HT 6010 SEVERIN

HT 6010 - Sèche-cheveux SEVERIN - Free user manual and instructions

Find the device manual for free HT 6010 SEVERIN in PDF.

Page 7
Manual assistant
Powered by ChatGPT
Waiting for your message
Product information

Brand : SEVERIN

Model : HT 6010

Category : Sèche-cheveux

Download the instructions for your Sèche-cheveux in PDF format for free! Find your manual HT 6010 - SEVERIN and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HT 6010 by SEVERIN.

USER MANUAL HT 6010 SEVERIN

Instructions for use

Before using the appliance, the user should

read the following instructions carefully.

Connection to the mains supply

The hair dryer should only be connected to

a socket installed in accordance with the

Make sure that the supply voltage

corresponds with the voltage marked on the

rating label of the hair dryer.

This product complies with all binding CE

labelling directives.

6. Air intake openings

9. Power cord with plug

Important safety instructions

● Caution: do not use the

appliance in the vicinity of a

bath, shower or swimming-

pool, over a washbasin filled

with water or near any other receptacle

Protect the appliance from moisture and

splashing water and do not operate it

● In the vicinity of any water source, there

is a risk even when the appliance is

switched off. Therefore, always remove

the plug from the wall socket after use,

especially if the appliance is being used in

For additional protection, the installation

of a residual current device (RCD)

having a rated residual operating current

not exceeding 30 mA is advisable in the

electrical circuit supplying the bathroom.

Ask your installer for advice.

● Electric heating appliances operate at

very high temperatures. Do not touch

any part of the appliance except the grip.

Otherwise there is a real risk of burning.

● Do not use the appliance on synthetic

hair-pieces or wigs, as the heat emitted

might cause damage to the synthetic

● Make sure the air intake and outlet

openings are not blocked (e.g. by fingers

or hair), and that no fluff or fibre

particles are allowed to accumulate in the

A blockage in the air-flow system may

cause the integral thermal safety cut-out

to switch off the appliance. Should this

occur, immediately disconnect the

appliance from the mains power and

allow sufficient time for it to cool down

before the blockage is removed and the

appliance is switched on again.

● Every time the appliance is used, the

main body including the power cord as

well as any attachment fitted should be

checked thoroughly for any defects.

Should the appliance, for instance, have

been dropped onto a hard surface, it

must no longer be used: even invisible

damage may have adverse effects on the

operational safety of the appliance.

● To prevent damage to the power cord,

- do not bend or kink the cable,

especially where it leaves the housing,

- do not pull on the cord,

- do not coil the power cord around the

● Do not leave the appliance unattended

● Always switch off and remove the plug

from the wall socket after use, as well as

- in cases of malfunction, and

● When removing the plug from the wall

socket, never pull on the power cord;

always grip the plug itself.

7● Do not place the appliance on any

surfaces sensitive to heat during or

immediately after use.

● This appliance is not intended for use by

any person (including children) with

reduced physical, sensory or mental

capabilities, or lacking experience and

knowledge, unless they have been given

supervision or instruction concerning the

use of the appliance by a person

responsible for their safety.

● Children should be supervised to ensure

that they do not play with the appliance.

● No responsibility will be accepted if

damage results from improper use, or if

these instructions are not complied with.

● This appliance is intended for domestic

use only and not for commercial

● In order to comply with safety

regulations and to avoid hazards, repairs

of electrical appliances must be carried

out by qualified personnel, including the

replacement of the power cord. If repairs

are needed, please send the appliance to

one of our customer service departments.

The addresses can be found in the

appendix to this manual.

The IONIC function facilitates gentle, easy

hair styling by preventing a static charge in

the hair. It uses the build-up of a negative

‘ion-cloud’ to prevent ‘flyaway’ hair caused

by a positive charge.

The IONIC function is enabled while the

indicator light is on. With the cool function

activated, or with the air temperature and air

flow controls set to position 1, the IONIC

function is automatically disabled.

The styling nozzle can be fitted to the air

outlet to facilitate shaping the hair during

Air-flow and temperature controls

By using different combinations of the air-

flow and temperature controls, various

settings are possible when drying the hair.

The air-flow control regulates the air-flow

intensity, while the temperature control

regulates the heat of the air-flow.

With the air-flow control set to the ‘0’-

position, the hair-dryer is switched off.

The cool function can be used at any time

during the drying process. It will supply

cooler air, which helps firming and shaping

Connect the hair dryer to a suitable wall

socket and select the desired power setting

with the switches integrated in the handle.

● Before cleaning the hair dryer, remove

the plug from the wall socket and let the

appliance cool down completely.

● To avoid the risk of electric shock, do not

clean the hair dryer with water nor

immerse it in water.

If necessary, the housing of the hair dryer

may be wiped with a dry lint-free cloth.

Always check the air intake openings for

accumulated lint particles or hair and - if

necessary - remove any found.

To facilitate cleaning, the grille on the air

intake can be removed by turning it anti-

clockwise and then lifting it off. After

cleaning, replace the grille and lock it by

Do not dispose of old or defective

appliances in domestic garbage;

this should only be done through

public collection points.

This product is guaranteed against defects in

materials and workmanship for a period of

two years from the date of purchase. Under

this guarantee the manufacturer undertakes

8to repair or replace any parts found to be

defective, providing the product is returned

to one of our authorised service centres. This

guarantee is only valid if the appliance has

been used in accordance with the

instructions, and provided that it has not

been modified, repaired or interfered with

by any unauthorised person, or damaged

This guarantee naturally does not cover

wear and tear, nor breakables such as glass

and ceramic items, bulbs etc. If the product

fails to operate and needs to be returned,

pack it carefully, enclosing your name and

address and the reason for return. If within

the guarantee period, please also provide the

guarantee card and proof of purchase.

9Chère Cliente, Cher Client,

Bahar Administration and

No. 668, 7th Floor, Ave.

Serbia and Montenegro