Question 1

Can the Deville C07335 stove be installed recessed into a drywall partition?

Accepted Answer

It is not possible to recess the Deville C07335 stove directly into a drywall partition. Indeed, this appliance requires a minimum safety distance of 30 cm (300 mm) between the stove and any combustible material, including drywall.

Here are the important points to remember for installation:

Safety distance: The stove must be installed at least 30 cm away from any combustible surface.
No direct recessing: Since drywall is a combustible material, it should not be in contact with or too close to the appliance.
Thermal protection: If the stove is near a combustible wall, a thermal protection screen must be installed to prevent any fire risk.

In summary, the stove must remain protruding from the drywall partition, with sufficient free space or appropriate protection to ensure a safe installation that complies with standards.

Question 2

What are the dimensions of the glass of the DEVILLE CO7782 stove?

Accepted Answer

The glass of the DEVILLE CO7782 stove is designed to provide good visibility of the fire while ensuring optimal safety. Here are the approximate dimensions of the glass:

Height: approximately 35 cm
Width: approximately 30 cm

These dimensions may vary slightly depending on the exact model or manufacturing tolerances. For an accurate measurement, you can use a tape measure directly on the glass of your appliance.

Question 3

How do I adjust the thermostat on the DEVILLE C07867 stove?

Accepted Answer

The DEVILLE C07867 stove is equipped with a thermostat that allows for precise and comfortable control of the ambient temperature. Here’s how to use this setting:

Thermostat Adjustment

Location of the thermostat: The thermostat is usually found on the control panel of the stove, in the form of a rotary knob or a digital display with buttons.
Setting the temperature: Turn the knob or use the buttons to select the desired temperature in the room. This temperature is expressed in degrees Celsius.
Automatic operation: Once the temperature is set, the stove automatically adjusts its power to maintain that temperature. When the room reaches the defined temperature, the stove reduces its power or goes into standby mode to save energy.
Manual mode (if available): Some models allow you to disable the thermostat and manually adjust the heating power. Check if your model offers this option for more direct control.

This system ensures optimal comfort while optimizing the energy consumption of your DEVILLE C07867 stove.

Question 4

Does the deflector of the DEVILLE C07787 - 05-10 heater have several adjustable positions?

Accepted Answer

The deflector of the DEVILLE C07787 - 05-10 heater is designed to direct the flow of warm air. Depending on the model, it may have several positions allowing you to adjust the direction of the heat.

For this specific model:

The deflector can generally be adjusted manually by tilting the front grille.
It offers several fixed positions to direct the heat upwards, downwards, or straight ahead.
This adjustment allows for optimizing the heat distribution according to the room configuration.

It is important to handle the deflector with care to avoid damaging the moving parts.

Question 5

How to install the deflector on a DEVILLE C07832 - 04-05 appliance?

Accepted Answer

To install or reassemble the deflector on your DEVILLE C07832 - 04-05 insert, you need to perform the operations in the reverse order of disassembly. The deflector of this fireplace insert model is installed by guiding its front part towards the slides or fixing points before lowering it completely.

Before any intervention, make sure that the appliance is completely turned off and cooled down, this is imperative for safety reasons.

Steps to install the deflector:

Position the front part of the deflector towards the guides or fixing points located at the front of the insert
Gradually lower the rear part of the deflector by guiding it so that it engages correctly in its rear holding points
Check that the deflector is properly in place and stable, with no lateral or vertical movement

The deflector serves an essential function on your DEVILLE insert: it creates a secondary air zone that protects the ceramic glass from direct contact with the smoke and improves the combustion of the wood. Therefore, it is important that it is correctly positioned.

During regular maintenance, you will need to disassemble the deflector to clean the secondary air zone and the air intake grille. To disassemble, lift the deflector and pull it forward, then let the rear part drop before completely removing it. Reassembly is done by reversing this procedure.

If you are installing this insert for the first time, refer to the complete assembly instructions provided in the specific manual supplied with the appliance. Any installation must comply with safety standards and be carried out according to the manufacturer's instructions.

User manual DEVILLE : user manuals and guides in PDF

Models DEVILLE most viewed

Browse manuals DEVILLE by appliance type

Recent questions about devices DEVILLE