58G077 - Saw Graphite - Free user manual and instructions
Find the device manual for free 58G077 Graphite in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Circular saw |
| Brand | Graphite |
| Model | 58G077 |
| Blade diameter | 165 mm |
| Nominal power | 1200 W |
| Supply voltage | 230 V ~ 50 Hz |
| No-load speed | 5000 rpm |
| Maximum cutting depth (90°) | 54 mm |
| Maximum cutting depth (45°) | 36 mm |
| Dimensions (L x W x H) | 300 x 220 x 250 mm |
| Weight | 4.2 kg |
| Power cable length | 2 m |
| Sound pressure level (LpA) | 92 dB(A) |
| Sound power level (LwA) | 103 dB(A) |
| Vibration (total value) | 3.2 m/s² |
| Safety device | Blade brake, two-hand switch |
| Maintenance and cleaning | Clean after each use, check blade tightening |
| Spare parts and repairability | Blade, carbon brushes, guide shoe available |
| Warranty | 2 years |
Frequently Asked Questions - 58G077 Graphite
How to change the blade of the Graphite 58G077 saw?
Unplug the tool, then use an Allen key to loosen the central screw. Remove the old blade and install the new one respecting the indicated rotation direction. Tighten the screw firmly.
What is the maximum cutting depth of this saw?
The maximum cutting depth is 54 mm at 90° and 36 mm at 45°.
How to adjust the cutting depth?
Loosen the depth adjustment knob located at the back of the shoe, adjust to the desired depth using the graduated scale, then retighten the knob.
Can I use the saw to cut metal?
No, this saw is designed only for wood and wood-derived materials. Using it on metal would damage the blade and the tool.
What to do if the blade jams during cutting?
Immediately release the switch. If the blade is stuck, unplug the saw and carefully remove the workpiece. Check the blade condition and the cleanliness of the guide.
How to maintain the carbon brushes?
The carbon brushes should be checked every 50 hours of use. If worn to less than 5 mm, replace them with original Graphite brushes.
The saw does not start, what to do?
First check that the plug is properly connected and that the cable is not damaged. Make sure the blade brake is not activated. If the problem persists, contact customer service.
How to change the carbon brushes?
Unplug the tool, remove the brush holder caps using a screwdriver, take out the worn brushes and insert the new ones. Refit the caps.
What type of blade to use for a clean cut?
Use a fine-tooth blade (40 teeth or more) for clean cuts in softwood. For hardwood, a carbide blade with 24 teeth is suitable.
Where to find the serial number of the tool?
The serial number is on a rating plate attached to the motor housing of the saw.
User questions about 58G077 Graphite
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Saw in PDF format for free! Find your manual 58G077 - Graphite and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 58G077 by Graphite.
USER MANUAL 58G077 Graphite
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Graphite
Model : 58G077
Category : Saw