HPS 2777 - Hair dryer CLATRONIC - Free user manual and instructions

USER MANUAL HPS 2777 CLATRONIC

General Safety Instructions

GB

• Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing.
• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water.
• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead).
• To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
  Use only original spare parts.
  Pay careful attention to the following "Special Safety Instructions".

Special safety instructions for this device

• Keep the device away from water and moisture such as, for example, bath tubs, shower areas or even persons taking a bath! Such situations constitute a DANGER TO LIFE! through electric shock.
• ATTENTION: The nozzles become hot during operation.
• Do not put objects, hair or your hands in front of the air intake opening! The device can suffer damage despite the overheating protection if the airflow is blocked!
• As additional protection we recommend the installation of a fault current protection device (RCD) with a rated current of not more than 30mA in the wiring system of the bathroom. Please contact an authorised electrician for advice.

GB

Initial and General Use of the Hair Dryer

1. Fully unwind the mains cable.
2. Attach a nozzle if required. You can dry single hair locks by concentrating the flow of hot air with the hairdressing nozzle.
3. Insert the plug into a duly installed 230V / 50Hz protective contact socket.
4. Shift the switch on the handle to one of the desired heat/blowing levels:

Level 0: off

Level 1: medium airflow and medium temperature

Level 2: strong airflow and high temperature

1. After use shift the switch to position 0 and pull out the plug. Leave the device to cool before putting it away!

COOL-Shot:

With this switch it is possible to interrupt the heating process so that the air can be mixed according to individual requirements.

Initial and General Use of the Curling Tongs

1. Fully unwind the mains cable.
2. Ensure that the round brush is fixed firmly in place.
3. Insert the plug into a duly installed 230V / 50Hz protective contact socket.
4. When your have dried your hair with a towel (no longer wringing wet), turn it evenly around the round brush or shape your hair with the curler switched on as desired.

The curling tongs will put your hair back into shape.

1. Setting the Temperature Level

Position 1: medium temperature for gentle drying and shaping

Position 2: high temperature for rapid drying

1. In order to unwind a curl, press the button above the operating switch.
2. After use, turn the switch to the "0" position and then remove the mains plug.

Allow the device to cool down before storing it away!

Cleaning and care

Hair dryer

Removing the air suction cover:

• Remove the cover after turning the cap through approximately 10 degrees against a clockwise direction.
• Clean the air suction opening from time to time with a fine brush.
• Clean the housing with a soft, dry cloth without additives.

Curling tong

Clean the air suction opening from time to time with a fine brush.
- Clean the housing with a soft, dry cloth without additives.
In order to remove this, take hold of the handle and pull the round brush off.

• The round brush can be cleaned with a suitable object (comb or brush).
• Insert the round brush back into the device in the reverse order.

GB

Do not immerse the device in water!

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month guarantee starting on the date of purchase (receipt).

During the life of the guarantee any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee!

Proof of the guarantee is provided by the proof of purchase. Without proof of purchase no free replacement or repair will be carried out.

If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt.

*) Damage to accessories does not mean automatic free replacement of the whole machine. In such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge.

Defects to consumables or parts subject to wearing (e.g. motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc.) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!

The guarantee lapses in case of unauthorized tampering.

After the expiry of the guarantee

After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs.

PL