EW7722UTn V2 - Network card / adapter Edimax - Free user manual and instructions
Find the device manual for free EW7722UTn V2 Edimax in PDF.
User questions about EW7722UTn V2 Edimax
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Network card / adapter in PDF format for free! Find your manual EW7722UTn V2 - Edimax and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. EW7722UTn V2 by Edimax.
USER MANUAL EW7722UTn V2 Edimax
No. 278, Xinhu 1st Rd., Neihu Dist., Taipei City, Taiwan
Email: support@edimax.com.tw
Edimax Technology Europe B.V.
Fijenhof 2, 5652 AE Eindhoven, The Netherlands
Email: support@edimax.nl
Edimax Computer Company
3444 De La Cruz Blvd., Santa Clara, CA 95054, USA
Live Tech Support: 1(800) 652-6776
Email: support@edimax.com
Multi-Language Quick Installation Guide (QIG) on the CD
Please key the PIN code into your AP's config page
PIN: 57099071
| SSID | Channel | Security | BSSID |
| !PTLLin-2.4G | 2 | WPA2-PSK AES... | 801f0275e723 |
| OBM-SMB-2.4G | 6 | WPA(2)-PSK AES... | 106f3fd00a40 |
| EDIMAX | 11 | No Encryption | 801f023c0e66 |
| 2.4G testing | 13 | No Encryption | 801f0289c13c |
| OBM-AirPort | 6 | WPA(2)-PSK AES... | 801f0288122a |

Copyright © Edimax Technology Co., Ltd. all rights reserved. No part of this publicaon may be reproduced, transmied, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnec, opcal, chemical, manual or otherwise, without the prior wien permission from Edimax Technology Co., Ltd.
Edimax Technology Co., Ltd. makes no representations or warranties, either expressed or implied, with respect to the contents thereof and specifically disclaims any warranties, merchantability, or tness for any parcular purpose. Any soware described in this manual is sold or licensed as is. Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the enre cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the soware. Edimax Technology Co., Ltd. reserves the right to revise this publicaon and to make changes from me to me in the contents thereof without the obligaon to nofy any person of such revision or changes.
The product you have purchased and the setup screen may appear slightly dierent from those shown in this QIG. The soware and specicaons are subject to change without noise. Please visit our website www.edimax.com for updates. All brand and product names menoned in this manual are trademarks and/or registered trademarks of their respecve holders.
Federal Communicaon Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parscular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio technician for help.
FCC Cauon
This device and its antenna must not be co-located or operang in conjunction with any other antenna or transmier. This device complies with Part 15 of the FCC Rules. Operaoon is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operaon. Any changes or modicaons not expressly approved by the party responsible for compliance could void the authority to operate equipment.
Federal Communicaons Commission (FCC) Radian Exposure Statement
This equipment complies with FCC radiaon exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 0.5cm during normal operation.
Federal Communicaons Commission (FCC) RF Exposure Requirements
SAR compliance has been established in the laptop computer(s) congueraons with PCMCIA slot on the side near the center, as tested in the applicaon for cercaon, and can be used in laptop computer(s) with substantially similar physical dimensions, construcon, and electrical and RF characteriscs. Use in other devices such as PDAs or lap pads is not authorized. This transmier is restricted for use with the specic antenna tested in the applicaon for cercaon. The antenna(s) used for this transmier must not be co-located or operang in conjunction with any other antenna or transmier.
RED Compliance Statement
Compliance with 2014/53/EU Radio Equipment Directive (RED)
In accordance with Arcle 10.8(a) and 10.8(b) of the RED, the following table provides informaon on the frequency bands used and the maximum RF transmit power of the product for sale in the EU:
| Frequency range (MHz) | Max. Transmit Power (dBm) |
| 2400-2483.5 | 19.98 |
A simplified DoC shall be provided as follows: Arcle 10(9)
Hereby, Edimax Technology Co., Ltd. declares that the radio equipment type 300N Wireless LAN USB Adapter is in compliance with Direcve 2014/53/EU
The full text of the EU declaration of conformity is available at the following internet
address: http://www.edimax.com/edimax/global/
Safety
This equipment is designed with the utmost care for the safety of those who install and use it. However, special aenon must be paid to the dangers of electric shock and stac electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all mes to ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and oce use in Austria, Belgium, Bulgaria, Cyprus, Czech, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Turkey, and United Kingdom. The ETSI version of this device is also authorized for use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries Not Intended for Use None
EU Declaeron of Conformity
English: This equipment is in compliance with the essenai requirements and other relevant provisions of Direcve 2014/53/EU, 2014/35/EU.
WEEE Direcve & Product Disposal

At the end of its serviceable life, this product should not be treated as household or general waste. It should be handed over to the applicable collecon point for the recycling of electrical and electronic equipment, or returned to the supplier for disposal.
Declarao n of Conformity
We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies with the requirements of the European Radio Equipment directives.
Equipment: 300N Wireless LAN USB Adapter
Model No.: EW-7612UAn V2
The following European standards for essenal requirements have been followed:
Directives 2014/53/EU
Spectrum : EN 300 328 V2.1.1 (2016-11)
EMC : Dra EN 301 489-1 V2.2.0 (2017-03)
Dra EN 301 489-17 V3.2.0 (2017-03)
EMF : EN 62311:2008
Safety (LVD): IEC 62368-1:2014 ( 2^nd Edion) and/or EN 62368-1:2014+A11:2017
Edimax Technology Europe B.V.
Fijenhof 2,
5652 AE Eindhoven,
The Netherlands
a company of:
Edimax Technology Co., Ltd.
No. 278, Xinhu 1st Rd.,
Neihu Dist., Taipei City,
Taiwan
Printed Name: David Huang
Title: Director
Edimax Technology Europe B.V.
CE
Date of Signature: Nov., 2020
Signature:

Printed Name:
Albert Chang
Title:
Director
Edimax Technology Co., Ltd.
EasyManual