Q: Why does the refrigerator make a clicking noise at startup?

The clicking or popping noise you hear when you plug in your FAGOR FFJ6825N refrigerator is completely normal. It is the compressor starting up , an essential component for the circulation of the refrigerant R600A. This noise is particularly noticeable during the first startup, as the compressor activates an electrical relay to begin its operation. The occasional clicking sounds that follow during operation are also normal. To minimize this noise: Ensure that the appliance is level and stable on the floor. An uneven surface amplifies vibrations. Allow a minimum delay of 2 hours between transport/placement and plugging in the appliance, to let the internal fluids stabilize. Maintain a clearance of at least 25 mm between the back of the appliance and the wall, to allow for good air circulation and reduce resonances. Check that the shelves and containers are properly positioned and do not vibrate together. These startup and normal operating noises will quickly disappear once you get used to them. If the noise becomes excessive or abnormal (strong vibrations, continuous hissing), check the balance of the appliance and contact FAGOR support.

Q: Is there a service manual for the FAGOR FFA253 refrigerator?

The FAGOR FFA253 combined refrigerator comes with a complete user manual (56 pages in French) that contains all the necessary information for the operation, use, maintenance, and troubleshooting of the appliance. Regarding the technical service manual: This type of documentation, reserved for authorized technicians, is not intended for public sale for safety reasons (intervention on the refrigeration circuit, electrical components, etc.). If you need a repair or specialized technical information, please contact the FAGOR Technical Assistance Service who can assist with your FFA253 appliance. For assistance: You can contact the FAGOR Consumer Service at the following address: BP 9526, 95069 CERGY PONTOISE CEDEX. The FAGOR teams respond to questions about the use, maintenance, and repairs of your refrigerator. Your appliance is covered by a 2-year warranty . In case of malfunction, do not attempt to repair it yourself: contact the authorized FAGOR technical service who has all the necessary documentation and original parts.

Question 1

Why does the refrigerator make a clicking noise at startup?

Accepted Answer

The clicking or popping noise you hear when you plug in your FAGOR FFJ6825N refrigerator is completely normal. It is the compressor starting up, an essential component for the circulation of the refrigerant R600A.

This noise is particularly noticeable during the first startup, as the compressor activates an electrical relay to begin its operation. The occasional clicking sounds that follow during operation are also normal.

To minimize this noise:

Ensure that the appliance is level and stable on the floor. An uneven surface amplifies vibrations.
Allow a minimum delay of 2 hours between transport/placement and plugging in the appliance, to let the internal fluids stabilize.
Maintain a clearance of at least 25 mm between the back of the appliance and the wall, to allow for good air circulation and reduce resonances.
Check that the shelves and containers are properly positioned and do not vibrate together.

These startup and normal operating noises will quickly disappear once you get used to them. If the noise becomes excessive or abnormal (strong vibrations, continuous hissing), check the balance of the appliance and contact FAGOR support.

Question 2

How to disable the alarm and the red light of the freezer?

Accepted Answer

Your Fagor FFA6815P refrigerator has two types of alarms concerning the freezer: an open door alarm and an insufficient temperature alarm.

Open door alarm: If the freezer (or refrigerator) door remains open for more than 2 minutes, an audible alarm sounds and the refrigerator light turns off. Simply close the door completely to immediately disable this alarm.

Insufficient temperature alarm and red light: When the temperature of the freezer is abnormally high, a light or icon appears along with an intermittent sound signal. To manually disable the sound signal, press the control buttons designated for this purpose on the control panel (refer to sections 4.2.4, 4.2.5, or 4.2.6 of the manual according to your configuration).

The light: This light will automatically turn off once the freezer returns to a normal temperature. Ensure that the door is properly closed, that nothing is blocking the rear ventilation grills, and that food is properly spaced to allow optimal air circulation.

Upon first use: When your appliance is initially connected, the light or icon may appear, but the audible alarm will not sound. This is normal, and the light will turn off once the temperature reaches the configured level.

If the alarm persists despite a normal temperature, check that you have not recently left the door open and that the appliance is functioning correctly. For specific needs, refer to the recommended temperature selection table in your user manual.

Question 3

How to install or reattach the handle of the freezer compartment?

