B415P - Blender FAGOR - Free user manual and instructions

USER MANUAL B415P FAGOR

NOTA: NUNCA MERGULHE O CORPO

Please read this manual carefully before using the blender for the first time and keep it handy for any later consultation. This will ensure that you obtain the best results with the maximum safety.

Before using the blender check that the mains voltage is the same as that shown on the blender.

If the electricity socket and the blender plug are incompatible, change the socket for a suitable one by contracting a professionally qualified electrician.

We do not advise you to use adapters, plugs or extension cables. If such a device is indispensable, use only single or multiple adapters and extension

(Fig.1) cables that comply with current safety standards, taking care not to surpass the capacity shown on the adapter and/or the extension cable.

After unpacking, check that the blender is in a perfect condition; if in doubt, contact the nearest Service Centre.

The packaging (plastic bags, polystyrene foam, etc.) should not be left within reach of children, as it is a potential source of danger.

This blender should be employed solely for domestic use. Use for any other purpose is considered inadequate and dangerous.

In the event of the blender breaking down or malfunctioning, switch it off and do not attempt to repair it.

If the blender needs repairing, only use a Service Centre authorised by the manufacturer and request that original spares are used. If this advice is not followed, the safety of the blender may be compromised.

Do not change the cable. If it is broken or needs to be changed, contact a Service Centre authorised by the manufacturer. Do not use the blender when the cable or plug is damaged.

The manufacturer will not be liable for any damage that may arise from inappropriate, erroneous or improper use or from repairs carried out by unqualified persons. When using any electrical appliance, certain fundamental rules must be followed. ESPECIALLY

• Do not touch or pull the cable with wet or damp hands or feet.

To prevent electric shocks, do not immerse the appliance or the cable or the plug in water or put it under the tap.

Do not touch the blade whilst the blender is in operation.

The whisk should be fitted or removed only when the appliance is unplugged.

Do not allow the cable to hang over the edge of a table or work-surface or to

B-415 P 400 W B-515 M B-575 MA 500 W B-615 M B-675 MA 600 Wpositioning marks and pressing it into the motor body (3) until you hear a click. (Fig.2) NOTE: To remove the blender stem, press the removal button (14). After adjusting the blender stem (4), plug in the appliance. Place the food you wish to blend in a suitable container, and position the blender as shown in figure 7. Press the On/Off switch (1). On models B-615M and B-675 MA, select the speed by turning the speed controller (7). If you wish, you may press the turbo button (2) to blend at top speed. IMPORTANT: Do not use the plastic blender stem (model B-415 P only) to blend any food at a temperature of over 60ºC. Egg white beating function (mod. B-575MA, B-675MA) Insert the egg white beater into the blender coupler until it fits into place (fig.5). Then fit it to the blender body by aligning the positioning marks and pressing it in until you hear a click (fig. 6). Place the blender in the container, plug in the appliance and press the On/Off button to start beating the egg whites. Use the speed controller to select a speed (models B-615M and B-675 MA), or press the turbo function button. You may use the glass (13) or another type of container for beating the egg whites. Mincing function (mod. B-575 MA, B-675 MA) The mincer can be used for fruit and nuts, herbs, boiled eggs, dry bread, etc. Place the mincer blade (12) in the centre of the bowl (fig. 3). Place the ingredients you wish to mince in the mincer bowl. Place the mincer lid (10) on the mincer jug, making sure it is correctly aligned with the mincer blade. Insert the motor body (3) in the mincer lid (3) by aligning the positioning marks and pressing it in until you hear a click (Fig. 4). Plug in the appliance and press the On/Off button. Use the speed controller (7) to select a speed (models B-615M and B-675 MA only) or press the turbo button (2) for quicker mincing. When you have finished mincing the food, make

come into contact with hot surfaces.

Do not pull the cable to unplug the appliance.

Unplug the blender when it is not in use, before fitting or removing the mixer base and before cleaning it.

Do not allow children to use the appliance.

Before connecting the blender, ensure that the mixer base is correctly fitted to the appliance.

Do not use or place any part of the blender on or near to hot surfaces (gas or electric hotplates or ovens).

This appliance should not be used by physically, sensorially or mentally handicapped people or people without experience or knowledge of it (including children), unless they are supervised or instructed in the use of the appliance by a person responsible for their safety.

Children should be watched to ensure they do not play with the appliance.

For greater protection, we recommend installing a residual current device (RCD) with an operational residual current not exceeding 30 mA. Ask your installer for advice. Preparing for use This blender is designed to process small quantities of foodstuff and should not be used for any other purpose. Before using for the first time, clean the casing of the motor with a damp cloth. Wash the shaft and the blade in hot, soapy water; do not immerse the upper part of the shaft. Dry all the pieces thoroughly. IMPORTANT: Before fitting or removing any of the parts of this blender, unplug it from the mains. Blender function The blender can be used to blend light foods, for making sauces, soups, mayonnaise or puree, for example. Insert the blender stem (4) by aligning the

sure you remove the blade from the bowl before taking the food out. Cleaning and maintenance Disconnect the blender and unplug it from the mains before carrying out any maintenance or cleaning. Wash all the accessories immediately after use in order to prolong their useful life. Take care when handling the blades, as they are very sharp, and keep them out of the reach of children. The jugs (11 and 13) and the egg whisk (9) are dishwasher safe. The rest of the components are not dishwasher-safe. Use a damp kitchen cloth to clean all external parts.

COUPLER OR THE BLENDER STEM. Do not allow the cord to hand over the edge of tables or work surfaces, and do not place it on hot surfaces. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. To remind you that you must collaborate with a selective collection scheme, the symbol shown appears on the product warning you not to dispose of it in traditional refuse containers. For further information, contact your local authority or the shop where you bought the product.

5. INFORMATION FOR THE CORRECT

DISPOSAL OF ELECTRICAL AND