How to assemble and install the CECOTEC Ready Warm 9770 Ceramic Towel?

Question

Accepted Answer

Assembling the CECOTEC Ready Warm 9770 Ceramic Towel requires careful preparation and secure wall mounting. Before you begin, ensure you have all the provided elements: 4 dowels, ST4x40 screws, ST3.5x20 screws, M5x14 screws, and plastic caps. The device must be positioned so that the control panel is at the bottom once installed.

Observe the following safety distances:

60 cm minimum between the device and the bathtub or shower
15 cm minimum from the ceiling and the floor
1 meter of free space in front of the device
50 cm minimum on each side

Step-by-step installation procedure:

Use a template or measure to mark the 4 anchor points (800 mm spacing in height and 450 mm in width)
Drill 4 holes of 8 mm diameter in the wall using a drill
Insert the 4 dowels into the drilled holes
Attach the external brackets to the wall with the ST4x40 screws
Secure the internal brackets to the device with the ST3.5x20 screws (4 screws for the internal brackets and 4 for the front fixings)
Clip the internal radiator brackets to the external wall brackets
Adjust the distance from the wall using the M5x14 screws to achieve the correct spacing
Clip the plastic caps onto the 4 front fixings for a neat finish

Once the installation is complete, check that the radiator is securely mounted and level. Then connect it to a grounded electrical outlet. The device will emit a beep upon activation to confirm proper operation. Observe the safety distances to avoid any risk of burns or thermal overload.

User manual CECOTEC Towel rack : user manuals and guides in PDF

Models CECOTEC Towel rack most viewed

Other categories CECOTEC

Recent questions about Towel rack CECOTEC