
- Never use accessories which are not recommended by the producer. They could constitute a danger to the user and risk to damage the appliance.
Never move the appliance by pulling the cord. Make sure the cord cannot get caught in any way. Do not wind the cord around the appliance and do not bend it.
Always position the heater in such a way that inflammable materials cannot be ignited. Ensure at all times that the unit is placed solidly on its base legs. Make sure that the air inlet openings underneath the unit are not blocked.
Do not touch the housing or any of the air outlet grilles, as they become hot during operation.
Do not allow the power cord to touch any hot part of the appliance.
Do not operate the heater near any inflammable or explosive materials or vapour.
To avoid any risk of fire, do not cover the heater (ex. With clothes).
Do not leave the heater unattended during operation and keep children away. Hazards may occur, for instance when touching the heater or knocking it over, or as a result of inappropriate positioning.
Do not insert any objects through the grille or into the interior of the appliance.
Always switch off and remove the plug from the wall socket after use, and also in case of any malfunction and during cleaning. Do not attempt to remove the plug from the wall socket with wet hands.
Do not operate the heater if the unit or the power cord show any signs of damage.
No responsibility is accepted if damage results from improper use, or if these instructions are not complied with.
In order to comply with safety regulations and to avoid hazards, repairs of electrical appliances must be carried out by qualified personnel, including the replacement of the power cord. If repairs are needed, please send the appliance to one of our customer service departments.
Do not use this appliance for other than its designed purpose.
- Select a position at least 1 metre away from combustibles.
Do not locate this appliance near wall sockets.
Always switch the unit off at the power point when not in use.
Do not use double adapters or other appliances connected to an adapter with heater. Do not cover and move the appliance.
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.

• When not in use always store in a dry place.
  Do not use water or any cleaning products. Prefer a soft cloth.

(^*) Competent qualified service: after sales department of the producer or importer or any person who is qualified, approved and competent to perform this kind of repairs in order to avoid all danger. In any case you should return the appliance to this service.

UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)

This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour coded: blue = neutral, brown = live, green or green & yellow = earth.

The blue wire must be connected to the terminal marked N or coloured in black.

The brown wire must be connected to the terminal marked L or coloured in red.

The green (& yellow) wire must be connected to the terminal marked E or coloured in green (& yellow).

NOTE

1) Please read this manual carefully, and keep for reference.
2) Please open the package carefully, and keep it for reassembling.

FEATURES

The fireplace should be placed in a standard fireplace hole of 560mm height, 410mm or 460mm width. Its features:

1. Real fire effect
2. Warm wind
3. Economiser (Energy saving)

ASSEMBLING

1. The fireplace should be at least one metre from furniture, curtain or any other object.
2. Before connecting, please check whether the supplied voltage is the same as the one of the fireplace.

FRAME OF A FIREPLACE

• This heater is suitable to be assembled in the frame of a fireplace. The fireplace should be at least 160mm depth. If the hole is not standard or if it is a decorative fireplace, the distance should also be kept.
  There are two uprights at the back of the appliance to make it level. When adjusting, unscrew the uprights and, once the fireplace is level, tighten the screws again.

APPLYING:

The fireplace can be used without the heater function, which means you can appreciate the marvellous fire effect throughout the year.
As the effect is produced by two small lights and a very weak engine, it is energy saving. You can set the fire intensity depending on the room dimensions.
- Warm air is produced when the heat passes through the wind wheel and comes into the room through the protecting grid below the small iron grid.

CONTROLLING

This equipment has a power switch, an Economiser switch and a fire adjustable switch.

POWER SWITCH

The appliance can operate in 5 different modes.

FIRE ADJUSTABLE SWITCH

You can enjoy the fire effect even if the heater has been switched off.
The fire adjustable switch enables you to set the fire and light intensity.
- When in the minimum position, the fire effect and the light have a weak intensity.
- To get a higher heat, turn the switch clockwise.

ECONOMISER SWITCH

• When you chose middle heat or high heat (in low heat position energy saving does not operate), this sensible heat output controller will automatically open or close the heating element in order to keep selected heat.
  First turn the Economiser switch clockwise to the highest heat (9).
• When the room temperature reaches the requested level, turn the switch anticlockwise to lower the heat and switch off the heating elements.
• It keeps the necessary room temperature and saves energy.

MAINTENANCE

WARNING: Always disconnect the appliance before cleaning or maintenance.

Replacing the bulb

Below the fire source there are two lights. Move down the front glass plate (there are 2 screws on the slide at the part of the glass), carefully put it aside. Lightly press the middle part of the glass; lift the glass toward the front and up then move away. When taking the light bulb, firstly press the lampstand, then rotate anticlockwise and take out.

Type of bulb

2x25W small light.

When reassemble be sure to put the transparent side of the glass inside.

REMOVING THE PROTECTION GRID

Unscrew the lower part of the protection grid, it will let down slightly. Then draw the higher part of the grid to remove it. To put it back, do the opposite.

CLEANING THE REFLECTOR

• Remove the heating elements first.
  Clean the reflector with a cloth slightly damped with soapy hot water, then wipe with a soft and dry cloth.
• Do not use detergents or cleaning products.

REMOVING THE QUARTZ TUBE

It is necessary to remove the quartz tube to clean it.
- First remove the protection grid as it is described here above.
- Hold tightly one edge of the tube with a soft cloth to protect it, then pull out the tube from the insert hole.

CLEANING THE FIREPLACE

Before cleaning the appliance, make sure it is disconnected from the power supply and has cooled down completely.
- The housing may be wiped with a slightly damp, lint-fee cloth.
- Do not use detergents or cleaning products.
- If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum cleaner.

MODE D'EMPLOI

POUR VOTRE SECURITE

INSTALLATIE IN DE SCHOUWOPENING