Accepted Answer

To install or reattach the handle of the freezer compartment of your Fagor 3FIS1224 refrigerator, follow this simple procedure:

Reassembly Steps:

Locate the screws - The handle is usually secured by two screws, one at the top and one at the bottom. These screws are often hidden under caps or plastic covers that can be unclipped or lifted with a flat screwdriver to access the screws.
Prepare a suitable screwdriver - You will need a flat or Phillips screwdriver depending on the type of screws. Completely unscrew the two screws at the top and bottom of the handle.
Install the new handle - Position the new handle by properly aligning the mounting holes with those on the freezer door. Insert the screws and tighten them securely, without forcing, alternating between the top and bottom to ensure even tightening.
Check the spring - Some models include a metal spring or a plastic clip. Make sure it is correctly installed or clipped before fully reattaching the handle.
Close the covers - Once the screws are tightened, reclip or re-screw the screw caps for a finished look and to protect the screws.

If the handle is broken or damaged, you can order an original Fagor replacement part by mentioning your model 3FIS1224 to specialized distributors of appliance spare parts. Ensure that the new handle model is compatible with your device.

Important - Make sure the handle is installed correctly before reusing the freezer, as a poorly secured handle could fall off or cause difficulties in opening the freezer door.

Question 4

What are the dimensions and main features of the FAGOR FL372?

Accepted Answer

The FAGOR FL372 is a compact yet efficient refrigerator-freezer:

Height: 185 cm
Width: 60 cm
Depth: 65 cm
Weight: 70 kg

Capacity: 250 liters in total (combining the refrigerator compartment and the integrated freezer at the bottom).

This model has an A++ energy class, offering an excellent balance between cooling performance and electricity consumption. It features interior LED lighting, adjustable glass shelves, and operates at a voltage of 220-240V with grounding.

Question 5

How to restart a FAGOR FFK4845X refrigerator after unplugging it for a whole day?

Accepted Answer

To restart your FAGOR FFK4845X refrigerator after unplugging it for a whole day, follow the steps below:

1. Plug the appliance back in

Make sure the refrigerator is properly plugged into a functioning electrical outlet.

2. Wait for stabilization

After plugging the appliance back in, let it run without opening the door for a few minutes so that the system can stabilize.

3. Adjust the temperature

If your model has a thermostat or temperature setting, adjust it to the recommended temperature: generally between 3 and 5 °C for the refrigerator compartment and around -18 °C for the freezer.

4. Check the operation

Open the door to check that the interior light turns on, indicating that the appliance is powered.
Listen for the compressor to start, a sign that cooling is underway.

5. Wait for cooling

Note that it may take several hours for the refrigerator to reach the ideal temperature after being restarted.

By following these steps, your refrigerator should quickly return to normal operation.

Question 6

How to change the bulb of the FAGOR FD-21 refrigerator?

Accepted Answer

To change the bulb of your FAGOR FD-21 refrigerator, follow these steps:

Unplug the refrigerator from the electrical outlet before any intervention.
Remove the grid located inside the refrigerator.
Locate the bulb, which is behind the thermostat panel.
Unscrew the bulb by turning it counterclockwise.
Install a new bulb of the same wattage as the previous one, by screwing it clockwise until it is securely in place.
Replace the grid in position.
Plug the refrigerator back in and check that the bulb lights up correctly.

Make sure to use a bulb with exactly the same wattage as the defective bulb to avoid any compatibility issues. If the bulb does not light up after replacement and the refrigerator is properly plugged in, contact an authorized technician.

Question 7

Where are the drainage systems located in the FAGOR FFA6715X refrigerator?

Accepted Answer

The drainage systems of the FAGOR FFA6715X refrigerator are essential for removing condensation water and ensuring optimal operation. Here is where they are generally located:

1. Drainage in the refrigerator compartment

A drainage system is located at the back of the refrigerator compartment, near the evaporator. This drain allows for the removal of water from condensation to prevent moisture buildup inside.

2. Drainage in the freezer compartment

In some models, a drainage system is also found in the lower or back part of the freezer. It collects water from automatic defrosting.

Access and maintenance

To access the drains, it may be necessary to remove some shelves or internal panels.
Be sure to unplug the appliance before any intervention for safety reasons.
Regular cleaning of the drains is recommended to avoid blockages and ensure proper water drainage.

