HTD 2940 - CLATRONIC - Free user manual and instructions

USER MANUAL HTD 2940 CLATRONIC

General Safety Instructions •

GB Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing.

The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. Do not operate the machine without supervision. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance. Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged. Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Use only original spare parts. Pay careful attention to the following “Special Safety Instructions“.

Special safety instructions for this device

Keep the device away from water and moisture such as, for example, bath tubs, shower areas or even persons taking a bath! Such situations constitute a DANGER TO LIFE! through electric shock.

Attention: The nozzles become hot during operation. If the hair dryer is used in the bathroom, remove the mains plug after use as water represents a hazard. This also applies when the hair dryer is switched off. As additional protection we recommend the installation of a fault current protection device (RCD) with a rated current of not more than 30 mA in the wiring system of the bathroom. Please contact an authorised electrician for advice.

6....-05-HTD 2940 23

01.12.2004, 10:05:16 Uhr

1. Fully unwind the mains cable.

2. Fit on a nozzle. You can dry single hair locks by concentrating the flow of hot air with the hairdressing nozzle. The diffuser is the ideal solution to dry curly hair without losing volume. 3. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. 4. Setting the Temperature Level (right switch): Position 1: Position 2: Position 3:

cold air medium temperature for gentle drying and shaping high temperature for rapid drying

Setting the desired blower strength (left switch):

Position 0: Position 1: Position 2:

OFF gentle stream of air strong stream of air

With this switch it is possible to interrupt the heating process so that the air can be mixed according to individual requirements.

TURBO button: By pressing the turbo button you can increase the air current even further.

Before cleaning remove the mains lead from the socket.

Clean the housing with a soft, dry cloth without additives.

Please clean the grill on the air intake side of the hairdryer regularly in order to avoid excessive temperatures as a result of heat accumulation.

To do so, please remove the cover of the grill by means of the recess on the top of the hairdryer. Remove any dirt that is present. If necessary, a fine brush can be used. Then close the cover again carefully.

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

6....-05-HTD 2940 24

01.12.2004, 10:05:17 Uhr

GB The device supplied by our Company is covered by a 24 month guarantee starting on the date of purchase (receipt).

During the life of the guarantee any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee! Proof of the guarantee is provided by the proof of purchase. Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. In such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e.g. motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc.) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid! The guarantee lapses in case of unauthorized tampering.

After the expiry of the guarantee

After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs.

6....-05-HTD 2940 25

01.12.2004, 10:05:17 Uhr