How to reset the Samsung SNO5080R surveillance camera?

Q: How to reset the Samsung SNO5080R surveillance camera?

Location of the Reset button The Reset button on the Samsung SNO5080R camera is located on the front, near the video output port. It is a small button integrated into the camera's casing. Resetting Steps Press and hold the Reset button for about 5 seconds. During this time, the system indicator (status light) will gradually turn off. Release the button once the light is completely off, and the camera will automatically restart. Wait a few seconds for the system to fully reset before checking its operation. Important: Resetting network settings The reset restores all camera settings to factory default values, including network settings. After a reset, the camera will switch to automatic DHCP mode. Network configuration after reset If your network has a DHCP server, the camera will automatically connect and obtain an IP address. If your network does not have a DHCP server, you will need to manually configure the network settings before you can use the camera. To do this, use the IP Installer software (provided on the installation DVD) to manually set the IP address, subnet mask, gateway, and other necessary network settings.

Question

Accepted Answer

Location of the Reset button

The Reset button on the Samsung SNO5080R camera is located on the front, near the video output port. It is a small button integrated into the camera's casing.

Resetting Steps

Press and hold the Reset button for about 5 seconds.
During this time, the system indicator (status light) will gradually turn off.
Release the button once the light is completely off, and the camera will automatically restart.
Wait a few seconds for the system to fully reset before checking its operation.

Important: Resetting network settings

The reset restores all camera settings to factory default values, including network settings. After a reset, the camera will switch to automatic DHCP mode.

Network configuration after reset

If your network has a DHCP server, the camera will automatically connect and obtain an IP address. If your network does not have a DHCP server, you will need to manually configure the network settings before you can use the camera. To do this, use the IP Installer software (provided on the installation DVD) to manually set the IP address, subnet mask, gateway, and other necessary network settings.

User manual SAMSUNG Surveillance Camera : user manuals and guides in PDF

Models SAMSUNG Surveillance Camera most viewed

Other categories SAMSUNG

Recent questions about Surveillance Camera SAMSUNG