This information will help you locate and maintain the drainage systems of your FAGOR FFA6715X refrigerator.

Question 8

What to do when the FAGOR FFA6715X refrigerator's freezer produces too much ice?

Accepted Answer

For your FAGOR FFA6715X refrigerator with static cooling, excessive ice buildup in the freezer generally indicates a disruption in air circulation or poor sealing. Here’s how to identify and effectively resolve this issue.

The first step is to check the freezer temperature. The FFA6715X should be set between -18°C and -20°C for optimal operation. A temperature that is too low (-25°C or lower) causes excessive frost formation. Gradually adjust the freezer thermostat and wait 24 hours to observe the results. Refer to the control panel located inside the appliance to access the temperature settings.

Next, inspect the sealing of the freezer door. Close it on a sheet of paper: it should not slide easily. A worn or improperly positioned seal allows moist air to enter, causing ice formation. Clean the seal with a damp cloth. If the door does not close tightly, the seal needs to be replaced. Also, check that nothing is forcing the door to remain ajar, especially shelves that may protrude.

To clean the drainage channels of the FFA6715X, locate the ventilation grilles at the back and on the inner walls of the freezer. Dust them regularly with a vacuum cleaner. A blocked drain prevents defrost water from flowing properly, leading to ice formation. You can also gently pour warm water mixed with baking soda into the drainage holes to dissolve mineral deposits and accumulated debris.

If a significant layer of ice has already formed, defrost: turn off the appliance, remove the food, and let the ice melt naturally. Place a towel and a tray to catch the water. Never use sharp objects (knives, picks) that could puncture the refrigeration circuit. You can speed up the process by placing a container of hot water in the freezer, renewing it every 15 minutes. This manual defrosting is recommended by the manufacturer for the FFA6715X.

Finally, ensure proper air circulation by not overloading the freezer and leaving space between food items for cold air to circulate freely. Cover moist foods (meat, fish) before storing them to limit humidity. Combining these actions should permanently eliminate the excessive frosting issue on your FAGOR FFA6715X.

Question 9

Is there a service manual for the FAGOR FFA253 refrigerator?

Accepted Answer

The FAGOR FFA253 combined refrigerator comes with a complete user manual (56 pages in French) that contains all the necessary information for the operation, use, maintenance, and troubleshooting of the appliance.

Regarding the technical service manual: This type of documentation, reserved for authorized technicians, is not intended for public sale for safety reasons (intervention on the refrigeration circuit, electrical components, etc.). If you need a repair or specialized technical information, please contact the FAGOR Technical Assistance Service who can assist with your FFA253 appliance.

For assistance: You can contact the FAGOR Consumer Service at the following address: BP 9526, 95069 CERGY PONTOISE CEDEX. The FAGOR teams respond to questions about the use, maintenance, and repairs of your refrigerator.

Your appliance is covered by a 2-year warranty. In case of malfunction, do not attempt to repair it yourself: contact the authorized FAGOR technical service who has all the necessary documentation and original parts.

Question 10

How to change the door seal of the FAGOR FFA253 refrigerator?

Accepted Answer

To change the door seal of your FAGOR refrigerator model FFA253, follow these precise steps:

1. Unplug the appliance

Before any intervention, unplug the refrigerator to avoid any electrical risk.

2. Remove the old seal

Open the refrigerator door.
Inspect the existing seal. It is usually secured by clips or screws.
If the seal is clipped, gently pull it to dislodge it.
If screws are holding it, use a screwdriver to remove them before taking off the seal.

3. Prepare the new seal

Check that the new seal is compatible with model FFA253.
If the seal is bent, let it relax at room temperature before installation.

4. Install the new seal

Align the new seal with the location of the old one.
If the seal is clipped, push it firmly into place.
If screws are needed, secure them tightly to hold the seal.

5. Check the seal

Close the door and test the seal by placing a piece of paper between the seal and the door. If the paper pulls out easily, the seal is not properly installed. Adjust if necessary.

6. Plug the refrigerator back in

Once the seal is correctly installed and the seal is verified, plug your refrigerator back in.

User manual FAGOR Fridge : user manuals and guides in PDF

Models FAGOR Fridge most viewed

Other categories FAGOR

Recent questions about Fridge FAGOR