HL 3651 - Electric heater CLATRONIC - Free user manual and instructions

USER MANUAL HL 3651 CLATRONIC

Black and yellow photo of a black ceramic heating fan with mesh grille and yellow handle (no visible text or symbols)

Overview of the Components....Page 3
Instruction Manual......Page 25
Technical Data Page 28
Disposal Page 28

JEZYK POLSKI

Spis treści

Thank you for choosing our product. We hope that you enjoy using the appliance.

Symbols in these Instructions for Use

Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine:

WARNING:

This warns you of dangers to your health and indicates possible injury risks.

CAUTION:

This refers to possible hazards to the machine or other objects.

NOTE: This highlights tips and information.

General Notes

Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use.
• Do not use it outdoors. Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull the plug itself, not the lead) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you leave the room you should always turn the device off. Remove the plug from the socket.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Use only original spare parts.
• In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

WARNING:

Do not allow small children to play with the foil. There is a danger of suffocation!

Special Safety Instructions for this Device

Symbols on the Product

On the products you will find symbols that indicate warnings or provide information:

WARNING:

In order to prevent overheating, the radiator must not be covered.

WARNING:

• Some parts of the product can become very hot and cause burns. Avoid contact with the skin. Carry the appliance by its handle.
• You must be particularly careful when children and vulnerable persons are present.

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given

supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Children younger than 3 years of age should be kept away from the appliance, unless they are supervised at all times.

- Children from the age of 3 and younger than 8 years of age may only turn the appliance on and off if they are supervised, or have been instructed with regard to the safe use of the appliance, and if they have understood the risks resulting from it, provided that the appliance has been placed and installed in its normal position of use.

- Children from the age of 3 and younger than 8 years of age may not insert the plug into the socket, may not clean the appliance and/ or may not perform the maintenance by the user.

- Please keep a safety distance of at least 90 cm between all sides of the device and furniture and other objects.

- Under no circumstances may the radiator be used in rooms with explosive gas (e.g. petrol) or while work is being carried out with inflammable adhesives or solvents (e.g. when gluing or painting parquet, PVC etc).

- Do not insert any objects into the radiator.

- Ensure that a safety distance is maintained between the power cord and the housing.

- Do not use the radiator in the open air.

- Do not use the radiator in close proximity to bathtubs, showers or swimming pools.

• The radiator should not be placed directly below a mains power socket.
• Do not try to repair the appliance on your own. Always contact an authorized technician. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

Overview of the Components

1 Handle
2 Function control knob
2a = 0ff
2b = Fan
2c = 1000 Watt
2d =2000 Watt
3 Function indicator lamp
4 Temperature control
5 Knurled screws
6 Stand
7 Protective grille

Notes on use

Unpacking the appliance

1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding, cable holders and cardboard.
3. Fully unwind the cable.

i NOTE:

There might be dust and production residue present on the appliance. We recommend cleaning the device as described under "Cleaning".

Position

CAUTION:

The appliance may tip over onto its front, blocking the air flow.

Always set the appliance onto the stand. The ideal position is a non-slip, flat surface.

Electric connection

1. Make sure the voltage of the appliance (see rating label) matches the mains voltage to be used.
2. Set the control knob to O.
3. Connect the mains plug to a properly installed isolated ground socket.

Connected load

The appliance supports a power input of 2000 W.

CAUTION: Overload:

• When using an extension cord, it must have a cable cross-section of at least 1.5 ~mm^2 .
• Do not use multi-outlet power strips, since this appliance is too powerful.
• Do not connect any other powerful devices to the same electric circuit.

Operation

Setting the temperature

The thermostat constantly switches the radiator on and off, thereby keeping the temperature at the desired level. Set the desired temperature as followed:

1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached, slowly turn the temperature control back, until the radiator switches off audibly. The indicator lamp turns off.

i NOTE:

The audible position of the temperature control depends on the ambient temperature.

1. The radiator will then keep the desired temperature level.

CAUTION:

When not using the appliance, disconnect the mains plug.

Adjusting the inclination angle

Do you want to change the inclination angle?

Proceed as follows:

1. Loosen the knurled screws slightly by turning them counterclockwise, so that you can move the housing.

i NOTE:

Only loosen the knurled screws. Otherwise the housing will fall off the stand.

1. Swivel the housing to the desired position.
2. Fix the housing by tightening the knurled screws again.

Fan operation

If you want to use the device as a fan, turn the function control knob to the fan icon and turn the temperature control to highest position.

Stop operation

Stop operation by setting the control knob to the ○ position. The indicator lamp turns off. Then disconnect the mains plug from the socket.

Overheat protection

The device features an overheat protection mechanism causing the device to switch off automatically in case of overheating.

1. Turn the function control knob to ○ position and disconnect the mains plug from the socket.
2. Let the appliance cool down for approx. 10 minutes before using it again.

NOTE:

If the overheat protection mechanism causes the appliance to switch off again after a short period, this might indicate a defect.

1. Switch off the appliance and disconnect it from the mains.
2. Have the appliance checked by your dealer or our customer service.

Cleaning

WARNING:

• Always disconnect from the mains before cleaning and wait until the appliance has cooled down.
- Never immerse the appliance in water to clean it. This may lead to electrical shock or fire.

CAUTION:

• Do not use wire brushes or other abrasive materials.

• Do not use caustic or scouring agents.

• Wipe away dust with a dry cloth.

• Flecks can be removed with a suitably damp cloth.

Dust on the protective grilles

Accumulation of dust on the protective grilles can lead to overheating.

• Remove the dust by careful brushing,
• or use the upholstery nozzle of your vacuum cleaner to remove the dust.

Technical Data

Model: HL 3651

Power supply: 220-240V\~, 50Hz

Power consumption: 2000 W

Protection class: I

Net weight:......approx. 1.64 kg

The right to make technical and design modifications in the course of continuous product development remains reserved.

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Disposal

Meaning of the "Dustbin" Symbol

Protect our environment: do not dispose of electrical equipment in the domestic waste.

Please return any electrical equipment that you will no longer use to the collection points provided for their disposal.

This helps avoid the potential effects of incorrect disposal on the environment and human health.

This will contribute to the recycling and other forms of re utilisation of electrical and electronic equipment.

Information concerning where the equipment can be disposed of can be obtained from your local authority.

Instrukcja obsługi

CTC Clatronic Sp. z o.o