How to remove the wing of the ROBBE Air Beaver

Q: How to remove the wing of the ROBBE Air Beaver

Wing attachment system : the wing of the ROBBE Air Beaver is attached by two bilateral clips located on each side of the fuselage. It clicks into place with an audible locking mechanism. Disassembly procedure : Locate the two clips on the sides of the fuselage (refer to Figure 12 of the manual) Gently pull the wing outward with a steady and constant motion You will feel and hear the wing disengage from the two clips (this is the reverse of the assembly process shown in Figure 14) Once the wing is removed, check the clips and fuselage to ensure they are not damaged Important tip : if the wing is difficult to remove, do not force it. Check that the servo rods and control cords are not stuck - they should pass freely through the front opening of the fuselage, as shown in Figure 13. Refer to Figure 14 to understand the locking mechanism properly.

Question

Accepted Answer

Wing attachment system: the wing of the ROBBE Air Beaver is attached by two bilateral clips located on each side of the fuselage. It clicks into place with an audible locking mechanism.

Disassembly procedure:

Locate the two clips on the sides of the fuselage (refer to Figure 12 of the manual)
Gently pull the wing outward with a steady and constant motion
You will feel and hear the wing disengage from the two clips (this is the reverse of the assembly process shown in Figure 14)
Once the wing is removed, check the clips and fuselage to ensure they are not damaged

Important tip: if the wing is difficult to remove, do not force it. Check that the servo rods and control cords are not stuck - they should pass freely through the front opening of the fuselage, as shown in Figure 13. Refer to Figure 14 to understand the locking mechanism properly.

User manual ROBBE : user manuals and guides in PDF

Models ROBBE most viewed

Browse manuals ROBBE by appliance type

Recent questions about devices ROBBE